2011 Bentley Continental Flying Spur 4dr Sdn Speed Memory Seating Side Airbags on 2040-cars

Auto blog

2019 Bentley Continental GT: High fashion at its best

The new 2019 Bentley Continental GT has been revealed, and it is a stunner. It shows a healthy influence from the brand's recent show cars, especially the EXP 10 Speed 6. This is a very positive thing. Whereas the exterior of the second-generation car looked exactly like that of the first, the new car sports fresh surfacing that is at once more elegant and more athletic, while also delighting in technical detailing that deepens upon second and third glance. The styling of a six-figure, ultra-luxury Grand Tourer must evolve slowly for a number of reasons. Their wealthy buyers – looking for a prime valet spot at the country club more than at the night club – tend to be a bit more conservative in their tastes than those in the market for a knife-edged exotic. They also prefer their recently purchased six-figure, ultra-luxury Grand Tourer not to be rendered irrelevant in the status game by the introduction of a radically differentiated new model. This is especially true for Bentley and its Continental GT. This model, launched back in 2004, though tracing its roots back much further, brought the company's design out of the anachronistically (if delightfully) baroque and into the aerodynamically imposing modern era. It was the first true 21st century Bentley, decades ahead of the neoclassic design it replaced while faithfully harkening back to cues from the marque's venerable history, especially its long flanking body line, and conspicuous rear haunches. It immediately became Bentley's best seller, a position it has maintained until this year, when it's been outsold slightly by the gauche and indistinct Bentayga SUV. We believe this error will correct once the new GT is available. Much of the success of the design comes from its transference to a platform shared with the new Porsche Panamera. The previous-generation Continentals were built on underpinnings originally created for the VW Phaeton, a configuration that was, at heart, front-drive with all-wheel-drive capabilities, packaging that required engine placement ahead of the front axle. This new stablemate has a rear-wheel-drive bias, allowing for more traditional and gracious grand touring proportions on the surface. It reflects the movement of the engine farther back on the chassis, with a long hood and more hunkered-down and planted rear. We detect luscious shades of 1960s Ferrari Superfast cues in this tapering front-to-rear, side-to-side and along the flanks.

The 2020 Bentley Flying Spur has 3-D wood now, and it looks spectacular

This is the coolest wood you’re going to see today. We promise. Bentley is now manufacturing something it calls “Three-Dimensional Wood.” And yes, all wood we come into contact with is 3-D, but this stuff pops out at you like people and items do in a 3-D movie. YouÂ’ll find it in the rear door inserts of the Bentley Flying Spur, assuming the owner checked the box. One look at the photos will have you going, “how the Â… ?” Yes, itÂ’s pretty wild to see, and we can imagine the effect it has in person is even stronger. Bentley did explain how it made wood look like the diamond-quilted leather it uses in its seats, though. As one would expect from Bentley, itÂ’s a hell of a process.  Each rear door and quarter panel is crafted out of a single block of wood. Bentley uses either American Walnut or American Cherry timber. They start by machining the back of the log to match a die-cast aluminum door panel template. ItÂ’s bonded to the template, and then the difficult work begins. Skilled craftspeople carve the wood to its three-dimensional surface with a multi-axis routing machine to a tolerance of 0.1 mm. They then hand finish the cuts to achieve perfect results. Finally, a lacquer is applied to attain the color and texture that Bentley desires. Left: EXP 10 Speed 6 Concept; Right: Production Flying Spur pattern This design of wood was first seen in a Bentley concept from 2015. It was called the Bentley EXP 10 Speed 6 (shown above, left). After the positive reaction to that design, Bentley says it felt a production adaptation was in order.  “Three-Dimensional Wood is the next interior design element weÂ’ve taken from concept car idea to production reality,” Brett Boydell, Head of Interior Design for the Flying Spur said. “It works in perfect harmony with the three-dimensional leather quilting across the cabin of the Flying Spur and creates an even more special environment for those being driven.” If you were to count the number of carved diamonds in the wood, youÂ’d come to a total of 150 in the Flying Spur. As of now, the big sedan is the only Bentley this option is available in. We wouldnÂ’t be surprised if it expanded to others in the future. In addition to that, this is a design that could be translated into lesser luxury cars using cheaper processes and 3-D printing. Bring on the 3-D wood. Related Video:    

BMW makes the M4 extra special with a huge wing

BMW has all of the bases covered in its lineup, especially when it comes to its 4 Series models. Don't like going to the track? There's the BMW 430i and 440i, which are available as a coupe and gran coupe. Drivers looking for a track-friendly car that can also be used on the road will be steered toward the M4. BMW even built the hardcore M4 GTS for drivers that spend all of their time on a track. Now, it looks like BMW is trying to bridge the gap between the M4 and the M4 GTS with a special-edition model. Our photographers caught BMW testing an M4 with some extreme aerodynamic components around the Nurburgring. With its aggressive front end, massive wing, and sporty rear diffuser, the prototype M4 appears to be similar to the special-edition M4 Competition Sport that BMW released in Spain. The Spain-only special edition was marketed as a softer version of the M4 GTS with less power and usable rear seats. With a similar look and visible rear seats, this prototype indicates a similar track-focused special edition model. Since the M4 is only a few years old, it's unlikely that BMW is testing a new model, but the automaker could be testing aerodynamic components for a refreshed model down the road. A cheaper, more usable M4 GTS, though, would be the perfect car to round out BMW's current lineup. Related Video: