Find or Sell Used Cars, Trucks, and SUVs in USA

1957 Chevrolet Bel Air 4-door 150/210 Chevy Belair Custom Restored on 2040-cars

Year:1957 Mileage:2500 Color: Black /
 Red
Location:

Richmond, Virginia, United States

Richmond, Virginia, United States
Advertising:
Transmission:350 power glide
Body Type:Sedan
Vehicle Title:Clear
Engine:400 small block
Fuel Type:GAS
For Sale By:Private Seller
VIN: B57T249571 Year: 1957
Number of Cylinders: 8
Make: Chevrolet
Model: Bel Air/150/210
Trim: chrome
Options: CD Player
Drive Type: automatic
Power Options: Power Locks
Mileage: 2,500
Exterior Color: Black
Interior Color: Red
Warranty: Vehicle does NOT have an existing warranty
Condition: UsedA vehicle is considered used if it has been registered and issued a title. Used vehicles have had at least one previous owner. The condition of the exterior, interior and engine can vary depending on the vehicle's history. See the seller's listing for full details and description of any imperfections.Seller Notes:"Minimal rust on chrome, small pops in paint, and driver side doors are starting to show signs of rust (pictured). Alarm system is currently not working (checking for wiring issue)and remote car locks sometimes do not work"

 I am the third owner of this 1957 Chevy Bel Air and have owned it since 2005. I have most of the work history paperwork for the past 10 years. Car has custom interior including trunk with slight fading in the rear window section. I had the car in storage for aprox 3 years and recently pulled it out. I have done aprox $2,500 worth of work to get it running and top notch mechanical shape including new carburetor, new master cylinders on all 4 brakes, and replaced most/all bushings. Floor is intact and to my knowledge the frame and body are all original.

Car runs great and gets lots of attention on the street. There are minor rust spots on the chrome and a few spots starting to show through the paint (fewer than 5 spots and very small). The driver side doors are beginning to show signs of minor rust also - likely due to door seals needing to be replaced.

Details:

  • Engine: 400 small block (less than 2,000 miles on rebuilt engine)
  • Trans: 350 power glide (shifter moved to floor)
  • Edelbrock carburetor
  • custom interior including trunk
  • cd player stereo w/ ipod adapter in glove box
  • original dash, dials, and gauges
  • new exhaust (2009)
  • alarm and power locks added (currently not working. I believe there is a short or cut wire to be found)
  • new tires including spare
  • Crager Wheels
  • Drum brakes w power booster

There is no warranty or returns on this purchase.
Buyer is responsible for shipping.



Auto Services in Virginia

Z Auto Body ★★★★★

Automobile Body Repairing & Painting, Car Wash
Address: 14049 Willard Rd, Clifton
Phone: (703) 802-3344

Wooddale Automotive Specialist ★★★★★

Auto Repair & Service
Address: 1051 Cannons Ct, Kingstowne
Phone: (703) 490-3319

White Tire Distributors ★★★★★

Auto Repair & Service, Tire Dealers, Brake Repair
Address: 1513 Seibel Dr NE, Hollins-College
Phone: (540) 342-3183

Vega MotorSport Window Tinting & Detailing ★★★★★

Auto Repair & Service, Automobile Parts & Supplies, Car Washing & Polishing Equipment & Supplies
Address: 11750 Pika Dr, Engleside
Phone: (301) 932-8342

Tysinger Motor Co., Inc. ★★★★★

Auto Repair & Service, New Car Dealers, Used Car Dealers
Address: 2712 Magruder Blvd, Sussex
Phone: (757) 865-8000

The Body Works of VA INC ★★★★★

Auto Repair & Service, Automobile Body Repairing & Painting, Automobile Parts & Supplies
Address: Belleview
Phone: (703) 777-5727

Auto blog

Next-gen Chevy Silverado and GMC Sierra may use carbon fiber

Thu, Dec 7 2017

It's been generally accepted that the next generation of full-size GM trucks will use some sort of strong, lightweight material for the beds while retaining steel for the cab. While aluminum seems like the most obvious choice, according to Automotive News, the Chevy Silverado and GMC Sierra will incorporate both aluminum and carbon fiber in their beds. The publication cites sources from within GM, though it seems the introduction of this comparatively exotic material mix is still a few years off. While carbon fiber is both stronger and lighter than steel and aluminum, it takes significantly more time and money to produce, essentially relegating the material to small-volume cars. The main benefit for trucks is the resulting reduction in weight to improve fuel economy without sacrificing the tough, rugged capabilities truck buyers expect. The Ford F-150 made the switch to aluminum for the 2015 model year and it's proved highly successful. It seemed like it was only a matter of time before the competition followed suit. Automotive News says that the next-gen trucks will launch with aluminum beds and that it will take a couple of years before we'll see any carbon fiber incorporated into the design. Even then, only look for the composite material on higher-trim models, with a trickle down to lower-spec trucks possible further in the future. In 2011, GM announced it was working with Japan-based Teijin Limited on a carbon fiber reinforced thermoplastic. There's a good chance that material's introduction will be on trucks. Related Video: News Source: Automotive News Plants/Manufacturing Rumormill Chevrolet GM GMC Truck

First 2014 Chevy Corvette Stingray spotted crashed in the wild

Tue, 12 Feb 2013

This restyled blue 2014 Chevrolet Corvette Stingray is wearing manufacturer plates, and it appears to be the same one seen around the internet in various pictures lately. This crash is likely not part of the Chevrolet testing regimen, however. Digital Corvettes forum member gpetry posted the shot with a note: "got this picture e-mailed from a friend in Arizona last week..." No circumstances are given, other than the incident occurred in the thick of a set of curvy roads, and the coupe ping-ponged off a guardrail and into the rock wall. Hopefully everyone involved in the incident walked away.
It may not be a pretty thing to see, a crashed sports car that's not even available for sale yet, but rest easy. Many pre-production cars are used for development and then unceremoniously crushed and scrapped, anyway. If that's the case here, that makes this wrecked 'Vette less of a tragedy and more of a case of exceptional efficiency.

GM's labor deal with UAW union on verge of ratification

Thu, Nov 16 2023

Nov 15 (Reuters) - General Motors' tentative labor deal with the United Auto Workers (UAW) union closed in on ratification as the votes were counted on Wednesday. Following the approval earlier in the day by more than 60% of union members at the Detroit automaker's large Arlington, Texas, assembly plant, additional votes in favor have the deal close to clinching majority approval. The number of union locals, most of which are smaller, still to report vote totals is not large. After several large assembly plants voted against the deal earlier on Wednesday, some media had reported the deal was heading toward failure. But Arlington's support, followed by strong voting in favor by smaller warehouse and parts facilities, has put the deal on the brink of approval. This would mark the first ratification of a deal, which runs through April 2028, with one of the Detroit Three automakers. Ford and Stellantis voting is still under way, and workers at both companies were favoring ratification by comfortable margins. The UAW's GM vote tracking site currently shows approval of the contract leading by a 54% to 46% margin with almost 32,000 workers having cast votes out of about 46,000 UAW-represented GM workers. The Arlington plant, with about 5,000 UAW members, has the most of any GM plant. Voting officially ends on Thursday at 4 p.m. EST, although most votes will be cast on Wednesday. The UAW went on strike for more than six weeks against the Detroit Three, seeking better wages, working conditions and cost-of-living adjustments. All three companies agreed to tentative agreements about two weeks ago. Workers at other GM assembly plants voted against the deal, including 60% of workers at its Fort Wayne, Indiana, truck plant, 53% at its Wentzville, Missouri, plant, 58% of workers at GM's Lansing Grand River plant and 61% of workers at the Lansing Delta Township plant. Seven of GM's 11 assembly plants rejected the deal. In addition to Arlington, workers at plants in Detroit, Fairfax, Kansas; and Lake Orion, Michigan; approved the agreement. Only nine facilities are still listed without vote totals on the UAW vote tracker, including GM's Lockport, New York, components plant with about 1,200 members. Those voting in favor of the agreement have a lead of almost 2,500 and many of the facilities still to come include workers who stand to receive large pay increases upon ratification.