1974 One Owner Chevrolet C-10 Lwb on 2040-cars

Auto blog

Next-gen Chevy Silverado and GMC Sierra may use carbon fiber

It's been generally accepted that the next generation of full-size GM trucks will use some sort of strong, lightweight material for the beds while retaining steel for the cab. While aluminum seems like the most obvious choice, according to Automotive News, the Chevy Silverado and GMC Sierra will incorporate both aluminum and carbon fiber in their beds. The publication cites sources from within GM, though it seems the introduction of this comparatively exotic material mix is still a few years off. While carbon fiber is both stronger and lighter than steel and aluminum, it takes significantly more time and money to produce, essentially relegating the material to small-volume cars. The main benefit for trucks is the resulting reduction in weight to improve fuel economy without sacrificing the tough, rugged capabilities truck buyers expect. The Ford F-150 made the switch to aluminum for the 2015 model year and it's proved highly successful. It seemed like it was only a matter of time before the competition followed suit. Automotive News says that the next-gen trucks will launch with aluminum beds and that it will take a couple of years before we'll see any carbon fiber incorporated into the design. Even then, only look for the composite material on higher-trim models, with a trickle down to lower-spec trucks possible further in the future. In 2011, GM announced it was working with Japan-based Teijin Limited on a carbon fiber reinforced thermoplastic. There's a good chance that material's introduction will be on trucks. Related Video: News Source: Automotive News Plants/Manufacturing Rumormill Chevrolet GM GMC Truck

Question of the Day: Worst year of the Malaise Era?

The Malaise Era for cars in the United States spanned the 1973 through 1983 model years, and featured such abominations as a Corvette with just 205 horsepower (from the optional engine!) and MGBs with suspensions jacked way up to meet new headlight-height requirements. There were many low points throughout this gloomy period, of course. The horrifyingly low power and fuel-economy numbers for big V8s during the middle years of the Malaise Era make a strong case for 1974 or 1975— the years of Nixon's resignation and the Fall of Saigon, respectively— as the most Malaisey years. But then the GM-pummeling debacles of the Chevy Citation and Cadillac Cimarron could make an early-1980s year the low point. 1979, the year of the ignominious Chrysler bailout? You choose! Related Video:

Leno drives Ringbrothers' latest, 1966 Chevy Chevelle Recoil

Jay Leno has been checking out quite a few older rides in his garage as of late, but has mixed things up a little this week. Ringbrothers took home an award at the 2014 SEMA Show for the 1966 Chevrolet Chevelle it named Recoil, and now the car has proven it can do more than just look good on Jay Leno's Garage. While the latest guest might look vintage, underneath those classic lines is a thoroughly modern muscle car sporting a claimed 980 horsepower. The heart of this beast is a supercharged LS7 V8 from Wegner Motorsports and a six-speed Tremec manual gearbox. Even with so much power, it can still run on 91-octane pump gas, and when Jay gets on the throttle the result is a wall of sound from the wailing supercharger. Despite the muscle, the Recoil doesn't really scream about its performance aesthetically. The color is a surprisingly plain beige, but the carbon fiber touches and side exhaust certainly indicate that there's something special here. The owner's sole request for the car was to include metal seats, and Ringbrothers provided them with a few bits of leather offering a touch of comfort. After checking the Recoil out from stem to stern, Leno finally gets behind the wheel and treats our ears to pull after pull from that big, supercharged V8.