2004 Cadillac Escalade Esv 04 Escalade on 2040-cars

Auto blog

Junkyard Gem: 1967 Cadillac Fleetwood Sixty Special Sedan

If you lived in North America in 1967 and you wanted to show the neighbors you'd clawed your way to the peak of the success pyramid, only one car would do: Cadillac Fleetwood. Today's Junkyard Gem is 4,685 pounds of General Motors luxury hardware, finally knocked off the road at age 53 by an unfortunate wreck and now residing in a Denver self-service wrecking yard. The Cadillac brand endured some rough years during the 1970s and 1980s, but rode high during the 1960s. The Fleetwood Sixty Special Sedan started at $6,423 in 1967, or just over $50,000 when figured using inflation-adjusted 2020 dollars. A Mercedes-Benz 250SE sedan set you back $6,385 that year, but it weighed barely half as much and packed just 148 horses against the Cad's 340. Really, you had to get a genuine Rolls-Royce to out-swank the Fleetwood-driving Joneses back then (the Lincoln Continental and Imperial didn't have quite the snob appeal at that time), and the Roller cost more than several Fleetwoods combined. This car has been around during its long life. On the windshield, we see 1980 and 1981 parking stickers from the Keeneland Club in Kentucky. This car was already 13 years old by that time, but still very classy. At some point, the car must have migrated to California. Here's a U.C. Berkeley sticker. This ancient In-N-Out sticker comes from the Southern California-only era of the famous hamburger chain. Sometimes it's tough to determine the reasons that an old car ended up in a place like this, but that's not a problem here. Let's hope the car's occupants had their belts on (lap belts only in 1967, but still better than nothing), because these old Detroit land yachts didn't have much in the way of energy-absorbing crumple zones. The paint and interior are quite rough, so this car depreciated from being worth perhaps a couple of grand to scrap value in an instant.  Cruise control was a very rare option in 1967, and this car has it. The famous Fleetwood triple-tone horns were still there when I got to this car. Under the hood, 429 cubic inches (7.0 liters) of super-smooth Cadillac pushrod V8. This engine grew to 472 and then 500 cubic inches during the following few years. The paint shows some great patina. Did I buy the horns? Of course I bought the horns — I always bring my trusty lightweight junkyard toolbox when I head out to shoot some Junkyard Gems. Related Video:

NHTSA investigating nearly 750,000 GM models over non-deploying airbags

Nearly 750,000 vehicles built by Chevrolet, GMC, and Cadillac are the subject of a National Highway Traffic Safety Administration (NHTSA) investigation due to non-deploying driver-side airbags. While the investigation is ongoing, the agency believes the issue is likely due to rust particles that form on the inflator's connection terminal interface. The list of nameplates included in the investigation includes Chevrolet's Silverado, Tahoe, and Suburban, GMC's Sierra, Yukon, and Yukon XL, plus Cadillac's Escalade, Escalade ESV, CT4, CT5, and XT4. All of the potentially affected vehicles are 2020 or 2021 models, according to a bulletin published on the NHTSA's website. Investigators launched the probe in April 2021 after 15 consumers reported airbag-related issues, including nine who said an airbag malfunction light appeared in the instrument cluster. More alarmingly, the NHTSA is aware of six accidents that caused significant damage to the car's front end yet didn't trigger the driver's airbag. It adds that there are no fatalities linked to the issue, but there are six crashes and eight injuries reportedly blamed on it. No evidence suggests this problem is related to the millions of potentially deadly Takata inflators recalled over the past few years. General Motors is aware of the defect. It sent a technical service bulletin (TSB) to its dealers in March 2021 to address the aforementioned warning light. The note explains the issue is due to "rust particles in the connection terminal interface of the driver's airbag inflator." The company hasn't issued a safety recall yet, however. Whether it will partially depends on the NHTSA's findings. It's currently looking into the scope and the severity of the problem, and it wants to understand its implications on driver safety. Investigators will decide whether General Motors needs to recall the 749,312 cars that are part of the probe when they close their investigation. General Motors has already spent a significant amount of money replacing defective airbag-related parts in its cars. In November 2020, it was ordered by the American government to recall nearly 6 million pickup trucks and SUVs equipped with potentially dangerous Takata airbag inflators. It repeatedly argued that testing proved the inflators were safe, and it petitioned the agency four times starting in 2016 to avoid a recall, which cost an estimated $1.2 billion (about a third of its net income in 2020).

Cadillac's striking Escala concept is reportedly headed for production

Cadillac is reportedly planning a new flagship four-door, and it won't be based on its alphanumeric naming system a la the CT6. It'll be the Escala, the stunning concept fastback it revealed in 2016 in Pebble Beach. The news comes via Autoline, which cites AutoForecast Solutions. The Escala is said to be planned for production starting in December 2021 at GM's Detroit-Hamtramck plant, which currently builds the CT6, Buick LaCrosse and Chevrolet Volt and Impala. That suggests the Escala, which was branded as a four-door coupe, will likely keep that layout. It'll also be built on the CT6 platform. Cadillac has been talking about fitting a flagship sedan above the CT6 for years, and the Escala's design language has been influencing bits of other Cadillac models, from the refresh of the CT6 to the broad grille shape on the new XT4 crossover, which debuts at the New York Auto Show next week. The concept Escala featured a wide, muscular stance and a minimalist, white mid-century modern interior aesthetic, with tail lamps that evoke waterfowl in flight. Interestingly, it came equipped with a 4.2-liter twin-turbo V8 with cylinder deactivation, which Cadillac President Johan De Nysschen said at the time was "absolutely worthy of a car of this caliber." But with such a long horizon before production, there's obviously lots of time to develop a more pragmatic production model and cue ravenous speculation. Or, for that matter, to decide to rename it something like the CT8. Related Video: Featured Gallery Cadillac Escala Concept View 33 Photos Image Credit: Jeff Jablansky Design/Style Cadillac Coupe Concept Cars Luxury Sedan cadillac ct6 cadillac xt4 cadillac escala