2001 Chevy Silverado 2500hd 4x4 Extended Cab Long Bed on 2040-cars

Auto blog

Driving Granatelli's turbine-powered 1978 Chevy Corvette [w/video]

With its curvy snout and feminine haunches, the third-gen Chevrolet Corvette looks like a dreamy – if dated – exemplar of Sports Car Fantasy 101 when viewed through modern eyes. This particular specimen circa '78, clad in silver and black paint with red pinstripes, appears to be a well-preserved example from the era. Apart from its low-profile Pirellis, slightly raised and slotted hood, spacious stance and a certain hand-painted descriptor alongside its crossed flag logos, you'd never guess there's a Space-Age propulsion unit powering this Coke bottle-bodied ride. Climb inside, and you're presented with aircraft gauges and big, colorful square buttons in the center panel. It takes a push of the "Ignitor" button, a tap of the starter button, and a slide of a T-handle for this nearly 40-year-old sports car to start sounding like Gulfstream G650 ready for takeoff. Yep, you're sitting in an 880-horsepower, turbine-powered Corvette, the only one of its kind in the world. Welcome to the whoosh. What The...? Built by Vince Granatelli, son of Indy 500 guru Andy Granatelli, this curious Corvette came into being by cramming a Pratt & Whitney ST6N-74 gas turbine engine into the donor car's lengthy front end. The same type of Jet A-burning mill powered Granatelli Senior's STP-sponsored racecar at the 1967 Indianapolis 500, where it famously led most of the 198 of 200 laps until a $6 transmission bearing failed, knocking it out of the race. The idea of turbine power usurping internal combustion was so threatening that Indy's governing body restricted turbine performance into obsolescence thereafter. A turbine-powered Corvette sounds excessive because it is. But there are also things about this 880-horsepower, 1,161-pound-feet monster that might surprise you. While it smacks of futurist exoticism and cost a then-dizzying $37,000 in 1967, the Canadian-built powerplant uses 80 percent fewer parts than an internal combustion V8 and will run on virtually anything combustible – whiskey, diesel, even Chanel No. 5. Though it's triple the length of a V8, the Pratt & Whitney beast weighs only 285 pounds. It's also one hell of a robust workhorse, typically serving as an auxiliary power unit for commercial aircraft or a generator in oil fields, where it can run for tens of thousands of consecutive hours before needing an overhaul. To adapt the Chevrolet for jet duty, the nose section was gutted and a sub-frame was built to compensate for the loosey-goosey front end.

GM dealers unhappy about pickup prices

The backlash is beginning. Following General Motors' price hike of the Chevrolet Silverado and GMC Sierra last week, dealers across the country are expressing their ire over increasing prices in the face of rebates and discounts on trucks from Ford and Ram.
Speaking to Automotive News, Sam Pilato, the general manager at Dimmitt Chevrolet in Clearwater, FL, Silverados are "selling very poorly." W. Carrol Smith, the president of Monument Chevrolet in the heart of truck country, Texas, said, "[GM's] position is that the vehicle stands on its own and it doesn't need a bigger rebate. That's not what the market is telling us."
According to AN, that's the general attitude amongst Chevy and GMC dealers across the country, where the twin pickups are getting butchered in sales by competitors offering up to $9,000 off their sticker prices. Part of the problem for GM is that its trucks are arriving on the market near the end of the current F-150's lifecycle, a fact that Ford has taken advantage of.

Chevy Bolt officially keeping name, says marketing boss

There might be just a little confusion at first, but the Bolt name is sticking around. After conducting two consumer studies into the name, Chevrolet isn't worried about the similarity of the monikers for the upcoming EV and existing Volt plug-in hybrid. In fact, the brand thinks the resemblance might be for the best. "The decision is made. The name won't be changed." Chevy head of marketing Tim Mahoney said to The Detroit Free Press. The research shows that the compatibility between the two names actually works quite well. With the Volt well established, people apparently already connect the Bolt to the Bowtie, which is just what a brand wants. Both studies indicated the ""same result, it did well," according to Mahoney. Just a few months ago, the future of the Bolt's name wasn't so clear. GM North America President Alan Batey said the company knew there might be confusion, and it was still mulling its options. The Bolt could be a breakthrough in the EV market with a 200-mile range and a possible price of around $30,000 after incentives. Production is set for the Orion Assembly plant in Michigan following a $200 million upgrade there, and the model could be in dealers as soon as 2017. That's just in time to take on the Tesla Model 3 with its claimed $35,000 price and similar driving distance as the Chevy. Related Video: