** One Of The Nicest-straightest 1967 Rs Camaro's We've Ever Had !!!! *** on 2040-cars
New Castle, Delaware, United States
Body Type:Coupe
Engine:468
Vehicle Title:Clear
Fuel Type:Gasoline
For Sale By:Dealer
Interior Color: Black
Make: Chevrolet
Number of Cylinders: 8
Model: Camaro
Trim: RS
Warranty: Vehicle does NOT have an existing warranty
Drive Type: RWD
Mileage: 1,000
Sub Model: RS
Exterior Color: Blue
*** WE CANNOT STRESS HOW NICE THIS CAR IS !!!!!! *** 1967 CAMARO RS *** ORIGINALLY BLUE WITH A BLACK DELUXE INTERIOR AND A REAL RS "327" 4-SPEED CAR *** PREVIOUS OWNER ( IN HIS 70'S NOW) BOUGHT THE CAR BACK IN 1994 AND ENJOYED UNTIL 2007- WHEN HE BROUGHT IT TO THE LEVEL YOU SEE NOW........
I'LL START WITH THE PAINT AND BODY:
*** INCREDIBLY STRAIGHT- WITH NICER THAN FACTORY GAPS !!!! FIREWALL, FLOORS, TRUNK ....SHOW AMAZING ATTENTION TO DETAIL WHEN IT WAS BEING BUILT !!!!!
*** THE PAINT IS "MILES DEEP" AND DONE TO A VERY HIGH STANDARD- INCLUDING THE PAINTED CENTER STRIPES !!!!! SHOW QUALITY THAT WOULD MAKE ANY OWNER PROUD !!!!!
NOW THE MEAT:
*** THE MOTOR IS A PURPOSE BUILT GM "SEASONED" .30 OVER "454" 4 BOLT BLOCK = "468".....
*** BUILT WITH GOOD PARTS: "EAGLE" CRANK... "EAGLE" RODS... "WEISCO" RACE PISTONS.... PORTED "BORDIX" BB RACE HEADS... ROLLER "COMP CAMS": 312int/319exh... CUSTOM "HOLLEY" 4150 950cfm CARB FLOWED BY DEAN NICKERSON....
TRANS:
*** BUILT TH400 WITH TRANS BRAKE....
REAR:
*** DANA 60 WITH "SUMMERS BROS" BILLET AXLES AND 4:56 GEARS....
SUSPENSION:
*** FULL LINKED REAR
*** FULL 3" EXHUAST WITH LOW RESTRICTION MAGNA FLOW 3 MUFFLERS ( TURN DOWNS)
*** PROFESSIONALLY BUILT 10 POINT CHASSIS BAR/CAGE ( CERTIFIED FOR 8:50 BRACKET)
*** MSD IGNITION 7AL WITH TRANS BRAKE DELAY TRIGGER
*** REAR "RS" FUEL CAP CONVERTED TO ON/OFF SWITCH FOR 12V BATTERY LOCATED IN TRUNK (REALLY COOL)
*** CUSTOM FUEL TANK LOCATED IN FACTORY LOCATION WITH 1969 STYLE FUEL FILL UP BEHIND LICENSE PLATE....
A COUPLE OF VIDEO'S OF STRAT UP AND WALK AROUND :
https://www.youtube.com/watch?v=phcVxJj0Vls
AND:
https://www.youtube.com/watch?v=sFqLcgdeBR4
*** CAR WAS BUILT FROM A RETIRED HOT RODDER/CAR COLLECTOR AND VERY CRAFTED MACHINIST BY TRADE.... OVER $45,000 INVESTED... NOT INCLUDING SOME NUMEROUS MAN HOURS/LABOR NOT ACCOUNTED FOR......
JUDGING BY THE WORK PERFORMED AND DONE ON THE CAR- IT WOULDN'T TAKE MUCH TO MAKE IT A STREET OR EVEN COOLER "PRO-TOURING" CAR..... IT'S NICE TO SEE A CAR THAT'S NOT "HACKED-UP" OR HAS BEEN "RUSHED"- PUT TOGETHER !!!!! FROM THE INTERIOR TO THE UNDERCARRIAGE- THIS CAR DOES NOT DISAPPOINT !!!!!
FOR MORE PICS AND INFO CONTACT: JAY BROWN (302)-395-7553 OR JAY.BROWN@PRICEAUTOGROUP.COM
SHIPPING AVAILABLE IF NEEDED.... PLEASE HAVE FUNDS READY WHEN PURCHASING- WE DO NOT HAVE ANY BANKS THAT FINANCE CARS THIS OLD !!!! TRADES ARE WELCOME, BUT THEY MUST BE BROUGHT HERE FOR US TO SEE IN PERSON - NO EXCEPTIONS !!!!
