1954 Chevy 2 Door Sedan - Camaro Subframe 350 Small Block Auto Trans on 2040-cars
Conway, Missouri, United States
Vehicle Title:Clear
Used
Make: Chevrolet
Model: Bel Air/150/210
Drive Type: Automatic
Year: 1954
Mileage: 5,555
Trim: Belair
Up for auction is a 1954 Chevrolet 2 door Sedan with a Camaro front Subframe with power steering and power disc brakes. It also has a Camaro 10 bolt rear end installed. The engine is believed to be a 350 Chevy with an Automatic trans bolted to it. It has a set of Rally wheels on it, a couple tires will go down after a while. The engine and trans are mounted but nothing is hooked up. The body has rust, dents, and dings. The floor pans are the worst. The glass is all there. I have a title for it. This car is a project and will need to be towed or hauled from here. Thanks for looking.
|
Chevrolet Bel Air/150/210 for Sale
1955 chevrolet bel air coupe resto mod(US $37,000.00)
1956 chevy bel air 2-door hardtop tropical turquoise beautifully restored
Older resto that's held up very well, 283 ci v8, 4bbl, auto, continental kit!!(US $35,995.00)
1956 chevy belair 2dr hard top(US $41,000.00)
1957 chevy 210 post low reserve
1956 chevrolet bel air sport coupe
Auto Services in Missouri
Warehouse Tire & Muffler ★★★★★
Uptown Auto Sales ★★★★★
Toyota Of West Plains ★★★★★
T & B Auto ★★★★★
Springfield Freightliner Sales ★★★★★
Spectrum Glass Inc ★★★★★
Auto blog
GM reintroduces Tripower name in the worst way possible
Wed, Aug 1 2018The story of General Motors' use of the Tripower moniker begins way back in 1957, when Semon E. "Bunkie" Knudsen, then General Manager of GM's Pontiac division, directed his engineers to inject more performance into his brand's line of V8-powered automobiles. Fuel injection was an option, but hot rodders flocked instead to Tri-Power (marketed way back when with a hyphen), which grafted a trio of two-barrel Rochester carburetors onto a single intake manifold. A legend was born. And that legend was born of performance. At idle and when full power wasn't required, Pontiac's Tri-Power system used just the middle carburetor, which helped make the setup easier to tune. Depending on the year and model, either a vacuum system or a mechanical linkage opened up the two outer carbs, thereby switching from two barrels to six, and allowing the engine to take in more fuel and air. And it was an easy marketing win – six barrels is better than four barrels, right? Because performance! So, when news filtered in that GM has resurrected the Tripower name, those of us who grew up attending classic car shows and wrenching on old Pontiacs did a double-take. And then we all collectively sighed. Turns out that today's Tripower refers to a trio of fuel-saving measures that include cylinder deactivation, active thermal management, and intake valve lift control, according to Automotive News. And, at least for now, it applies to GM's line of fullsize trucks powered by a 2.7-liter turbocharged four-cylinder engine. We're all for saving fuel whenever possible. And we have zero say in how any automaker chooses to market its products and technologies. But, we'll offer our two cents anyway: Relaunching a storied name from the past is fine. Relaunching a storied name from the past while completely overlooking the reasons the name got famous in the first place is only going to irritate the people who remember the name in the first place. Couldn't they just call this new technology package something else? Related Video: News Source: Automotive NewsImage Credit: Getty Green Marketing/Advertising Chevrolet GM Pontiac Automotive History Truck chevrolet silverado
GM raises 2023 guidance on strong sales, higher profits
Tue, Apr 25 2023General Motors beat first-quarter profit estimates and raised its full-year earnings and cash-flow guidance after vehicle demand at the start of the year surpassed expectations. Its shares rose in premarket trading. GM made $2.21 a share in adjusted profit in the first quarter, compared to a consensus forecast of $1.72 a share. Revenue rose 11% to $39.99 billion, it said Tuesday, which was more than the $39.24 billion analysts expected. The stronger results stem from rising sales in the US, even in the face of higher interest rates and inflation. GM executives said demand was strong enough to revise 2023 guidance upward, boosting profit estimates for the year by $500 million to between $11 billion and $13 billion. “We did it with strong production and