4dr Sdn Ls Chevrolet Cruze Ls Low Miles Sedan Manual Gasoline Engine, Ecotec 1.8 on 2040-cars

Auto blog

Feds open investigation into Chevy Express, Ford Freestar rust issues

'Tis the season... for road salt. And with that, comes rust. And what does rust bring? Well, for Ford and General Motors, a National Highway Traffic Safety Administration investigation. According to The Detroit News, NHTSA is looking into potential recalls issues with Chevrolet Express vans and Ford Freestar minivans.
The feds have received five complaints that rust has caused leaking fuel filler pipes on 2003 Express vans. Separately, seven complaints have been filed over excessive rust in the rear wheel wells of 2004 Ford Freestar and Mercury Monterey minivans. The Freestar and Monterey went out of production in 2007. Neither issue has resulted in any crashes or injuries, according to the report.

GM opens official investigation into C8 Corvette transmission leaks

In March 2020, a month after Chevrolet began customer deliveries of the 2020 C8 Corvette, a GM dealer technician created a Reddit thread about a leaking gearbox in a Corvette with 32 miles. That car hadn't even been sold yet. Since then, as a search of "C8 Corvette transmission leak" shows, it's been tales of woe for some owners. Something in the Tremec TR-9080 transaxle in the back of the mid-engined Corvette doesn't work as it should, the fault able to cause codes that the transmission needs service, or that the driver needs to shift to park. In some cases, the battery would die because of follow-on issues after the initial transmission code, that code preventing the car from powering down. As Autoevolution reports, GM filed paperwork with the National Highway Traffic Safety Administration in August to look into what's going on. Between forum threads and GM's investigation document, there are several issues mentioned. The most common appears to be the dual-clutch transmission leaking fluid due to gasket failures like the one suffered by one owner at 858 miles, and another for an owner currently enduring a second leaking transmission. The Midengined Corvette Forum reported that Chevy engineers redesigned the TR-9080 pan, fitting Corvettes with the new unit at some point in the 2021 model year. The original pan was stamped steel unit affixed to the engine with two studs and 13 bolts, plus "reinforcement plates." The updated pan is said to be a cast aluminum unit affixed with two studs and 17 bolts, omits the reinforcement plates, and gets a new machined new groove around its edge to seat the gasket seal. The GM paperwork now at the NHTSA mentions a P1789 code, and says one reason for it could be "debris on the park position sensor magnet causing an incorrect position reading to the TCM." This might be caused by another issue mentioned in forums, which is clogged transmission filters. GM gives instructions for returning transmission filters to the company, and a poster on one forum said the Corvette tech at the dealer where he bought his Corvette told him the automaker "requires every used transmission filter to be returned to GM."  Whatever's going on, the problems haven't stopped, and they go beyond the P1789 code. Over the weekend, a 2022 Corvette owner posted on Corvette Forums that he got a check engine light on his car after just 850 miles.

First 2015 Chevy Corvette Z06 engine blows up at just 891 miles

You've waited and watched and waited some more for the arrival of your 650-horsepower, $78,000 Chevrolet Corvette Z06. Finally, that joyous day arrives and you eagerly, but gingerly, begin to break-in the 6.2-liter supercharged V8 monster under your hood. Then 900-odd miles after delivery, your excitement grinds, quite literally, to a halt. That's what the owner of one 2015 Z06 claimed happened to him when a simple break-in drive resulted in a lunched engine. The owner, known as Lawdogg149 on Corvette Forum, says he was out breaking-in his car ahead of a January track event when it happened. "While making a pull from 35 miles per hour, I accelerated and shifted short of redline, and boom - the car began knocking. I pulled over and popped the hood. I could hear a loud knock coming from the No. 6 cylinder area along with a serious, grinding, metal-on-metal sound coming from the supercharger area," Lawdogg wrote. A subsequent trip to the dealer confirmed his concerns, with the service facility telling Lawdogg that the No. 6 valvetrain had failed. The dealer couldn't research the issue further, though, as General Motors requested the engine be returned for a more thorough evaluation. The good news for the Z06's unlucky owner, at least, is that GM will be covering the engine replacement under warranty, an expense that Corvette Forum estimates is a nearly $24,000 procedure. At this point, the two leading theories behind the engine's detonation involve a manufacturing defect – which could be why GM is so keen to tear the blown powerplant down – or a mistake on the part of Lawdogg. As Motor Authority points out, such an error could be something as simple as the Z06's owner accidentally shifting to first rather than third during his 35-mph pull. If, however, there's a deeper manufacturing problem with the Z06's engine, this might not be the only case we end up hearing about.