1962 Chevrolet Impala 4 Door Sedan on 2040-cars

Auto blog

Autoblog In Cuba: 1957 Chevy Bel Air Review

If you've been following the Autoblog In Cuba series, you may remember that my efforts to rent a car in the country were ultimately unsuccessful. Misinformation, bad planning, and a lack of rental car inventory conspired to disrupt my hoped-for driving adventure. I discovered in my week of exploration, however, that the terrific thing about Havana is that there's always another adventure to be found – if you're willing to look. A car I could drive myself might have been impossible to come by, but a ride to remember was not. After all, even when reviewing a new car, I've found that impressions about the car and the route can be credibly formed from the right seat. Starting from the parking lot of the grand Hotel Nacional, finding an interesting car for hire is as simple as walking up and down the block. Scads of classic American iron wait just outside the hotel gates, in a riot of colors and conditions befitting the tropical climate. Fords from the 1940s are plentiful – more sedans than coupes – and the glory days of General Motors are represented by enough Pontiacs and Cadillacs to fill a Bruce Springsteen B-sides album. But the Chevy Bel Air is the king of the road here, by some margin. View 30 Photos I settled on a burnt orange 1957 Chevy Bel Air convertible, in tourist-appropriate condition. I was looking for a hardtop at the request of my crew's audio/video needs, but settled on a burnt orange 1957 Chevy Bel Air convertible, in tourist-appropriate condition. This car might look good as a prop in the background on your vacation photos – hair blowing in the breeze with the ocean at your back, parked in front of Che's face in Revolution Square, etc. – but was far from pristine on a closer inspection. A perfect representative of the Cuban average. At least the price was right: $50 for two hours to make it 12 miles to Hemingway's house, and back. My driver was a kid named Daniel who looked to be about 20 years old. The Chevy doesn't belong to him, he co-drives it with the owner, but he was able to give me the basic mechanical rundown. The eight- or six-cylinder engine that Chevy shipped this convertible with was long gone. No surprise there, as nearly every American-made car I'd ridden in so far was powered by some belching Mercedes diesel. Despite it's clattering note, Daniel said the lump under the hood of the '57 drinks gas: a four-cylinder of Russian origins, pulled out of a GAZ Volga as best I can understand.

Next-gen Chevy Silverado and GMC Sierra may use carbon fiber

It's been generally accepted that the next generation of full-size GM trucks will use some sort of strong, lightweight material for the beds while retaining steel for the cab. While aluminum seems like the most obvious choice, according to Automotive News, the Chevy Silverado and GMC Sierra will incorporate both aluminum and carbon fiber in their beds. The publication cites sources from within GM, though it seems the introduction of this comparatively exotic material mix is still a few years off. While carbon fiber is both stronger and lighter than steel and aluminum, it takes significantly more time and money to produce, essentially relegating the material to small-volume cars. The main benefit for trucks is the resulting reduction in weight to improve fuel economy without sacrificing the tough, rugged capabilities truck buyers expect. The Ford F-150 made the switch to aluminum for the 2015 model year and it's proved highly successful. It seemed like it was only a matter of time before the competition followed suit. Automotive News says that the next-gen trucks will launch with aluminum beds and that it will take a couple of years before we'll see any carbon fiber incorporated into the design. Even then, only look for the composite material on higher-trim models, with a trickle down to lower-spec trucks possible further in the future. In 2011, GM announced it was working with Japan-based Teijin Limited on a carbon fiber reinforced thermoplastic. There's a good chance that material's introduction will be on trucks. Related Video: News Source: Automotive News Plants/Manufacturing Rumormill Chevrolet GM GMC Truck

GM takes 2020 full-size pickup sales crown

It's no secret that 2020 was an unconventional year for auto sales. Extenuating circumstances or not, it was a year of upheaval even for ever-resilient (and ever-profitable) pickups, with General Motors taking the crown from Ford in the full-size segment.  The Ford F-Series still outsold every other full-size pickup nameplate in the country by a significant margin. It's only when you combine GM's Chevrolet Silverado and GMC Sierra variants that you get a number that exceeds Ford's. This isn't really a new phenomenon, either. In fact, it was only somewhat recently that Ford took the overall full-size crown away from GM, and not only did Ford widen the gap in recent years, but Ram has once again become a legitimate challenger, even managing to outsell the Silverado by a healthy margin in 2019, but never coming close to the F-Series in terms of total volume.  But, 2020 being 2020, things got weird yet again. Ram remains relevant, of course, but Ford got caught with its pants down thanks to the one-two punch of COVID and the generational changeover of the core F-150 model, which resulted in a production interruption as the company's assembly facilities transitioned from building the old 2020 model to the new-for-2021. This perfect storm, as it turns out, was sufficient for GM to walk away with the full-size crown. See for yourself: Full-size 2020 pickup sales: GM total: 847,110 F-Series: 787,422 Silverado: 594,094 Ram: 563,676 Sierra: 253,016 Tundra: 109,203 Titan: 26,439 As you can see, Ram slipped back behind Silverado, slotting comfortably into third place. The Silverado 1500 had a flat year, but the heavy- and medium-duty variants bucked the trend and contributed to a slight uptick in sales for the nameplate, while F-Series tumbled more than 12% (nearly 110,000 units), opening the door for GM to steam ahead.  There were similarly significant shakeups in the midsize truck segment. First, 2020 was the first full year of retail sales for the Gladiator pickup, which surged to fourth place behind the stalwart Tacoma, Ranger and Colorado. GM's combined sales of the Colorado and Canyon are good enough for second place by manufacturer, but nowhere close to what it would take to dethrone Toyota.