2014 Chevrolet Equinox 1lt on 2040-cars

Auto blog

2016 Chevrolet Camaro First Drive [w/video]

The Autoblog gang was downright stoked to learn the 2016 Chevy Camaro was next on our test-car docket. Then we found out it was the V6 model. Buzzkill. We were hoping for the snorting V8, or at least the spunky new turbo four-cylinder. The V6? Meh. We've been driving V6 Camaros for, like, six years. It's what you buy if you can't afford anything better, or so say horsepower snobs as they wrinkle their noses and cut their coffee with 93 octane. But after a week with the six-pot Camaro, we'll admit it: we were wrong. The all-new 3.6-liter V6 is strong, sounds good, and is damn fun to drive. Its 335 horsepower and 284 pound-feet of torque appear modest by modern standards, but they power the Camaro to 60 miles per hour in 5.1 seconds with the automatic, or in the case of our manual-equipped test car, 5.2 seconds. That's almost half a second quicker than the new turbo four-cylinder model. Yes, it has the same displacement as the old V6. No, it's not the same engine. Upon closer inspection, the V6's potency shouldn't come as a surprise. This engine is from General Motors' newest family of dual-overhead cam powerplants that launched in the Cadillac CTS and ATS. Yes, it has the same displacement as the old V6. No, it's not the same engine. Don't be fooled, and don't underestimate it at stoplights. The strapping V6 is unsuspectingly good, but it's just one of many improvements for the sixth-generation Camaro. Chevy's coupe is lighter, faster, and more modern looking inside and out. It starts with a rear-wheel-drive chassis donated from the Cadillac ATS, though about 70 percent of the components are unique to the Camaro. The 2016 model is about two inches shorter in length (thanks to a shorter wheelbase) and about an inch has been removed from height and width compared to the 2015 model. These lighter underpinnings jumpstarted the Camaro's weight-loss plan, and thanks to extensive use of aluminum, the V6 with the new eight-speed automatic transmission weighs 3,435 pounds – 294 less than its predecessor (the manual-transmission V6 Camaro weighs 3,448 pounds). The V8, meanwhile, sheds 223 pounds. One by one, these elements would merely enhance how the Camaro drives, but taken collectively, they invigorate the new model. It feels much more confident and agile in all circumstances. Put simply, it's a sportier car. View 32 Photos Grab second, let the revs build, and the dual-mode exhaust changes its tune from a low buzz to a rumble, then a growl.

GM: Without LG Chem, we couldn't build Bolt EV [UPDATE]

It's absolutely no surprise that General Motors has a thing for LG Corp. The Detroit automaker and the Korean parts supplier have been working in public on electric vehicles ever since it was announced that LG Chem would supply the battery cells for the Chevy Volt in 2009. LG Chem was even named GM's 2010 Supplier of the Year. But, yesterday, the connection between the two companies was strengthened with the announcement that LG Electronics would be supplying a number of components for the upcoming Chevy Bolt electric vehicle. The Bolt is expected to be able to go about 200 miles and will carry a price tag of about $30,000 (after incentives) when it arrives in 2017 or so. LG's new components can be found almost everywhere in the Bolt. They include the battery pack and the battery heater, a new motor, the power inverter module, the electric climate control system compressor, the on-board charger, high-power distribution module, the accessory power module, and power line communication module. Oh, and then there are LG Electronics' advanced display technologies like the new instrument cluster and a new infotainment cluster. LG Electronics also supplies parts for the 4G LTE OnStar system, just like it does in other new Chevys. If that all sounds like a lot of components to you, you're right. Mark Reuss, GM executive vice president of global product development, purchasing and supply chain, said that without the expanded relationship with LG, GM would not be able to bring the Bolt to market (insert old ironic quote link here). "I think GM was lacking that [electrification knowledge] in a very complete way for many years, I'll just be frank about that," Reuss said. "I also think that on an electrified basis, this requires a long-term commitment and trust that sometimes is violated on a more short-term, regular, traditional basis. I think we have found something completely different with LG and I think that has become a widely talked about and duplicated want from our purchasing and corporate standpoint with our supply base." The "this" that Reuss is talking about here is the OEM-supplier relationship, something has evolved with the LG-GM situation. Previously, the automaker-supplier relationship used to be more like a dictator telling underlings what he needed, Reuss said, and that was a bad idea. "Today's competitive landscape requires a different approach, especially in electrified vehicles," he said.

GM extends production cuts, affects Cadillacs, Camaro and Acadia

General Motors is extending production cuts at some of its North America factories due to a chip shortage that has roiled the global automotive industry, the U.S. carmaker said on Thursday. The move's impact has been baked into GM's prior forecast that the shortage could shave up to $2 billion off this year's profit. GM's Lansing Grand River assembly in Michigan will extend its downtime through the week of April 26. The plant makes Chevrolet Camaros and Cadillac CT4 and CT5 sedans. It has been out of action since March 15. GM's Spring Hill assembly in Tennessee will shut down for two weeks starting the week of April 12. The plant makes the Cadillac XT5, XT6 and GMC Acadia. The company said it has not taken downtime or reduced shifts at any of its more profitable full-size truck or full-size SUV plants due to the shortage. The news was first reported by CNBC. Reporting by Ankit Ajmera in Bengaluru; Editing by Maju Samuel and Sriraj Kalluvila