4dr Sdn Lt R 3.5l Cd Power Windows Power Door Locks Tilt Wheel Cruise Control on 2040-cars

Auto blog

Chevy keeps teasing next Camaro, 70 percent of parts unique to it [w/video]

2016 Chevy Camaro performance figures released

If you want to make a car faster, there are two sure-fire ways to get the job done – add power and/or reduce weight. Chevy has done both for the 2016 Camaro, putting as much as 455 horsepower into its muscle coupe and shaving a few hundred pounds from every trim. That range-topping power comes courtesy of a 6.2-liter V8 engine, and it's enough grunt to push an automatic-equipped Camaro SS to 60 miles per hour in just 4.0 seconds flat (4.3 seconds with a manual) and down the quarter mile in 12.3 seconds at 116 mph (12.5 at 115 for the stick). Not coincidentally, those acceleration specs, at least on paper, put the V8-powered Camaro SS just above the Mustang GT on the muscle-car pecking order. When the road gets twisty, Chevy claims the Camaro SS can generate as much as .97 g on the skidpad. And, thanks in part to its Goodyear Eagle F1 summer tires, the SS can stop from 60 in as little as 117 feet. We look forward to finding out how nimble the new Camaro feels when compared to its primary competitors. <p>Your browser does not support iframes.</p> Moving down one notch to the 335-hp 3.6-liter V6, properly equipped 2016 Camaro coupes can hit 60 in as few as 5.1 seconds and cover the quarter in 13.5 at 103. Perhaps even more intriguingly, the 2.0-liter turbocharged four-cylinder and its 275 horsepower (the only configuration quicker with a manual transmission, incidentally) can propel the Camaro to 60 in 5.4 seconds and through the 'ol 1320 in 14 seconds flat. That's seriously quick, but buyers comparing the Camaro to the Mustang will find that the EcoBoost 2.3-liter is a bit more powerful (310 hp and 320 lb-ft) and quicker (5.1 seconds to 60). Chevy is making lots of noise about the efforts its engineers went through to shed weight from the 2016 Camaro, going so far as to shave down suspension bolts so that no thread went unthreaded. The weight-saving obsession pays off – base Camaro models are down 390 pounds while the SS model drops 223 pounds over the 2015. The 2016 Camaro SS boasts a power-to-weight ratio of 8.1 lbs per pony, a 14-percent improvement over the last-gen. Even though weight is down, chassis stiffness is said to be up by 28 percent over the fifth-gen Camaro coupe. Also of note: The Camaro is now lighter than the Mustang across the board when comparing like-to-like configuration levels. The 2016 Chevy Camaro starts at $26,695 (including $995 for destination).

GM adds 1,200 jobs at Detroit-Hamtramck plant

General Motors is making a big move at its Hamtramck, MI, factory, announcing it will add a second shift and hire over 1,200 workers within the next several months. It's expected that by early 2016, the factory will employ over 2,800 workers to build the Chevrolet Volt, Impala, Malibu, Cadillac ELR, and by early next year, the new CT6. According to GM Hamtramck spokesperson Courtney Zemke, 40 of the 1,200 positions are for salaried employees, while the remainder will be hourly positions. As for where these employees will go, positions are being made available across the factory, so GM isn't focusing on any particular area for its new hires. It's a similar story behind the hiring surge itself. GM said in its press release that the "second shift is necessary to meet forecasted market demand," a position Zemke reiterated. It's a matter of demand across the plant's portfolio, rather than any one particular product seriously outstripping supply. Naturally, the United Auto Workers is happy with the move. "The workforce at Detroit-Hamtramck is second to none," UAW Local 22 Shop Chairman Don LaForest said in the attached release. "We appreciate the opportunity to expand our UAW-GM family." Hiring is going on now, with the second shift slated to get underway in early 2016. GM's Detroit-Hamtramck Assembly to Add Second Shift and More Than 1,200 Jobs Plant will nearly double its workforce by early 2016 2015-10-22 DETROIT – General Motors is nearly doubling its workforce at Detroit-Hamtramck Assembly by adding a second shift and more than 1,200 hourly and salaried jobs. The addition of a second shift will increase the plant's workforce to approximately 2,800 people when hiring is completed. The second shift is necessary to meet forecasted market demand for the five cars produced at Detroit-Hamtramck. "This is the result of the award-winning vehicles Detroit-Hamtramck produces and the confidence GM has in our team to build world-class quality for our customers," said Plant Manager Gary West. Second shift hiring is underway, and the shift is scheduled to begin operations in early 2016. "The workforce at Detroit-Hamtramck is second to none," said UAW Local 22 Shop Chairman Don LaForest. "We appreciate the opportunity to expand our UAW-GM family." The 4.1 million-square-foot Detroit-Hamtramck Assembly opened in 1985. GM has invested $1 billion in the plant over the last six years, making it one of the company's most-agile manufacturing facilities in North America.