Chevrolet Corvette Hardtop Only on 2040-cars

Auto blog

The future's electric — but the present is peak gasoline. Burn some rubber! Do donuts!

I vividly remember the year 1993 as a teenager looking forward to getting my driver’s license, longingly staring into Pontiac dealerships at every opportunity for a chance to see the brand-new fourth-generation Firebird and Trans Am. Back then, 275 horsepower, courtesy of GMÂ’s LT1 5.7-liter V8 engine, was breathtaking. A few years later, when Ram Air induction systems freed up enough fresh air to boost power over 300 ponies, I figured we were right back where my fatherÂ’s generation left off when the seminal muscle car era ended around the year 1974. It couldn't get any better than that. I was wrong. Horsepower continued climbing, prices remained within reach of the average new-car buyer looking for cheap performance, and a whole new level of muscular magnitude continued widening eyes of automotive enthusiasts all across the United States. It was all ushered in by cheap gasoline prices. And as much as petrolheads bemoan the coming wave of electric vehicles, perhaps instead now would be a good time for critics to sit back and enjoy the current and likely final wave of internal combustion. Today, itÂ’s easier than ever to park an overpowered rear-wheel-drive super coupe or sedan in your driveway. Your nearest Chevy dealership will happily sell you a Camaro with as much as 650 horsepower. Not enough? Take a gander at the Ford showroom and youÂ’ll find a herd of Mustangs up to 760 ponies. Or if nothing but the most powerful will do, waltz on over to the truly combustion-obsessed sales team of a Dodge dealer and relish in the glory of a 797-hp Charger or 807-hp Challenger. Want some more luxury to go with your overgrown stable of horses? Try Cadillac, where you'll find a 668-horsepower CT5-V Blackwing. You could instead choose to wrap that huffin' and chuggin' V8 in an SUV. Or go really off the rails and buy a Ram TRX or Jeep Wrangler Rubicon 392 and hit the dunes after a quick stop at the drag strip. Go pump some gas. Burn a little rubber. Do donuts! There is nothing but your pocketbook keeping you from buying the V8-powered car of your dreams. Yes, just about every major automaker in the world has halted development of future internal combustion engines in favor of gaining expertise in batteries and electric motors. No, that doesnÂ’t mean that gasoline is going extinct. There are going to be gas stations dotting American cities and highways for the rest of our lifetimes.

Next-gen Chevy Silverado and GMC Sierra may use carbon fiber

It's been generally accepted that the next generation of full-size GM trucks will use some sort of strong, lightweight material for the beds while retaining steel for the cab. While aluminum seems like the most obvious choice, according to Automotive News, the Chevy Silverado and GMC Sierra will incorporate both aluminum and carbon fiber in their beds. The publication cites sources from within GM, though it seems the introduction of this comparatively exotic material mix is still a few years off. While carbon fiber is both stronger and lighter than steel and aluminum, it takes significantly more time and money to produce, essentially relegating the material to small-volume cars. The main benefit for trucks is the resulting reduction in weight to improve fuel economy without sacrificing the tough, rugged capabilities truck buyers expect. The Ford F-150 made the switch to aluminum for the 2015 model year and it's proved highly successful. It seemed like it was only a matter of time before the competition followed suit. Automotive News says that the next-gen trucks will launch with aluminum beds and that it will take a couple of years before we'll see any carbon fiber incorporated into the design. Even then, only look for the composite material on higher-trim models, with a trickle down to lower-spec trucks possible further in the future. In 2011, GM announced it was working with Japan-based Teijin Limited on a carbon fiber reinforced thermoplastic. There's a good chance that material's introduction will be on trucks. Related Video: News Source: Automotive News Plants/Manufacturing Rumormill Chevrolet GM GMC Truck

GM profit dips on truck changeover, but beats estimates

DETROIT — General Motors on Thursday reported a higher-than-expected quarterly profit despite a drop in production of high-margin pickup trucks, as it gears up for new models that are expected to boost profits next year. Like rivals Ford and Fiat Chrysler Automobiles, GM is banking on highly-profitable Chevy Silverado and GMC Sierra pickup trucks to lift profits, as consumers shift away from traditional passenger cars in favor of these larger, more comfortable trucks, SUVs and crossovers. During the first quarter, the process of changing over to GM's new pickups resulted in a drop in production of 47,000 units. GM Chief Financial Officer Chuck Stevens said the production drop had resulted in a drop in pre-tax profit of up to $800 million. Earlier this year, GM said its 2018 profits would be flat compared with 2017, but expected its all-new pickup trucks would boost margins starting in 2019. On Thursday, GM reiterated its full-year 2018 forecast for adjusted earnings in a range from $6.30 to $6.60 per share. The automaker said capital expenditures were more than $500 million higher in the quarter because of investments its new pickup trucks and a family of low-cost vehicles under development with Chinese partner SAIC Motor Corp. On Wednesday, rival Ford said it would stop investing in most traditional passenger sedans in North America. CFO Stevens told reporters on Thursday that GM has "already indicated that we will make significantly lower investments on a go-forward basis" in sedans. 2019 GMC Sierra View 21 Photos GM benefited from a lower effective tax rate in the quarter, but adjusted pre-tax margin fell to 7.2 percent from 9.5 percent a year earlier. Stevens said the company's profit margin should hit 10 percent or higher in the second quarter and for the full year. GM said material costs were $700 million higher in the first quarter, and it expects those costs to continue rising. The automaker said it would counter those increases with cost cutting measures. "It is a more difficult environment than it was three or four months ago," Stevens said when asked about rising commodity prices from potential steel and aluminum tariffs announced by the Trump administration. "But we are confident we can continue to offset that." The company reported quarterly net income of $1.05 billion or $1.43 per share, a drop of nearly 60 percent from $2.61 billion or $1.75 per share a year earlier. Analysts had on average expected earnings per share of $1.24.