Auto blog

Little-bit-bigger 2020 Buick Encore GX gets two three-cylinder engines

Ford broke the ice on selling three-cylinder engines in the U.S. with the 2014 Fiesta, then followed up with the EcoSport. Buick is about to widen that supermini-sized crack in the ice with the 2020 Encore GX. The semi-subcompact crossover will come in three trim levels that mix-and-match two turbocharged three-cylinder engines, two transmissions, and two drivetrains. The smaller engine is a 1.2-liter three-pot with 137 horsepower and 166 pound-feet of torque. This comes in one horse and 18 lb-ft of twist beyond the 1.4-liter four-cylinder in the smaller Encore. This engine will only be paired with a CVT and front-wheel drive in the Preferred, Select, and Essence trims. The meatier motor is a 1.3-liter three-cylinder with 155 hp and 174 lb-ft. That's down on the 163 hp and 177 lb-ft that the same engine produces in the Chinese-market version of the Encore GX. However, it gets buyers close to the 1.4-liter turbocharged four-cylinder that used to be optional on the smaller Encore, producing 153 hp and 177 lb-ft. This engine can be optioned on the front-wheel drive Select and Essence trims, where it would be mated to the CVT. The 1.3-liter three-cylinder is standard on all trims optioned with all-wheel drive, where it gets paired with GM's nine-speed automatic. GM does say the horsepower figures are estimates at the moment, so don't be surprised at any slight changes before deliveries begin next year. The Encore GX will serve buyers who would love it if the Encore had a bit more room but don't want to step up to the Envision. For a price GM hasn't announced yet, the Encore GX will reward those buyers with five more feet of cargo space, and some extra power for all those who decide to level up further. The junior Encore weighs just over 3,200 pounds, it's likely the Encore GX will shade that some. The Encore GX does ride on GM's new VSS-F platform, though, so the advanced architecture could provide an overall superior experience even with the lesser three-cylinder. GM has also said that the Encore GX will come standard with safety kit like forward collision alert and lane keep assist with a lane departure warning, features that are cost extras on the Encore. The Encore GX will also include automatic emergency braking, which can't be had on the Encore at any price.

Junkyard Gem: 1978 Buick Skylark Sedan

Around the time that OPEC shut off the oil taps, The General realized that it was time to sell more small cars from GM divisions not previously known for such machines. The logical candidate for this project was the Chevrolet Nova, a rear-wheel-drive compact that shared much of its chassis design with the Chevrolet Camaro and Pontiac Firebird. The Nova-based Pontiac Ventura came out in the 1971 model year, and the Buick and Oldsmobile Divisions began producing their own badge-engineered Nova siblings for 1973 (Cadillac was late to the party, but eventually created the Nova-based Seville for 1976). At first, the Buickized Nova got Apollo badges, but the better-known Skylark name was applied to these cars for the 1975 through 1979 model years. Today's Junkyard Gem is one of those Nova-based Skylarks, found in a Denver self-serve yard. From the 1964 through 1972 model years, the Skylark lived on the A-Body chassis and was sibling to the Chevrolet Chevelle/Malibu, Pontiac LeMans/Tempest/GTO, and Oldsmobile Cutlass/442. After the 1975-1979 rear-wheel-drive X-Body phase, the Skylark name then went onto the unrelated front-wheel-dive X-Body chassis developed for the Chevrolet Citation. It's a Nova, sure, but Buick made sure that it had a bit more swank than its Chevy counterpart. Checked seat fabric with big square buttons! The base engine in the '78 Skylark was the 3.8-liter Buick V6, rated at 110 horsepower. GM had invested in a new crankshaft design for this engine the year before, so it no longer had the "odd-fire" cut-down V8 crankshaft that shook the fillings out of so many drivers' teeth in earlier years. An assortment of low-compression V8s from Oldsmobile, Chevrolet, Pontiac, and Buick were available as optional equipment as well, eventually leading to the "Chevymobile" lawsuits of a few years later. The base transmission in this car was a three-speed manual (I'm not sure if you could still get a three-on-the-tree column-shift manual Skylark in 1978, but a three-on-the-floor manual was available for sure). The very last three-on-the-tree car Americans could buy was the '79 Nova and its Olds Omega/Pontiac Phoenix siblings, while the final three-on-the-floor cars were the '81 Malibu and siblings. This car has the optional three-speed automatic.

2024 Buick Envision previewed with new design, Super Cruise technology

The second-generation Buick Envision will enter the 2024 model year with an array of updates inside and out and Super Cruise hands-free technology. While the model won't make its full debut until later in 2023, an official preview image gives us a good idea of what to expect. Buick designers gave the Envision's front end a complete overhaul; this is not a subtle nip-and-tuck. The crossover gets a bigger grille positioned lower on the front fascia, bright trim, and the new Buick emblem on its hood. The headlights are now integrated into the bumper, Jeep Cherokee-style (or Citroen-style, depending on where your automotive references lie), and LED daytime running lights replace the outgoing Envision's headlights. The revamped look brings the Envision in line with other recent additions to the Buick range, like the Encore. We'll need to be patient to find out what the rear end looks like, though the overall proportions haven't significantly changed. Similarly, Buick hasn't released photos of the interior yet. We're guessing that infotainment- and trim-related changes will be part of the 2024 updates. The updated Envision will bring the Super Cruise technology already available in several General Motors products, including the Chevrolet Tahoe, to the Buick brand for the first time. Likely offered as an option with a four-digit price tag, the system will allow drivers to take both hands off the wheel when the right conditions are met; the car notably needs to be on a highway that General Motors has mapped. Super Cruise won't make the Envision autonomous, the driver will need to remain focused on the road ahead and ready to take over if needed, but it should make long trips less tiring. As of writing, General Motors has mapped over 400,000 miles of roads in the United States and Canada. Built in China, the 2024 Buick Envision will go on sale across the nation before the end of 2023. More details about it will emerge in the coming months. It's too early to tell what's next, but the company promised it will unveil two additional new vehicles before the end of 2024.