1962 Chevrolet Impala on 2040-cars

Auto blog

GM CEO to meet with U.S. lawmakers over job cuts

WASHINGTON — General Motors Co Chief Executive Mary Barra plans to visit Capitol Hill next week to discuss the company's plans to halt production at five plants in North America next year and cut up to 15,000 jobs, two congressional aides said on Friday. GM has come under harsh criticism from lawmakers from both major political parties, and from President Donald Trump, since Monday when it announced the biggest restructuring for the U.S. No. 1 carmaker since its bankruptcy a decade ago. Barra is expected to meet with lawmakers from Michigan and Ohio, where GM plans to shutter three plants, as well as senior leaders in Congress. GM did not immediately comment. Barra has been calling lawmakers this week to explain the decision to end production. Trump has threatened to revoke subsidies for GM. The Detroit automaker plans to halt production next year at three assembly plants: the Lordstown small-car factory near Youngstown, Ohio; the Detroit-Hamtramck complex in Detroit; and the Oshawa, Ontario, assembly complex near Toronto. It will also stop building several models now assembled at those plants, including the Chevrolet Cruze, the Chevrolet Volt hybrid, the Cadillac CT6 and the Buick LaCrosse. Additionally, GM plans to shutter the Warren transmission plant outside Detroit and a plant that makes electric motors and drivetrains outside Baltimore, Maryland. The Cruze compact car will be discontinued in the U.S. market in 2019, although GM may continue building it in Mexico for other markets, Barra said. Reporting by David Shepardson. Related Video:

2016 Chevy Camaro performance figures released

If you want to make a car faster, there are two sure-fire ways to get the job done – add power and/or reduce weight. Chevy has done both for the 2016 Camaro, putting as much as 455 horsepower into its muscle coupe and shaving a few hundred pounds from every trim. That range-topping power comes courtesy of a 6.2-liter V8 engine, and it's enough grunt to push an automatic-equipped Camaro SS to 60 miles per hour in just 4.0 seconds flat (4.3 seconds with a manual) and down the quarter mile in 12.3 seconds at 116 mph (12.5 at 115 for the stick). Not coincidentally, those acceleration specs, at least on paper, put the V8-powered Camaro SS just above the Mustang GT on the muscle-car pecking order. When the road gets twisty, Chevy claims the Camaro SS can generate as much as .97 g on the skidpad. And, thanks in part to its Goodyear Eagle F1 summer tires, the SS can stop from 60 in as little as 117 feet. We look forward to finding out how nimble the new Camaro feels when compared to its primary competitors. <p>Your browser does not support iframes.</p> Moving down one notch to the 335-hp 3.6-liter V6, properly equipped 2016 Camaro coupes can hit 60 in as few as 5.1 seconds and cover the quarter in 13.5 at 103. Perhaps even more intriguingly, the 2.0-liter turbocharged four-cylinder and its 275 horsepower (the only configuration quicker with a manual transmission, incidentally) can propel the Camaro to 60 in 5.4 seconds and through the 'ol 1320 in 14 seconds flat. That's seriously quick, but buyers comparing the Camaro to the Mustang will find that the EcoBoost 2.3-liter is a bit more powerful (310 hp and 320 lb-ft) and quicker (5.1 seconds to 60). Chevy is making lots of noise about the efforts its engineers went through to shed weight from the 2016 Camaro, going so far as to shave down suspension bolts so that no thread went unthreaded. The weight-saving obsession pays off – base Camaro models are down 390 pounds while the SS model drops 223 pounds over the 2015. The 2016 Camaro SS boasts a power-to-weight ratio of 8.1 lbs per pony, a 14-percent improvement over the last-gen. Even though weight is down, chassis stiffness is said to be up by 28 percent over the fifth-gen Camaro coupe. Also of note: The Camaro is now lighter than the Mustang across the board when comparing like-to-like configuration levels. The 2016 Chevy Camaro starts at $26,695 (including $995 for destination).

GM recalls select Tahoes, Yukons, Escalades for rear driveshaft issue

GM is recalling a number of its full-size SUVs due to an issue with the rear driveshaft assembly that could ultimately result in driveshaft failure. The actual number of total vehicles involved in the recall is small at just 1,789, but it’s spread out across the entire 2021 model year full-size GM vehicle lineup. That means a small number of every model is being recalled, including the Chevrolet Tahoe, Suburban, GMC Yukon, Yukon XL and the Cadillac Escalade and Escalade ESV. GM traced the issue back to certain driveshaft assemblies with ball bearings that were not properly heat treated. If theyÂ’re not properly heat treated, GM says that the balls may deform over time, causing noise and vibration. Continue to drive in this condition, and GM says the affected joint in the driveshaft assembly could seize, causing loss of drive power. However, the problem wonÂ’t present itself all at once, as GM says there will be a gradual increase of noises and vibrations before total failure. For those few owners with affected vehicles, GM says that it will replace the left and right rear driveshaft assemblies with properly-built units. Per usual with recalls, this will be done at your local dealership at no cost to the owner. If you have one of the recalled SUVs, expect to be notified mid-March. Related video: