1969 Chevrolet Impala Ss-427 on 2040-cars

Auto blog

NHTSA upgrades probe into 1.7 million GM vehicles over wiper failures

WASHINGTON — The U.S. National Highway Traffic Safety Administration (NHTSA) said Tuesday it is upgrading an investigation into 1.7 million General Motors vehicles for windshield wiper failures. The auto safety agency opened the probe in November 2018 to see if GM needed to expand a 2016 recall of 2013 model year Chevrolet Equinox and GMC Terrain SUVs to cover additional vehicles. The engineering analysis probe covers 2010-2012 and 2014-2016 Equinox and Terrain vehicles. NHTSA could demand a recall after it completes the probe. NHTSA said it has reviewed 1,900 complaints and reports related to the issue in the 1.7 million vehicles. NHTSA said it has seen elevated failure rates in the 1.7 million vehicles, even though GM said the recalled vehicles have "double the warranty rate and five times the complaint rate." GM said it will "fully cooperate to support their investigation. We do not believe these windshield washer systems are defective." The wiper failures that prompted the 2016 recall were attributed to water and debris intrusion into the windshield wiper assembly ball joints, leading to excessive wear and eventual detachment of the ball joint. GM said it was installing an improved windshield wiper motor and transmission assembly and relocating a drain hole at the base of the windshield. Related Video:

Would you pay $17 a month to give your older Ford connectivity?

When it was first introduced in 2007, there was nothing like the original Ford Sync system, since it allowed car owners to connect and use a portable device better than anything that came before it. And because it was a brought-in/tethered and software-based system, Sync leveraged a device's connectivity and was easily updated. It took competitors awhile to catch up: Toyota Entune wasn't available until 2011, and Chevy MyLink didn't roll out until 2012. But now Ford is the one playing catchup since it stuck with the brought-in strategy while most other automakers were quicker to add connectivity via an embedded cellular modem. Ford initially installed 2G/3G modems in its small fleet of electric and plug-in electric vehicles starting in 2012 so that owners could keep tabs on charging. Embedded connectivity came to Lincoln in 2014, and Ford began adding onboard 4G LTE via Sync Connect to select cars starting with the Escape in 2015. To get more cars connected more quickly, last week the automaker rolled out its FordPass SmartLink solution that plugs into the OBD port of 2010 to 2017 model year vehicles. This lets owners retroactively get onboard Wi-Fi, set up a "geo-fence" to keep tabs on a car's location, receive vehicle health reports and allows remote engine starting and door locking/unlocking using a smartphone app, among other features. But to connect older Ford vehicles will cost owners $16.99 a month for two years, not including installation. Ford throws in 1 GB of data or a 30-day trial, whichever comes first, after which owners have to add the vehicle to their Verizon shared data plan, which supplies connectivity for SmartLink, or establish a new account. (Disclosure: Autoblog is owned by Verizon.) By comparison, GM's 4G LTE data plans start at $10 a month for 200 MB and goes up to $30 for 3 GB, and owners can also add a car to an AT&T shared-data plan. But OnStar doesn't have a separate monthly subscription for the embedded modem or an installation charge, and standard features via the RemoteLink Mobile App are free for the first five years of ownership. FCA's Uconnect Access service also uses an embedded modem to provide similar telematics features for $20 per month following a free one-year trial, while a la carte in-car Wi-Fi is offered for $10 per day, $20 per week or $35 per month.

2014 Chevrolet Silverado tows in new configurator, microsite

Judging by your continued enthusiastic response to configurator notices, dear reader, you enjoy speccing out new cars as much as we do. Better still, there tends to be even more ways to personalize, configure and bloat theoretical MSRPs on full-size trucks as there are with more ordinary passenger cars. In addition to trim level, engine and transmission choices, truck buyers usually have to specify items like cab configuration, bed length, number of driven axles, tow packages, gear ratios and all sorts of bits and bobs.
That's why we're pleased to see the DIY specification utility for the 2014 Chevrolet Silverado come alive so soon after this week's Detroit Auto Show debut. While the configurator lacks pricing (General Motors hasn't announced numbers yet) and full options, you can still spec out your half-ton rig, and even print it out or email it to your friends. Beyond the configurator, the new model-specific site is pretty cool, too, with various videos and closer looks at the truck's new features.
The new Chevrolet pickup range won't be on dealer lots until sometime this summer, so whether you're a building contractor, an avid sportsman or just a guy or gal that loves full-size trucks, you might want to check out the link below to keep your appetite whetted. If you're more of a Sierra fan, well, it looks like you're going to have to wait a while - GMC hasn't updated its site yet.