Chevrolet Camaro for Sale
Auto Services in Delaware
Star Loan Auto Ctr ★★★★★
Springfield Mitsubishi Pa ★★★★★
Rick`s Auto Service ★★★★★
Pro-Bond Auto Glass ★★★★★
Piazza Honda of Drexel Hill ★★★★★
Oxford Auto & Tire ★★★★★
Auto blog
Lutz dishes dirt on GM in latest Autoline Detroit
Mon, 20 Jun 2011Bob Lutz sits down for Autoline Detroit - Click above to watch video after the jump
Autoline Detroit recently played host to Bob Lutz, and, as is always the case, the former General Motors vice chairman dished out some great commentary. Lutz was promoting his new book Car Guys vs. Bean Counters: The Battle for the Soul of American Business, and talk quickly turned to his role as it related to product development and high-level decision making at GM. While on the topic of brand management, Lutz revealed a few rather interesting tidbits about his former employer:
All Chevrolet vehicles were required to have five-spoke aluminum wheels and a chrome band up front, as part of the Bowtie brand's overall image.
Sinkhole Opens Up In National Corvette Museum, Swallows Eight Cars
Wed, Feb 12 2014More cars are being moved inside the National Corvette Museum in Bowling Green, Ky. to avoid falling down the same sinkhole that swallowed eight classic sports cars early this morning, Autoblog reported. Museum officials said the hole was discovered when motion sensors activated around 5:45 a.m. The rescue mission can be viewed on the museum's live feed cameras, which weren't working after the sinkhole emerged. A 1993 ZR-1 Spyder and a 2009 ZR1 "Blue Devil," both on loan from General Motors, were among the cars that fell into the sinkhole. The museum owned the other affected Corvettes, which included a 1963 Corvette, a 1984 PPG Pace Car and the 1 millionth Corvette ever produced. The state of the cars at the bottom of the hole isn't known, but trial lawyer and sinkhole expert Ted Corless said the cars may be a total loss for the museum and GM. "Most states, including Kentucky, exclude damage caused by sinkhole activity," he said. "There will be, in all likelihood, a claim made, but a lot of policies would specifically exclude these kinds of damages." Corless has 15 years experience dealing with sinkholes. He said that typically neither the building, nor the cars themselves are protected under their insurance policies. "I would have to say, more likely then not, they're going to have an uninsured loss measured in the hundreds of thousands of dollars." The museum is closed Wednesday while a structural engineer assesses the damage. Related Gallery 2014 Chevrolet Corvette Stingray Test Drive View 9 Photos Related Gallery 2014 Chevrolet Corvette Stingray Test Drive View 9 Photos Weird Car News Chevrolet GM corvette
The 2021 F-150 elevates Ford's bed game
Fri, Jun 26 2020The new 2021 Ford F-150 is ushering in a new era of pickup capability, but there's more to it than the introduction of the PowerBoost hybrid. While that new powertrain is certainly the truck's headlining element, the supporting electrical architecture enables a level of utility that hasn't been offered in past consumer half-tons. The true party trick is Ford's new "Pro Power Onboard" feature, which is essentially a built-in generator that provides juice for the 2021 F-150's rather robust in-bed power station. This system is available even on gasoline-engine models, but its utility is maximized with the electrified powertrain. ICE models equipped with the option max out at 2.0 kilowatts, while the PowerBoost hybrid can be had with either a 2.4- or a whopping 7.2-kilowatt inverter. The idea here is that the F-150 can essentially stand in for a high-output portable generator. In a worksite example provided by Ford, a PowerBoost model with the 7.2-kW upgrade and a single tank of fuel could provide 32 hours of power for an 1,800-watt compound miter saw, a 1,000W circular saw, a 1,200W battery charger, a 1,200W hammer drill, and a 1,000W air compressor with hundreds of watts to spare for lighting and other accessories. But even without the Pro Power Onboard option, Ford's new bed setup enables more versatility than in previous models. The new Tailgate Work Surface option adds a flat work area with integrated rulers, recesses for pencils or small tools, and even a stand for a personal device. Ford is neither the first to offer an auxiliary power outlet in a half-ton pickup bed, nor was Ford the first to introduce a more feature-rich tailgate. GMC's MultiPro tailgate was a major innovation on that front, and while it is geared mostly toward improving the cargo utility of the bed, it can also be customized with 12-volt power and even an accessory speaker system. The Ram 1500 is also offered with both a multi-function tailgate and AC power in the bed, though the latter option is limited to models with the RamBox cargo package. As half-ton pickups approach levels of towing and hauling capability that begin to blur lines with heavy-duty offerings, it's clear that automakers are looking for ways to differentiate themselves without stepping on their own bigger trucks' toes. These new bed and tailgate innovations may yet be the tip of the iceberg when it comes to full-size pickup versatility. Related Video: