67 Camaro Big Block on 2040-cars

Auto blog

Europeans ask Chevy to bring Volt back to Europe

A group of French fans is asking for a jolt of support from General Motors to get the 2016 Chevrolet Volt across the pond. The Association Amperistes et Amis des Vehicules Rechargeables is running a Change.org petition that currently has 383 signatures out of a goal of 500. While the attempt is admirable, it's probably going to take a lot more than several hundred people for the model to make a return to the continent after the poor showing of the Opel Ampera – first-gen Volt's European cousin. The group's major argument for bringing a version of the second-gen Volt to Europe is that consumers need "an intermediate choice between expensive or range-limited pure electric cars and plug-in hybrids with a miserable electric range." Furthermore, such a vehicle would prod the competition to produce similarly efficient electrified models. They also lavish praise on the abilities of the Ampera for its long EV driving range. The supporters aren't entirely kind to GM in the petition, though, and claim the company excluded the original car from marketing efforts there. The Ampera actually enjoyed a strong European launch with more orders than initially expected and briefly topped the best-sellers list among EVs there. It was even named 2012 European Car of the Year. Those halcyon days didn't last long, and by 2014 sales fell off to a trickle. The waning reception caused GM's decision not to introduce a version of the new 2016 Volt there or in Australia. Related Video:

Next-gen Chevy Silverado and GMC Sierra may use carbon fiber

It's been generally accepted that the next generation of full-size GM trucks will use some sort of strong, lightweight material for the beds while retaining steel for the cab. While aluminum seems like the most obvious choice, according to Automotive News, the Chevy Silverado and GMC Sierra will incorporate both aluminum and carbon fiber in their beds. The publication cites sources from within GM, though it seems the introduction of this comparatively exotic material mix is still a few years off. While carbon fiber is both stronger and lighter than steel and aluminum, it takes significantly more time and money to produce, essentially relegating the material to small-volume cars. The main benefit for trucks is the resulting reduction in weight to improve fuel economy without sacrificing the tough, rugged capabilities truck buyers expect. The Ford F-150 made the switch to aluminum for the 2015 model year and it's proved highly successful. It seemed like it was only a matter of time before the competition followed suit. Automotive News says that the next-gen trucks will launch with aluminum beds and that it will take a couple of years before we'll see any carbon fiber incorporated into the design. Even then, only look for the composite material on higher-trim models, with a trickle down to lower-spec trucks possible further in the future. In 2011, GM announced it was working with Japan-based Teijin Limited on a carbon fiber reinforced thermoplastic. There's a good chance that material's introduction will be on trucks. Related Video: News Source: Automotive News Plants/Manufacturing Rumormill Chevrolet GM GMC Truck

GM recalls select Chevy Cruze, Sonic and Buick Verano models over airbag issue

General Motors is recalling certain 2012 Buick Verano, Chevrolet Cruze and Sonic models due to a defect in the driver's airbag system. According to the National Highway Traffic Safety Administration, the airbag has a shorting bar which may contact two internal terminals. If that happens during a crash, the supplemental restraint may not deploy, increasing the risk of driver injury. The recall includes a total of 2,949 units.
GM will contact owners and replace the steering wheel airbag coil at no cost. At this point, it's unclear when the recall will begin, though owners may contact the automaker at 1-800-521-7300 for more information. You may also take a closer look at the full NHTSA notice below.