2012 Cadillac Cts-v Wagon Recaro Seats Pano Sunroof Nav Texas Direct Auto on 2040-cars

Auto blog

Cadillac recalls 17,500 SRX CUVs in Canada

When reporting on recalls, Autoblog generally tries to focus on the US market. However, a recent campaign in Canada seems important enough to be worth mentioning because it could eventually affect American drivers. General Motors is repairing 17,481 Canadian examples of the Cadillac SRX from the 2010-2015 model years because of the possibility of a loose nut in the rear suspension. For the moment, the automaker hasn't yet announced whether the CUV in the US would require a similar campaign.
The notice was dated September 18, 2014, on the website for Transport Canada, similar to the National Highway Traffic Safety Administration in the US. It says, "the rear suspension toe link jam nuts" might not have been sufficiency tightened, which could allow a rear wheel to turn "inboard or outboard" while driving. If this happens, it could cause a sudden change in handling. Canadian Cadillac dealers are inspecting the parts and replacing the toe link if necessary.
This campaign isn't listed on the GM's running recall tally from September, which includes exported models, but it does list four other campaigns for the SRX this year - three in this range of years and one for the 2004-2006 model. Autoblog reached out to the company to ask about the possibility of this recall expanding to the US and were told "We have not publicly announced US recalls" for the issues affecting the SRX. The New York Times was given a similar quote. Scroll down to read the notice from Transport Canada.

GM recalling 54k Cadillac SRX, HD pickup models

There are more recalls to report General Motors, but these latest actions pertain to newer examples of the Cadillac SRX, Chevrolet Silverado HD and GMC Sierra HD. With so much scrutiny on the company's recall strategy, GM is under increasing pressure to call in defective models more quickly, and it appears to be doing so here.
Here in the US, the automaker is recalling 50,571 Cadillac SRX crossovers from the 2013 model year fitted with the 3.6-liter V6 because the transmission control module programming can cause a three- or four-second lag in acceleration at low speeds. The explanation filed with the National Highway Traffic Safety Administration states, "if the following sequence occurs within two seconds: during an upshift from first to second gear (8-10 mph), the driver then brakes the vehicle to less than 5 mph, and then accelerates again," the delay can occur. According to Automotive News, the recall effects 56,400 vehicles worldwide, and the company is not aware of any crashes caused by the problem. The fix consists of a transmission control module (TCM) reflash.
In a separate recall, GM is repairing 51 Chevrolet Silverado HD and GMC Sierra HD pickups from the 2015 model year in the US. In vehicles with diesel engines and dual fuel tanks, the nuts that connect the fuel pipe to each side of the transfer pump between the tanks may be improperly torqued, which could cause a fuel leak. Obviously, this could be a fire hazard. The remedy is simply tightening the hardware. According to GM spokesperson Alan Adler, there have been no fires actually caused by the potential leak. "Only 21 of the trucks are in customer possession and they can be fixed anytime because there are no parts involved. The others are being fixed at dealerships," Adler said in an email to Autoblog.

Cadillac adds torque-number badging to most new models starting in 2020

Few phrases describe huge swaths of America better than a phrase spotted on the back of a top-fuel dragster at an NHRA event: "You can never have too much horsepower or ammunition." If Cadillac CEO and wily Canuck Steve Carlisle has his way, the revised phrase would substitute "torque measured in Newton-meters" for "horsepower." Starting with the 2020 model year, America's luxury brand will add torque figure badges to CT and XT models, beginning with the XT6. The badge above kinda almost sorta represents the torque produced by the luxury crossover's 3.6-liter V6. That badge did not appear on the XT6 we photographed at the Detroit Auto Show. In U.S. parlance, twist in the XT6 comes to 271 pound-feet. Translated to Newton-meters, that's 367 Nm. Then round that up to the nearest 50, which Cadillac will do, and one arrives at 400. True, the rounding prevents a future of number jumbles like the 2020 XT6 367 vs. the 2021 XT6 419T. Nevertheless, we don't know why Cadillac is rounding to the nearest 50 instead of the nearest 25, since 50 Nm is about 37 lb-ft and could conceal a decent torque increase between model years. A "T" denotes turbocharging, and we imagine there'll be designations for hybrids and electric cars. We think most modern attempts at engine-based nomenclatures soon get as complicated as ciphers or come unmoored from their original scheme. And based on our experience with The Average Car Buyer, they don't care. A bigger number, no matter what that number represents, means more, which is the important thing. Because America, right? Maybe not. Carlisle said, "We're not talking about displacements any more," and the new badging will give consumers "a clear understanding of the power differences across the lineup." The brand believes torque provides a better comparison between ICE, hybrid, and EV powertrains and "the balance between fuel economy and performance." As for the immigrant unit of measurement, Carlisle told CNET, " It's metric, it's universal, it's global, we have to think about all the markets that we're doing business in." Oh, and, "Engineers certainly prefer Newton-meters." The new nomenclature will not be applied to V-series models or the Escalade, because the CEO holds that "special cars get special names." We should probably take a moment to reassure the CT and XT models that Steve Carlisle thinks you're all special, too. Just a different kind of special.