Victory Red 2013 Camaro Zl1 Only 2100 Miles Cheap!! on 2040-cars

Auto blog

Diesel details: Comparing Ram 1500 EcoDiesel, Chevy Silverado Duramax, Ford F-150 Powerstroke

With specifications for the 2019 Ford F-150 Power Stroke diesel already out, and the details on the 2020 Ram 1500 EcoDiesel and Chevy Silverado Duramax (and its GMC Sierra twin) trickling out, we felt it was a good time to start comparing the full-size trucks' light-duty diesels. Bear in mind, we've only driven one of these new diesel trucks, so we'll be sticking to numbers for now. Some numbers haven't been announced yet, either, but stay tuned, because we'll be updating this post with additional specifications as they become available. And if you want to compare any other versions of these trucks with other vehicles, be sure to check out our comparison tool. Now let's start comparing, starting with our big chart of numbers below. As we can plainly see, these trucks are quite closely matched. Each one has six cylinders, a displacement of 3.0 liters and a turbocharger to boost it. The output of each is somewhat close, too. The Ram 1500 EcoDiesel is the torque king at 480 pound-feet, 20 more than the GM trucks and 40 more than the Ford. The GM trucks win on power, though, with 277 ponies, 17 more than the Ram, and 27 more than the Ford. GM does report that you get their trucks' peak 460 pound-feet of torque from 1,500 rpm to 3,000 rpm, whereas the others only report peak torque at a particular point in the rev band, but all of these trucks should have wide, flat torque curves as you would expect from modern turbodiesels. 2020 Ram 1500 EcoDiesel View 8 Photos Engine output is only one part of the truck performance equation. We also have towing and payload capacity, as well as fuel economy. With towing, the Ram 1500 is the current leader with a maximum capacity of 12,560 pounds. That tops the Ford F-150's 11,400-pound tow rating by well over 1,000 pounds. The F-150 can carry 2,020 pounds in its bed, but we don't know yet whether that's better or worse than the Ram or the GM trucks. We also don't have numbers for the GM trucks' towing capacities. View 9 Photos As for fuel economy, the Ford F-150 manages a thoroughly impressive 22 mpg in the city and 30 on the highway with two-wheel drive. Choosing four-wheel drive drops those numbers to 20 and 25 respectively. The fuel economy numbers for the Ram, Chevy and GMC haven't been revealed yet, but for some comparison, we can look at the old Ram EcoDiesel. That truck's best fuel economy was 20 in the city and 27 on the highway with two-wheel drive.

GM recalls select Tahoes, Yukons, Escalades for rear driveshaft issue

GM is recalling a number of its full-size SUVs due to an issue with the rear driveshaft assembly that could ultimately result in driveshaft failure. The actual number of total vehicles involved in the recall is small at just 1,789, but it’s spread out across the entire 2021 model year full-size GM vehicle lineup. That means a small number of every model is being recalled, including the Chevrolet Tahoe, Suburban, GMC Yukon, Yukon XL and the Cadillac Escalade and Escalade ESV. GM traced the issue back to certain driveshaft assemblies with ball bearings that were not properly heat treated. If theyÂ’re not properly heat treated, GM says that the balls may deform over time, causing noise and vibration. Continue to drive in this condition, and GM says the affected joint in the driveshaft assembly could seize, causing loss of drive power. However, the problem wonÂ’t present itself all at once, as GM says there will be a gradual increase of noises and vibrations before total failure. For those few owners with affected vehicles, GM says that it will replace the left and right rear driveshaft assemblies with properly-built units. Per usual with recalls, this will be done at your local dealership at no cost to the owner. If you have one of the recalled SUVs, expect to be notified mid-March. Related video:

GM adds 1,200 jobs at Detroit-Hamtramck plant

General Motors is making a big move at its Hamtramck, MI, factory, announcing it will add a second shift and hire over 1,200 workers within the next several months. It's expected that by early 2016, the factory will employ over 2,800 workers to build the Chevrolet Volt, Impala, Malibu, Cadillac ELR, and by early next year, the new CT6. According to GM Hamtramck spokesperson Courtney Zemke, 40 of the 1,200 positions are for salaried employees, while the remainder will be hourly positions. As for where these employees will go, positions are being made available across the factory, so GM isn't focusing on any particular area for its new hires. It's a similar story behind the hiring surge itself. GM said in its press release that the "second shift is necessary to meet forecasted market demand," a position Zemke reiterated. It's a matter of demand across the plant's portfolio, rather than any one particular product seriously outstripping supply. Naturally, the United Auto Workers is happy with the move. "The workforce at Detroit-Hamtramck is second to none," UAW Local 22 Shop Chairman Don LaForest said in the attached release. "We appreciate the opportunity to expand our UAW-GM family." Hiring is going on now, with the second shift slated to get underway in early 2016. GM's Detroit-Hamtramck Assembly to Add Second Shift and More Than 1,200 Jobs Plant will nearly double its workforce by early 2016 2015-10-22 DETROIT – General Motors is nearly doubling its workforce at Detroit-Hamtramck Assembly by adding a second shift and more than 1,200 hourly and salaried jobs. The addition of a second shift will increase the plant's workforce to approximately 2,800 people when hiring is completed. The second shift is necessary to meet forecasted market demand for the five cars produced at Detroit-Hamtramck. "This is the result of the award-winning vehicles Detroit-Hamtramck produces and the confidence GM has in our team to build world-class quality for our customers," said Plant Manager Gary West. Second shift hiring is underway, and the shift is scheduled to begin operations in early 2016. "The workforce at Detroit-Hamtramck is second to none," said UAW Local 22 Shop Chairman Don LaForest. "We appreciate the opportunity to expand our UAW-GM family." The 4.1 million-square-foot Detroit-Hamtramck Assembly opened in 1985. GM has invested $1 billion in the plant over the last six years, making it one of the company's most-agile manufacturing facilities in North America.