1985 Chevrolet C/k Pickup 1500 on 2040-cars

Auto blog

Driving Granatelli's turbine-powered 1978 Chevy Corvette [w/video]

With its curvy snout and feminine haunches, the third-gen Chevrolet Corvette looks like a dreamy – if dated – exemplar of Sports Car Fantasy 101 when viewed through modern eyes. This particular specimen circa '78, clad in silver and black paint with red pinstripes, appears to be a well-preserved example from the era. Apart from its low-profile Pirellis, slightly raised and slotted hood, spacious stance and a certain hand-painted descriptor alongside its crossed flag logos, you'd never guess there's a Space-Age propulsion unit powering this Coke bottle-bodied ride. Climb inside, and you're presented with aircraft gauges and big, colorful square buttons in the center panel. It takes a push of the "Ignitor" button, a tap of the starter button, and a slide of a T-handle for this nearly 40-year-old sports car to start sounding like Gulfstream G650 ready for takeoff. Yep, you're sitting in an 880-horsepower, turbine-powered Corvette, the only one of its kind in the world. Welcome to the whoosh. What The...? Built by Vince Granatelli, son of Indy 500 guru Andy Granatelli, this curious Corvette came into being by cramming a Pratt & Whitney ST6N-74 gas turbine engine into the donor car's lengthy front end. The same type of Jet A-burning mill powered Granatelli Senior's STP-sponsored racecar at the 1967 Indianapolis 500, where it famously led most of the 198 of 200 laps until a $6 transmission bearing failed, knocking it out of the race. The idea of turbine power usurping internal combustion was so threatening that Indy's governing body restricted turbine performance into obsolescence thereafter. A turbine-powered Corvette sounds excessive because it is. But there are also things about this 880-horsepower, 1,161-pound-feet monster that might surprise you. While it smacks of futurist exoticism and cost a then-dizzying $37,000 in 1967, the Canadian-built powerplant uses 80 percent fewer parts than an internal combustion V8 and will run on virtually anything combustible – whiskey, diesel, even Chanel No. 5. Though it's triple the length of a V8, the Pratt & Whitney beast weighs only 285 pounds. It's also one hell of a robust workhorse, typically serving as an auxiliary power unit for commercial aircraft or a generator in oil fields, where it can run for tens of thousands of consecutive hours before needing an overhaul. To adapt the Chevrolet for jet duty, the nose section was gutted and a sub-frame was built to compensate for the loosey-goosey front end.

2014 Chevrolet Corvette Stingray priced from $51,995*

After months of speculation, Chevrolet has finally revealed the official starting price of the 2014 Corvette Stingray. The base MSRP for the 450-horsepower Stingray Coupe will be $51,995, while the Stingray Convertible will go for $56,995 (*both prices include a $995 destination fee). This means that the price increase from 2013 to 2014 is just $1,400 for the coupe and $2,395 for the convertible - pretty modest increases considering the upgrade in specifications. Of course, neither price accounts for the sort of dealer markup that might grace early C7 window stickers, especially since less than a third of all Chevrolet dealers will be allocated Corvette models to sell at the car's launch.
Now, these prices are for the base car, so if you're wondering how much a fully loaded Stingray will run, Chevy has given us a good indication of that as well. The coupe we saw on display at the Detroit Auto Show (shown above), for example, would run $73,360 including options such as the $2,800 Z51 Performance Package, $2,495 competition sport seats and the $1,795 Magnetic Ride Control option - just to name a few. Stepping up to the 3LT trim level that brings a full leather interior will run an extra $8,005 over the base price.
While $20,000 in options may seem like a lot, this "as-tested" price still has the C7 competitively priced against rival coupes like the Porsche 911 and Nissan GT-R. Speaking of price comparisons, Chevrolet also points out that the C7 Stingray Z51 costs $2,200 less than the C6 Grand Sport while delivering better acceleration (0-60 mph in less than four seconds) and improved track performance (including more than 1 g in cornering).

Regular-cab, short-bed Chevy Silverado Trail Boss pickup looks great

For all the wild popularity of full-size pickups, there's one configuration that U.S. buyers are no longer offered: the regular-cab, short-bed truck. Interestingly, however, GM still does make this configuration, and both the Chevrolet Silverado and the GMC Sierra are offered with it — in the Mexican market. That body style, however, is available solely in ultra-basic work-truck form. But a custom wheel shop, JC Wheels in the Mexican city of Culiacan, has converted one of these Silverados to Trail Boss trim, and we're digging the result. The sporty shorty Silverado Trail Boss comes to our attention via GM Authority, after the shop posted it on their Instagram feed. The shop added a 3-inch lift, assist steps, Chevy alloy wheels, a Trail Boss front fascia including red tow hooks, and Trail Boss badging. They also added dark window tint, which seems like a good idea in sunny Mexico. In the U.S., the Silverado Trail Boss isn't offered at all in regular-cab form; it only can be had as a double cab or a crew cab, the latter with a choice of a short bed or standard bed. But size is often a hindrance for trucks that actually get driven on trails, where this regular-cab, short-bed variant's smaller wheelbase would be an advantage. Beyond that, the Trail Boss upgrades keep this configuration from looking like a basic-spec machine. That's even more true of the same outfit's previous efforts: the conversion of the GMC Sierra regular-cab, short-bed pickup into a Denali. With so many buyers choosing pickups as personal-use vehicles, it's not hard to think that this configuration could find an audience here. But the key would be to do as this Mexican firm has done and offer it in the desirable off-road and luxury trims, rather than as a basic work truck. Would you buy one? Sound off in the comments below. The next step would be to use this configuration as the basis of a full-size, two-door SUV, in the mold of the classic Chevy K5 Blazer and GMC Jimmy.