1999 Chevy Silverado With Utility Box on 2040-cars

Auto blog

GM says EVs are the future — but trucks are going to take it there

In the PowerPoint deck for the General Motors Capital Markets Day presentation, one of the more disturbing things comes early on, during GM President Mark Reuss' initial remarks, in an area where he is discussing the company's overall strength in trucks. The point being made is that GM has a truck for all and sundry. And there it is, a phrase on a slide that should send chills up the spines of those who still pine for the old Bob Seger "Like a Rock" Silverado ads: "Little bit country. Little bit rock 'n' roll." That's right. Donny and Marie. Somehow the Denis Leary snark in the F-150 ads is all the more appealing. The Capital Markets Day presentation was chock full of observations about electrification and automation (Reuss and CEO Mary Barra both noted that the corporation's vision is one of "Zero Crashes. Zero Emissions. Zero Congestion." Dan Ammann talked about the progress being made at Cruise Automation; Reuss rolled out the plan for an array of electrified vehicles, with a luxury EV and a compact SUV being the "Centroid Entries" for the modular bases of many others). But it is worth noting that there is no getting away from the power of pickups in the U.S. market, as that was the central topic in Chief Financial Officer Dhivya Suryadevara's comments, with "Truck Franchise" being flanked by "Key Financial Priorities" and "Financial Outlook." Clearly, to gloss the old phrase, the truck segment is where the money is. Suryadevra enumerated how the truck segment is significantly different than other types of light vehicles. Among her points: GM, Ford and FCA have more than 90% of market share. The truck parc has been growing and aging over the past 10 years. Customers are fiercely loyal to the segment—as in 70% of truck buyers are truck buyers. A good number of the vehicles are for commercial use (40 percent). Trucks are "less prone to. . .mobility disruption." Trucks offer high margins. Translaton: The segment is one that they're solidly positioned in. There are lots of old trucks on the road that will need to be replaced by new ones. Perhaps buyers may switch from a Sierra to a Canyon, but it will be a truck. If your livelihood depends on that type of vehicle, even if gas prices go up or the economy begins to go south, you're going to stick with it. Most of the country isn't San Francisco, so trucks will continue to be essential. And, well, they're profitable in the extreme.

Want a V8 on the cheap? Buy a work truck

In case you didn't notice, V8 cars have gotten pretty expensive. If you want a modern muscle car like the Dodge Challenger R/T, Ford Mustang GT, or Chevy Camaro SS, you'll need between $34,000 and $38,000 for a stripped out example of one. The cheapest of those is the Challenger, and the priciest is the Camaro. These are also the cheapest V8 cars the companies offer. But if you absolutely have to have a V8 for less, there is an option, work trucks. As it turns out, all of the Big Three offer their most basic work trucks with V8s. And because they're so basic, they're pretty affordable, especially when sticking with the standard two-wheel drive. A Ram 1500 Tradesman with a V8 can be had for as little as $29,840, which is a little more than $4,000 less than a Challenger R/T. For a bit more at $30,275, you can have a Chevy Silverado W/T, almost $8,000 less than a Camaro SS. The most expensive is the V8 Ford F-150 starts at a starting price of $30,670, which is a bit over $5,000 less than the Mustang. Of course you'll be in an ultra bare bones vehicle with few comforts, and the price will go up if you add stuff, but we're bargain hunting here, and sacrifices are sometimes necessary. Besides, what you lose in comfort, you gain in loads of cargo space and towing (try to look at the bright side). Also, as a side note, all three trucks are available with optional electronic locking rear differentials. At the discounted price of these trucks, you still get a heaping helping of power. The most potent of the trio is the Ram 1500 Tradesman with 395 horsepower and 410 pound-feet of torque generated by a 5.7-liter V8. Compared with the Challenger R/T, the Ram is up by 20 horsepower and they're tied for torque. The value proposition is even more stark between the two vehicles when looking at the price per horsepower. Each pony in the Ram costs $75.54, while the Challenger charges you $90.91. The Challenger is also more expensive per horsepower than its close competitors. The F-150's 5.0-liter V8 is just barely behind the Ram with 395 horsepower and 400 pound-feet of torque. That's still more power than the Challenger, and it matches the torque of the 2017 Mustang GT. On the down side, it still would be down 20 horsepower on that same 2017 Mustang, and it's behind by 60 horsepower and 20 pound-feet on the new 2018 Mustang GT. The F-150 also just edges out the Mustang in the dollar per horsepower measure.

2016 Chevrolet Camaro powers up, slims down

Don't be fooled by its familiar appearance, the 2016 Chevrolet Camaro is vastly different than its iconic predecessors. It has a new chassis, a fresh engine lineup, and is loaded with clever technologies that promise to invigorate and improve the sixth generation of Chevy's legendary sports car. It was revealed Saturday before a crowd of enthusiastic Camaro revelers on Belle Isle in Detroit. Redesigning the sports coupe was a heady task, especially as its archrivals, the Ford Mustang and Dodge Challenger, drive better and are more powerful than ever. But the new Camaro is aiming to be the best combination of handling and raw performance, with quick acceleration and competitive fuel economy. "Redesigning the Camaro is thrilling and challenging all at once, but the secret is to offer something more," Mark Reuss, General Motors executive vice president of product development, said in a statement. It all began with a weight-loss plan. The new Camaro shed more than 200 pounds compared with the outgoing car, with 133 pounds coming from a lighter body-in-white. Then engineers culled weight nearly everywhere, using aluminum for the instrumental panel frame and some suspension components to trim as much fat as possible. The slimmer body rests on new bones. The Camaro's rear-wheel-drive platform is lighter and stiffer in a bid to improve handling. It's a modified version of the underpinnings used by the Cadillac ATS, though about 70 percent of the architecture is unique to the Camaro. Chevy said structural rigidity is improved by 28 percent. As you'll see, healthy doses of Cadillac and Corvette technologies have been used to bolster the Camaro's drive character and performance. The new car is also expected to handle better thanks to a slightly smaller footprint. It is about two inches shorter in length, with most of that due to the more compact wheelbase. It's also an inch shorter in height and an inch slimmer in width. So yes, the Camaro will be leaner, but it will still be plenty mean. The Camaro SS tops the range (for now) with the Corvette's 6.2-liter V8 pushing put 455 horsepower and 455 pound-feet of torque. Known as the LT1, is has a cast aluminum block and cast aluminum cylinder heads, and it's fortified with direct injection, variable valve timing, and cylinder deactivation. About 20 percent of the engine's parts are said to be unique to the Camaro, including the exhaust manifolds.