on 2040-cars

Auto blog

Chevy's 6.6-liter Duramax is pretty much all new

To say there's a heated battle in heavy-duty pickups is an understatement, with Chevrolet, Ford, and Ram constantly trading blows of increased torque, horsepower, and towing capacity. The latest salvo is the revised, more powerful turbo diesel 6.6-liter Duramax V8 in the 2017 Chevy Silverado. It has 910 pound-feet of torque, an increase of 145, putting it nearly level with the Ford Super Duty. Here's a closer look at where those gains come from. How exactly did Chevrolet add all that torque plus 48 horsepower? The automaker essentially took a fine-tooth comb to the entire engine. Chevy says it changed 90 percent of the V8, and the cumulative effect of those small changes adds up to big increases. As you might guess, the turbocharger is updated. The larger unit features electric actuation of the variable nozzle turbine (VNT), and what Chevy calls a double axle cartridge mechanism that separates the VNT moving parts from the housing. That helps with heat performance as well, with a claim that the exhaust side of the turbo can run continuously up to 1,436 degrees Fahrenheit. Helping that cause are six exhaust gaskets made of Inconel - an nickel alloy that contains chromium and iron – and upgraded stainless steel for the exhaust manifold. Despite having the same cast iron cylinder block, albeit with some minor enhancements, the engine has new cylinder heads, pistons, piston pins, connecting rods, and crankshaft, which have all been upgraded to handle 20 percent higher cylinder pressures. Alongside the increase in pressure, Chevrolet also increased the cylinder head's structure with a honeycomb design. The pattern features high-strength aluminum with dual layer water jackets that not only improve strength, but also optimize water flow for better cooling. For 2017, the cylinder head also benefits from integrated plenum that aids the engine in getting more air under heavy loads. The cylinder head isn't the only component to get a minor update, as the pistons have a larger diameter pin for improved oil flow. The same detailed improvements has been bestowed to the humble connecting rods (second in our hearts only to the inanimate carbon rod). The new design has the bolts oriented roughly 45-degrees to the rod instead of parallel. The angle split design, as it's called allows for easier passage through the cylinder.

NHTSA investigating nearly 750,000 GM models over non-deploying airbags

Nearly 750,000 vehicles built by Chevrolet, GMC, and Cadillac are the subject of a National Highway Traffic Safety Administration (NHTSA) investigation due to non-deploying driver-side airbags. While the investigation is ongoing, the agency believes the issue is likely due to rust particles that form on the inflator's connection terminal interface. The list of nameplates included in the investigation includes Chevrolet's Silverado, Tahoe, and Suburban, GMC's Sierra, Yukon, and Yukon XL, plus Cadillac's Escalade, Escalade ESV, CT4, CT5, and XT4. All of the potentially affected vehicles are 2020 or 2021 models, according to a bulletin published on the NHTSA's website. Investigators launched the probe in April 2021 after 15 consumers reported airbag-related issues, including nine who said an airbag malfunction light appeared in the instrument cluster. More alarmingly, the NHTSA is aware of six accidents that caused significant damage to the car's front end yet didn't trigger the driver's airbag. It adds that there are no fatalities linked to the issue, but there are six crashes and eight injuries reportedly blamed on it. No evidence suggests this problem is related to the millions of potentially deadly Takata inflators recalled over the past few years. General Motors is aware of the defect. It sent a technical service bulletin (TSB) to its dealers in March 2021 to address the aforementioned warning light. The note explains the issue is due to "rust particles in the connection terminal interface of the driver's airbag inflator." The company hasn't issued a safety recall yet, however. Whether it will partially depends on the NHTSA's findings. It's currently looking into the scope and the severity of the problem, and it wants to understand its implications on driver safety. Investigators will decide whether General Motors needs to recall the 749,312 cars that are part of the probe when they close their investigation. General Motors has already spent a significant amount of money replacing defective airbag-related parts in its cars. In November 2020, it was ordered by the American government to recall nearly 6 million pickup trucks and SUVs equipped with potentially dangerous Takata airbag inflators. It repeatedly argued that testing proved the inflators were safe, and it petitioned the agency four times starting in 2016 to avoid a recall, which cost an estimated $1.2 billion (about a third of its net income in 2020).

GM says its electric pickup truck is 'in development'

GM President Mark Reuss just reiterated the company's support for an electric pickup project. He also claimed that GM is going to be selling its future electric cars at "very average transaction prices" during the same conference with Wall Street analysts. Previously, Mary Barra informed the world of GM's electric pickup truck aspirations, but didn't tell us anything else. Reuss says the truck is already in development, though, according to a Wards Auto report. "We will have a complete electric lineup, including a pickup truck that's in development," Reuss said. This comment marks the second time GM has gone on the record about its intentions to bring an electric pickup to market. Additionally, Reuss said GM's third-generation global EV platform will be used to help develop the electric pickup. This platform was recently announced to underpin at least 20 new EVs from GM in the future — the platform itself is slated to be unveiled in 2021. Of course, this platform will be flexible and modular to allow various body styles to be used with it, a truck being one of those. Reuss still hasn't said what GM brand the pickup will be sold under, or what class of truck it will be. GM thinks this new platform is also going to be what helps it drive down the cost of building EVs. "We'll reach parity a lot sooner than people think," Reuss said comparing EVs to traditional gas-powered engines. "We're driving down the cost of batteries and the whole EV in general." As for electric pickups, Ford is also deep in development of its own electric F-150. However, neither of these truck projects have official timelines on them, so we can't say when they'll hit the market. For now, the cross-town rivals are both in development with their respective electric pickups. Even further across town is Rivian (in which Ford just invested half a billion dollars), a company that says its electric R1T pickup is right around the corner, with the official due date being end of 2020 for the time being. Green Chevrolet GMC Green Culture Green Driving Truck Electric Future Vehicles