Corvette Convertable 1992 Six Speed Doug Rippie Motorsports Built on 2040-cars

Auto blog

Next-gen Chevy Silverado and GMC Sierra may use carbon fiber

It's been generally accepted that the next generation of full-size GM trucks will use some sort of strong, lightweight material for the beds while retaining steel for the cab. While aluminum seems like the most obvious choice, according to Automotive News, the Chevy Silverado and GMC Sierra will incorporate both aluminum and carbon fiber in their beds. The publication cites sources from within GM, though it seems the introduction of this comparatively exotic material mix is still a few years off. While carbon fiber is both stronger and lighter than steel and aluminum, it takes significantly more time and money to produce, essentially relegating the material to small-volume cars. The main benefit for trucks is the resulting reduction in weight to improve fuel economy without sacrificing the tough, rugged capabilities truck buyers expect. The Ford F-150 made the switch to aluminum for the 2015 model year and it's proved highly successful. It seemed like it was only a matter of time before the competition followed suit. Automotive News says that the next-gen trucks will launch with aluminum beds and that it will take a couple of years before we'll see any carbon fiber incorporated into the design. Even then, only look for the composite material on higher-trim models, with a trickle down to lower-spec trucks possible further in the future. In 2011, GM announced it was working with Japan-based Teijin Limited on a carbon fiber reinforced thermoplastic. There's a good chance that material's introduction will be on trucks. Related Video: News Source: Automotive News Plants/Manufacturing Rumormill Chevrolet GM GMC Truck

Camaro spy shots show subtly different grille, front fascia

It looks like there some changes in store for the Chevrolet Camaro - the only thing is that we just don't know what Chevy has up its sleeve. Looking at these spy shots, we'd initially be inclined to think that there is just a minor facelift or a new special edition, but upon closer inspection, there are a few oddities about this car that definitely have us intrigued.
The most obvious difference on this prototype is the slightly restyled front fascia with a smaller lower air inlet and the two-bar grille. Then we get to some of the car's mysterious details. For starters, this fascia has the SS vent above the grille, but it looks to be blocked off. Granted this could just be a one-off piece used for testing. What really piqued our interest was at the rear of the car where it has quad exhaust outlets that are used on the ZL1. Could this be the LS7-powered Camaro that we reported on back in December?
At this point, your guess is as good as ours as to what we're looking at here, so let us know in the comments what you think this could be.

GM wants to have 10 plug-in models in China in five years

Last we checked, General Motors was selling all of three plug-in vehicle models in its home country of the US, and is prepared to make the Chevrolet Bolt EV available on these shores later this year. So it's notable that the automaker is hatching plans to have at least 10 plug-in variants for sale in China within the next five years, according to Hybrid Cars. Which plug-ins are coming remains a mystery. GM started selling a hybrid version of the Buick LaCrosse in China this month. The strategy makes sense, as China is now the world's largest car market, and accounts for about a third of GM's annual revenue. The automaker, which operates in China under the SAIC-GM and SAIC-GM-Wuling joint ventures, sells cars there under the Chevrolet, Buick, Cadillac, and Boujun badges, and has been doing so for the better part of two decades. Most recently, GM started selling a hybrid version of the Buick LaCrosse in China this month. What we do know is that GM is building its Cadillac CT6 Plug-in Hybrid in China, with distribution to be split between China and the US. That model, which is scheduled to start sales by the end of the year, is being built overseas because of a combination of Chinese government support for new-energy vehicle technology through incentives and the fact that battery-pack maker LG Chem makes most of its cells in nearby South Korea. The plug-ins are part of a broader plan by General Motors to either introduce or substantially tweak about 60 models by the end of the decade. With such new models, GM looks to boost unit sales by as much as five percent a year for the next few years. As for the other nine plug-in models slated for China by 2021, the company is mum. GM spokesman Dan Flores declined to comment to AutoblogGreen. Related Video: Featured Gallery 2016 Cadillac CT6: First Drive View 32 Photos News Source: Hybrid Cars Green Cadillac Chevrolet GM Electric Hybrid PHEV