1972 Coupe Deville Cadillac on 2040-cars

Auto blog

2020 Cadillac CT5 debuts at N.Y. Auto Show as a proper sport sedan

The 2019 Cadillac CT5 is here, and it's not a tweener sedan. After having done battle with the luxury sedan world through cars that were either too large or too small, Cadillac is using the CT5 to take direct aim at the BMW 3 Series, Audi A4, Alfa Romeo Giulia and Mercedes C-Class. Specifically, the CT5 replaces the CTS, but takes on vehicles one class smaller than what the CTS did. So, let's take a look at what Cadillac is bringing to the table. To begin, GM knows it has a winner on its hands with the Alpha platform used on the CTS and ATS and the Camaro, so engineers adapted it to the CT5. This seems like a great start, because we all happen to love the driving dynamics from vehicles on this chassis. The wheelbase is a couple inches longer than the CTS, but the CT5 is a couple inches shorter in overall length. As a result, the wheels get pushed toward the corners of the car, leaving the CT5 with relatively short overhangs in the front and rear. It looks different than both of the to-be-discontinued Cadillac sedans, but we wouldn't call it revolutionary. The rear end isn't quite a "sportback," but it's a "faster" shape, eschewing a traditional sedan's long decklid for a sloping-roof look instead. This shape does come at the expense of rear seat headroom, but we'll dive into the interior later. We got a little preview of the powertrain setup before this official reveal, but details were scarce. The base engine is the recently new 2.0-liter turbo four-cylinder found in the Cadillac XT4. Just as it did in that vehicle, this engine makes 237 horsepower and 258 pound-feet of torque. While it might be down on power compared to the old 2.0-liter in the ATS (272 horsepower and 295 pound-feet) we found it to be incredibly smooth, refined and not lacking in thrust compared to the old unit. We're sure the four-pot will offer sufficient power for the CT5, but the 3.0-liter twin-turbo V6 is lying in wait. This engine makes 335 horsepower and 400 pound-feet of torque. Both engines are paired to a 10-speed automatic transmission and can be had in rear-wheel drive or all-wheel drive in every configuration. So yes, you can get the V6 with rear-wheel drive, thankfully. Cylinder deactivation is also equipped to both these power units — the four-banger is able to run on two cylinders, while the V6 drops to four. Cadillac was entirely transparent about its new pumped-in engine sound strategy, too.

[UPDATE] Cadillac Blackwing gets ticket to Italy, to go to work in a supercar

UPDATE: It seems MAT's belief it had secured a supply of Cadillac's 4.2-liter Blackwing V8 was premature, and based on a handshake deal before GM sold its Turin engine center to Italy's Punch Group. Shortly after Hagerty ran the story, GM sent a statement to the outlet reading, in part, "We do not have an agreement in place with Manifattura Automobili Torino (MAT) to provide or sell the Blackwing engine. ... Our team is following up with MAT president Paolo Garella to discuss the misunderstanding." MAT also submitted a statement to Hagerty, saying, in part, "We thank GM for the clarification. Although a signed agreement was not finalized between the parties, we were under the impression that our counterpart was committing to making this engine available to MAT at conditions yet to be defined. ... We hope that this misunderstanding will not compromise our relations with GM and possible future collaborations." The original article follows: Some necessary cost-cutting at Cadillac led to switching the new CT4, CT5, and Escalade to older platforms. The revised architecture plan meant Cadillac's newest top-tier products couldn't fit Cadillac's newest top-tier engine, the 4.2-liter twin-turbo DOHC V8 known as Blackwing. That engine would serve limited duty at full power in the now-dead CT6-V, and at reduced output in the CT6 Platinum V8 trim before ending its bright, brief domestic life. But the story isn't over, the rebirth of Blackwing coming from a most surprising locale: Turin, Italy. Before the canceled Geneva Motor Show, Hagerty spoke to Paolo Garella, CEO of Manifattura Automobili Torino; that's the company better known as MAT, makers of the New Stratos and contract engineering house for boutique screamers like the Aspark Owl electric hypercar, Apollo Intensa Emozione, and SCG003C. Garella told the outlet, "We have an agreement with General Motors" for a supply of Blackwings, which would be developed and built at the General Motors Propulsion Engineering Center (PEC) in Turin. Since 2005, the PEC has been used to develop GM's global diesel engines and electronics. MAT's plan is to put the V8 into a new limited-run car MAT is creating from its own design. Then another surprising turn: Belgium-based global auto supplier Punch Group bought the PEC, with plans to work with GM on projects in progress until at least the end of 2021. Nothing changes as far as MAT is concerned, except perhaps a chance for an even closer collaboration with Punch Turin.

Cadillac to bolster CT sedans with XT crossovers

Cadillac is moving swiftly to change up its naming scheme. Barely over a week ago we received our first indication that it was considering a different name its the upcoming flagship sedan previously known as LTS. Then Cadillac not only revealed the model would be called CT6, but announced that it would set the stage with a massive overhaul of its model nomenclature. And now we have another piece of the puzzle.
According to Forbes, Cadillac will not only rename its sedans with the letters CT, but will realign its utility vehicles under the banner of XT - both to be followed by a number indicating its place in the lineup. The one exception will be the Escalade, whose nameplate has such a strong following that it would be foolish for Cadillac to cast it aside. That leaves only the SRX (pictured above), but makes room for a new crop of crossovers said to be in the works.
It's a similar approach which Cadillac's new boss Johan de Nysschen took in revising the naming scheme at Infiniti. While it's bound to ruffle some feathers and scratch some heads in the beginning - especially since the company's current flagship sedan is called XTS - it's equally sure to make sense of it all in the long run. All we need to know now is what Nysschen and his marketing chief Uwe Ellinghaus plan to call the coupes.