1973 Chevrolet Camaro Lt 5.7l Good Driver on 2040-cars

Auto blog

GM opens official investigation into C8 Corvette transmission leaks

In March 2020, a month after Chevrolet began customer deliveries of the 2020 C8 Corvette, a GM dealer technician created a Reddit thread about a leaking gearbox in a Corvette with 32 miles. That car hadn't even been sold yet. Since then, as a search of "C8 Corvette transmission leak" shows, it's been tales of woe for some owners. Something in the Tremec TR-9080 transaxle in the back of the mid-engined Corvette doesn't work as it should, the fault able to cause codes that the transmission needs service, or that the driver needs to shift to park. In some cases, the battery would die because of follow-on issues after the initial transmission code, that code preventing the car from powering down. As Autoevolution reports, GM filed paperwork with the National Highway Traffic Safety Administration in August to look into what's going on. Between forum threads and GM's investigation document, there are several issues mentioned. The most common appears to be the dual-clutch transmission leaking fluid due to gasket failures like the one suffered by one owner at 858 miles, and another for an owner currently enduring a second leaking transmission. The Midengined Corvette Forum reported that Chevy engineers redesigned the TR-9080 pan, fitting Corvettes with the new unit at some point in the 2021 model year. The original pan was stamped steel unit affixed to the engine with two studs and 13 bolts, plus "reinforcement plates." The updated pan is said to be a cast aluminum unit affixed with two studs and 17 bolts, omits the reinforcement plates, and gets a new machined new groove around its edge to seat the gasket seal. The GM paperwork now at the NHTSA mentions a P1789 code, and says one reason for it could be "debris on the park position sensor magnet causing an incorrect position reading to the TCM." This might be caused by another issue mentioned in forums, which is clogged transmission filters. GM gives instructions for returning transmission filters to the company, and a poster on one forum said the Corvette tech at the dealer where he bought his Corvette told him the automaker "requires every used transmission filter to be returned to GM."  Whatever's going on, the problems haven't stopped, and they go beyond the P1789 code. Over the weekend, a 2022 Corvette owner posted on Corvette Forums that he got a check engine light on his car after just 850 miles.

Want a V8 on the cheap? Buy a work truck

In case you didn't notice, V8 cars have gotten pretty expensive. If you want a modern muscle car like the Dodge Challenger R/T, Ford Mustang GT, or Chevy Camaro SS, you'll need between $34,000 and $38,000 for a stripped out example of one. The cheapest of those is the Challenger, and the priciest is the Camaro. These are also the cheapest V8 cars the companies offer. But if you absolutely have to have a V8 for less, there is an option, work trucks. As it turns out, all of the Big Three offer their most basic work trucks with V8s. And because they're so basic, they're pretty affordable, especially when sticking with the standard two-wheel drive. A Ram 1500 Tradesman with a V8 can be had for as little as $29,840, which is a little more than $4,000 less than a Challenger R/T. For a bit more at $30,275, you can have a Chevy Silverado W/T, almost $8,000 less than a Camaro SS. The most expensive is the V8 Ford F-150 starts at a starting price of $30,670, which is a bit over $5,000 less than the Mustang. Of course you'll be in an ultra bare bones vehicle with few comforts, and the price will go up if you add stuff, but we're bargain hunting here, and sacrifices are sometimes necessary. Besides, what you lose in comfort, you gain in loads of cargo space and towing (try to look at the bright side). Also, as a side note, all three trucks are available with optional electronic locking rear differentials. At the discounted price of these trucks, you still get a heaping helping of power. The most potent of the trio is the Ram 1500 Tradesman with 395 horsepower and 410 pound-feet of torque generated by a 5.7-liter V8. Compared with the Challenger R/T, the Ram is up by 20 horsepower and they're tied for torque. The value proposition is even more stark between the two vehicles when looking at the price per horsepower. Each pony in the Ram costs $75.54, while the Challenger charges you $90.91. The Challenger is also more expensive per horsepower than its close competitors. The F-150's 5.0-liter V8 is just barely behind the Ram with 395 horsepower and 400 pound-feet of torque. That's still more power than the Challenger, and it matches the torque of the 2017 Mustang GT. On the down side, it still would be down 20 horsepower on that same 2017 Mustang, and it's behind by 60 horsepower and 20 pound-feet on the new 2018 Mustang GT. The F-150 also just edges out the Mustang in the dollar per horsepower measure.

Bob Lutz builds the case for a mid-engined Corvette

Rumors of a mid-engine Corvette are like automotive industry folklore at this point. Every once in a while, news pops up that it might be happening or is under development, but nothing actually ever comes to fruition as something people can actually buy. The latest spy shots strongly suggest a mid-engine 'Vette is in the cards, yet again, possibly for 2018. Now, an op ed by former General Motors executive (and definite performance car fan) Bob Lutz in Road & Track gives the inside scoop on the history of one of these proposals and lays out how to make it happen today. According to Lutz, the company's engineers believed the C6 ZR1 was at the limit for front-engine, rear-wheel drive performance in that package, and the only solution was to move the powerplant behind the driver. Lutz even got then CEO Rick Wagoner on board. The scheme made it at least as far as clay models for mid-engine versions of the 'Vette and Cadillac XLR. Eventually, a lack of money got in the way, though, bringing the project to an end. Lutz puts a lot of faith in GM's current leaders, especially Mary Barra and Mark Reuss. He thinks the chances of a mid-engine 'Vette happening this time are better than 50 percent. The model, rumored to be named Zora, could offer over 700 horsepower in an ultra lightweight body and be priced at about $120,000 to "suck the doors off everybody." Head over to Road & Track to get some insights from this highly respected and entertaining auto industry veteran. Related Video: