1955 Chevrolet Belair 150/210 2-door - 265 V-8 Engine on 2040-cars

Auto blog

NHTSA investigating nearly 750,000 GM models over non-deploying airbags

Nearly 750,000 vehicles built by Chevrolet, GMC, and Cadillac are the subject of a National Highway Traffic Safety Administration (NHTSA) investigation due to non-deploying driver-side airbags. While the investigation is ongoing, the agency believes the issue is likely due to rust particles that form on the inflator's connection terminal interface. The list of nameplates included in the investigation includes Chevrolet's Silverado, Tahoe, and Suburban, GMC's Sierra, Yukon, and Yukon XL, plus Cadillac's Escalade, Escalade ESV, CT4, CT5, and XT4. All of the potentially affected vehicles are 2020 or 2021 models, according to a bulletin published on the NHTSA's website. Investigators launched the probe in April 2021 after 15 consumers reported airbag-related issues, including nine who said an airbag malfunction light appeared in the instrument cluster. More alarmingly, the NHTSA is aware of six accidents that caused significant damage to the car's front end yet didn't trigger the driver's airbag. It adds that there are no fatalities linked to the issue, but there are six crashes and eight injuries reportedly blamed on it. No evidence suggests this problem is related to the millions of potentially deadly Takata inflators recalled over the past few years. General Motors is aware of the defect. It sent a technical service bulletin (TSB) to its dealers in March 2021 to address the aforementioned warning light. The note explains the issue is due to "rust particles in the connection terminal interface of the driver's airbag inflator." The company hasn't issued a safety recall yet, however. Whether it will partially depends on the NHTSA's findings. It's currently looking into the scope and the severity of the problem, and it wants to understand its implications on driver safety. Investigators will decide whether General Motors needs to recall the 749,312 cars that are part of the probe when they close their investigation. General Motors has already spent a significant amount of money replacing defective airbag-related parts in its cars. In November 2020, it was ordered by the American government to recall nearly 6 million pickup trucks and SUVs equipped with potentially dangerous Takata airbag inflators. It repeatedly argued that testing proved the inflators were safe, and it petitioned the agency four times starting in 2016 to avoid a recall, which cost an estimated $1.2 billion (about a third of its net income in 2020).

2016 Camaro gets most revealing tease yet

Chevrolet started its long teaser campaign for the 2016 Camaro by just revealing the exhaust manifold and front frame, but as time has passed the company has slowly unveiled more. In the latest glimpse ahead of the pony car's May 16 debut, we're actually getting to see the model's profile completely undisguised. As suggested by the recent tease of the rear and hood, the 2016 Camaro wears a sharper, more angular design than the current model. This is especially the case when you look at the taut lines making up the rear. Chevy claims that the new shape underwent 350 hours of wind tunnel tests to be able to generate left lift, improve cooling and reduce wind noise in the cabin. A smooth underbody pan is among the aerodynamic tweaks, and it runs from underneath the front grille to the center of the Camaro. Chevy asserts that all of the changes at the front help reduce lift by 30 percent. Related VIdeo: 2016 Camaro is all about the Aero Total aerodynamic lift improved by 30 percent for improved stability 2015-05-11 DETROIT – After 350 hours of wind tunnel testing – often 24 hours a day – the new Camaro will slip more easily through the wind, and drivers of the Camaro SS will experience a marked improvement in reduced aerodynamic lift. These changes illustrate the lengths the aerodynamics team went to for improved performance, stability, cooling and lower wind noise intrusion "The importance of aerodynamics increases exponentially as we increase vehicle performance," said Kirk Bennion, Exterior Design manager. "As engine output increases, we need more engine cooling. As acceleration and top speeds climb, we need to reduce lift for better high-speed stability. However, we cannot make any changes at the expense of increasing drag, which can hurt fuel economy. "To balance these different aerodynamic targets, we tested literally hundreds of changes on the new Camaro, millimeters at a time." For example, the initial design called for the lower grille bars to be set at a 20-degree angle to the horizon. However, after meticulous testing, the team improved engine-cooling airflow by 1 percent by shifting the angle to 13 degrees – a change that achieved the airflow target while maintaining the original grille design. And rather than a traditional front air dam to reduce aerodynamic lift, the team developed a flush belly pan that stretches from the front grille to the center of the vehicle.

Here's why automakers roll out those Texas-themed pickup trucks

Every year, automakers with a full-size truck link make a big show of the Texas State Fair, usually involving a reveal of a new model. Sometimes they show a whole new truck, and other times a special edition centered on the Lone Star state. While some people might write this off as a quirk of the industry, others might be wondering, "What's the big deal with Texas?" As it turns out, part of the big deal with Texas is big truck sales. According to Dave Sullivan, product analysis manager at AutoPacific, Texas buys more trucks than any other state in the country. It's not a small margin either. Edmunds.com, one in five trucks sold in the US are sold in Texas. The state also accounts for 15 percent of the country's large truck sales, which is more than twice that of California, the second largest truck market in America. Even when you break down sales only in Texas, trucks are a huge piece of the pie - Sullivan says that a quarter of new vehicle sales in Texas are trucks. One in five trucks sold in the US are sold in Texas. But it's not just sales that make truck builders give attention to Texas. As Sullivan explained, "Pickups are life in Texas." Both he and Hugh Milne, marketing and advertising manager for the Chevy Silverado line, said that trucks are key fixtures in Texas society, as both work trucks and luxury vehicles (or Texas Cadillacs as Milne called them). Milne said Texas is so important in the truck market that if you want to be successful in the rest of the country, "you've got to be successful in Texas." As for the State Fair, it has become a prime location for reveals in part because of the importance of the Texas market and because of how big the fair is. Milne also revealed that the State Fair also hosts its own auto show, so it's an ideal venue for a vehicle introduction. So there you have it. Why do truck builders obsess over Texas? It's because Texas obsesses over trucks. When you have one market that loves your product that much, you give it the attention it deserves. Related Video: Image Credit: Donovan Reese via Getty Images Auto News Marketing/Advertising Chevrolet Ford RAM Truck f-150 texas state fair