inventory discipline and consistent pricing,” GM Chief Financial Officer Paul Jacobson said on a call with journalists. “All in all, weÂ’re feeling confident about 2023.” The Detroit automaker raised per-share full-year guidance to between $6.35 and $7.35, up from $6 to $7 a share, and said free cash flow would also increase by $500 million to a range of $5.5 billion to $7.5 billion. GMÂ’s shares pared a gain of as much as 4.4% before the start of regular trading Tuesday, rising 3.5% to $35.50 as of 6:55 a.m. in New York. The stock was up 1.9% for the year as of the close on Monday. North American Strength The automakerÂ’s sales were particularly strong in North America, where first-quarter earnings rose before interest and taxes rose to $3.6 billion. Vehicle sales rose 18% to 707,000 in the region. Jacobson said the company originally expected to sell 15 million vehicles in the US this year, slightly less than the 15.5 million annualized rate automakers foresaw in the first quarter. North American demand was enough to offset a weak performance in China, GMÂ’s second-largest market. The automaker continues to struggle in the country, where its vehicle sales fell 25% to 462,000 vehicles in the quarter. Profits from its joint ventures in the market slumped 65% to $83 million. The market has struggled overall in the wake of Covid-19 restrictions and foreign automakers have had to overcome a growing preference for Chinese brands by competing on price, squeezing profit margins. The situation in China probably wonÂ’t significantly improve until the second half of the year, according to Jacobson. GM remains on target to sell 150,000 electric vehicles this year, the CFO said.
A conversation with GM's Mark Reuss on MPG, aluminum and Corvettes
Wed, Feb 19 2014There was plenty to talk about when General Motors hosted its annual mid-December holiday media reception a few months ago. GM had just decided to pull its global Chevrolet brand out of major European markets, where Chevys have competed directly with GM Europe Opel and Vauxhall vehicles, and the US government had sold its last remaining shares of GM stock. But most important was the company's just-reshuffled leadership. Post-bankruptcy CEO Dan Akerson had announced that he would step aside and that 52-year-old Mary Barra would replace him on January 15. Not only would she be the first woman to lead a major automaker, she would also be GM's first engineer CEO since Bob Stempel in the early 1990s. "I look at 2013 and 2014, as the retooling of General Motors" - Mark Reuss Replacing her as executive VP for global product development (and purchasing and supply chain) would be 49-year-old Mark Reuss, who had served a stellar four years as North American president, and elevated to corporate president (from executive VP and CFO) would be 42-year-old Dan Amman. All three are relatively young auto enthusiasts who are liked and respected inside and outside the company, and their collective talents and experience are highly complementary. I've interviewed Barra and found her smart, personable and knowledgeable, though she carefully walks the corporate line in speaking and answering questions. I met and chatted with Ammann for the first time at that holiday reception, and he made a good first impression. But I've known Reuss for some time as a genuinely good guy and a highly capable and inspiring leader, and I believe he is exactly the right person for the global product responsibility once famously held by the outspoken, oft-controversial Bob Lutz. So I jumped at an opportunity to join a group interview of Reuss (with mostly business reporters) at the Detroit Auto Show in January. It was an interesting session of mostly good questions, which he answered with refreshing candor and humor. "I look at 2013 and 2014, as the retooling of General Motors," Reuss said. "We've taken down almost every plant in North America, converted and turned it this last year, and to do that with award-winning vehicles and pretty flawless launches is key. We have to keep the train rolling on great product, because the rest won't happen without the best product, period." A reporter asked whether GM was pushing big trucks, SUVs and Corvettes again because gas is cheap. "No," Reuss said.
2040Cars.com © 2012-2025. All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.
Use of this Web site constitutes acceptance of the 2040Cars User Agreement and Privacy Policy.
0.279 s, 7903 u