1967 Chevy Chevelle 502 Bbc on 2040-cars

Auto blog

Want a V8 on the cheap? Buy a work truck

In case you didn't notice, V8 cars have gotten pretty expensive. If you want a modern muscle car like the Dodge Challenger R/T, Ford Mustang GT, or Chevy Camaro SS, you'll need between $34,000 and $38,000 for a stripped out example of one. The cheapest of those is the Challenger, and the priciest is the Camaro. These are also the cheapest V8 cars the companies offer. But if you absolutely have to have a V8 for less, there is an option, work trucks. As it turns out, all of the Big Three offer their most basic work trucks with V8s. And because they're so basic, they're pretty affordable, especially when sticking with the standard two-wheel drive. A Ram 1500 Tradesman with a V8 can be had for as little as $29,840, which is a little more than $4,000 less than a Challenger R/T. For a bit more at $30,275, you can have a Chevy Silverado W/T, almost $8,000 less than a Camaro SS. The most expensive is the V8 Ford F-150 starts at a starting price of $30,670, which is a bit over $5,000 less than the Mustang. Of course you'll be in an ultra bare bones vehicle with few comforts, and the price will go up if you add stuff, but we're bargain hunting here, and sacrifices are sometimes necessary. Besides, what you lose in comfort, you gain in loads of cargo space and towing (try to look at the bright side). Also, as a side note, all three trucks are available with optional electronic locking rear differentials. At the discounted price of these trucks, you still get a heaping helping of power. The most potent of the trio is the Ram 1500 Tradesman with 395 horsepower and 410 pound-feet of torque generated by a 5.7-liter V8. Compared with the Challenger R/T, the Ram is up by 20 horsepower and they're tied for torque. The value proposition is even more stark between the two vehicles when looking at the price per horsepower. Each pony in the Ram costs $75.54, while the Challenger charges you $90.91. The Challenger is also more expensive per horsepower than its close competitors. The F-150's 5.0-liter V8 is just barely behind the Ram with 395 horsepower and 400 pound-feet of torque. That's still more power than the Challenger, and it matches the torque of the 2017 Mustang GT. On the down side, it still would be down 20 horsepower on that same 2017 Mustang, and it's behind by 60 horsepower and 20 pound-feet on the new 2018 Mustang GT. The F-150 also just edges out the Mustang in the dollar per horsepower measure.

Final C6 Corvette built in Bowling Green

With all of the attention given to the 2014 Chevrolet Corvette Stingray lately, you could be forgiven for thinking that it's already well along in production, yet tooling up for the new C7 has only just begun. In fact, production of the outgoing C6 generation in Bowling Green, Kentucky just halted on Thursday.
As the C6 has aged, production numbers have predictably ebbed along with demand, but this year, the addition of the 427 and 60th anniversary models resulted in an uptick in vehicles built - this, despite a model year shortened by around 25 percent to accomodate the new model changeover. The final C6 Corvette ever, No. 13,466 built this year, was a white 427 Convertible destined for the General Motors Heritage Center museum. The car's 7.0-liter V8 heart was assembled by Corvette chief engineer Tadge Juechter himself.
In total, Bowling Green pushed out 215,100 C6 Corvettes over nine years. If you're still a C6 fan at heart and are hoping to get a good deal on a phase-out model, step lively - Chevrolet reportedly had about 6,100 unsold units, which Autoweek suggests is good for around five and a half months of supply at the model's current sales rates. Given that demand will likely slacken even further as the C7 draws closer, that should be a big enough stockpile to keep dealers satisfied until 2014 Stingrays begin showing up on their forecourts in December.

The Opel GT is the concept General Motors should build for the US

Now is the time. General Motors should double-down on performance cars and build the Opel GT concept that's set to debut next week at the Geneva Motor Show. Better yet, sell it in the United States as the Chevy GT. Consumers are showing a thirst for performance cars not seen in decades. Ford has them coming in waves, with everything from the F-150 Raptor to a hotted-up Fusion. FCA US is unrepentantly building loads of Hellcats. GM should respond. The General's cupboard is hardly bare. With the Corvette, Camaro, and Cadillac's V-Series, GM has more than enough to compete with its crosstown rivals and anything Europe or Japan can throw at it. But there's also an opportunity. There's not many front-mid-engine, rear-wheel-drive, two-seat sports cars out there like the Opel GT concept. A Chevy GT that used that layout and captured some of the concept car's proportions and curves would ignite a different kind of passion in enthusiasts. It would be Miata-like. With Chevy branding, this sports car would be the everyday exotic. The concept has a turbocharged 1.0-liter three-cylinder engine, which makes about 143 horsepower to motivate a structure that weighs less than 2,200 pounds. It can hit 60 miles per hour in less than eight seconds. All of those numbers are within the front-engined Miata's territory. This new Opel is inspired by two great mid-1960s concepts that helped put its design studio, and that of its sister brand, the British Vauxhall, on the map. (The GT concept is also technically a Vauxhall, as the brands are linked in GM's European strategy.) One of them, the '66 Vauxhall XVR remained a concept. The '65 Opel Experimental GT was on the road by 1968. That shows this is doable. There's precedent. The Saturn Sky and Pontiac Solstice shared a chassis with a modern GT during that trio's brief run. If GM ever makes this concept, Opel and Vauxhall should get their versions. But Chevy is the one that could make this car a global icon. Chevrolet GT. Make it happen. News & Analysis News: The potential return of the Ford Bronco is generating a ton of attention. Analysis: That's not news, per se. But when the Bronco6G.com fan site did a rendering of a next-generation Bronco, it almost broke the Internet. Everyone from Automotive News to Jalopnik picked up the illustrations. Our own post has drawn a lot of traffic and passionate responses. People are clamoring for the Bronco's return.