2018 Bentley Bentayga on 2040-cars

Auto blog

Here's the Bentley Bentayga actually going off-road

There might not be many opportunities to see a Bentley Bentayga getting dirty off-road, but Bentley is making sure its upcoming crossover can perform capably when off the beaten path. This video demonstrates the Bentayga's all-wheel drive system, and you can see the wheels braking when needed. While the SUV's exterior is covered in cladding, you get an idea of the vehicle's general shape. A small skid plate is also visible underneath. It is not set to go on sale until 2016, but the Bentayga has been spied testing all over the world. Bentley also already offered a good look at the interior. Most recently, the model showed up on the highways around Dubai, likely for hot-weather evaluation. Laps around the Nurburgring should also help keep the SUV relatively light on its feet. With 4,000 interested customers lined up as of earlier this year, the Bentayga should be a success for Bentley. After launch, a diesel V8 version and a plug-in hybrid are reportedly on the way in 2017. Later, a smaller crossover might be in the cards, too. Related Video:

Bentley resumes restoration of the first T-Series sedan

Bentley has shifted one of its on-going restoration projects into high gear. Found after spending decades undriven, the first T-Series sedan built is being brought back to life by the British company's apprentices and specialists and it should be back on the road by the end of 2023. Manufactured on September 28, 1965, about a week before the model's official unveiling at that year's Paris auto show, the oldest T-Series was finished in Shell Gray with a blue interior. Bentley initially kept the car and used it as a test mule around the world. The big sedan later ended up in private hands with a blue California plate and a "Beverly Hills Motor Cars" plate frame attached to its rear end. It was last registered in 2015, according to the sticker on the plate, though Bentley notes that it has spent decades off the road and in storage. Bentley bought the car and shipped it back to its headquarters in England. It started tearing down the sedan in October 2016: A group of apprentices removed the exterior trim and began preparing the body for new paint, but the project stalled. See, this happens even to luxury carmakers — don't feel bad about the Fox-generation Mustang lingering in the back of your garage. For collectors, projects tend to get delayed when, for better or worse, life happens. Bentley ran into different hurdles: It put the T-Series on the backburner to launch its current range of models, including the Flying Spur and the Continental GT. Nearly six year later, the firm is returning to the garage to wrap things up. It sounds like the T-Series was stored indoors, and being out of the elements might be its saving grace. Mechanics managed to fire up the 6.2-liter, 225-horsepower V8 engine, and they gave it a clean bill of health; the automatic transmission is in good condition as well. There is still some body work that needs to be completed and the interior is almost completely taken apart. Bentley estimates that the project will take approximately 18 months, so it should be finished by late 2023, and it plans to add the car to its Heritage Collection when it's done.  While it's a relatively obscure classic in 2022, the T-Series remains a hugely important part of Bentley's heritage.

Bentley Speed Six Continuation Series revealed at Goodwood Festival of Speed

The Bentley Continuation series of cars is … continuing. Today, Bentley unveiled the Speed Six Continuation Series at the Goodwood Festival of Speed. This follows the series of 12 Bentley Blower Continuation models, but apologies youÂ’re only hearing about the new series now, as the 12 Speed Six units are already spoken for. Bentley says it regards the Speed Six as its most successful race car ever because it dominated Le Mans both in 1929 and again in 1930. Just like the Blower, the Speed Six will be built using the same processes as the original car by BentleyÂ’s bespoke and coachbuilding division, Mulliner. Bentley has 80% of the carÂ’s original drawings and is supplementing this knowledge with original mechanicÂ’s notes and data taken from an original 1930 Le Mans racer and a 1930 Speed Six currently residing in BentleyÂ’s Heritage Collection. The “6 1/2 liter” (as Bentley likes to term it) six-cylinder engine required the creation of over 600 new parts to build, and Bentley says initial dyno testing shows itÂ’s making 205 horsepower, which is 5 horses more than the original race engines were documented to produce. Bentley originally put this engine together as a successor to the Blower motor, as the thinking at the time from W.O. Bentley was that increasing displacement would produce better results than supercharging. Every last detail of the Speed Six Continuation Series is scrutinized to be as authentic as possible to the original. The one youÂ’re looking at in photos here is finished in Parsons Napier Green and features a tan leather interior. A total of five authentic colors will be available for the buyers to choose from, too. The craftspeople building the cars will be working alongside younger folks on purpose in an effort to pass down the skills and techniques used to create such vehicles. Before a single screw is turned, though, Bentley says it will be putting “Car Zero” through a real-world durability program with a goal of over 21,000 miles on the road and nearly 5,000 miles on the racetrack. Will any of the 12 customers ever get close to those figures? It sure would be cool if they did. As for those 12 lucky people who will own one of these Speed Six Continuation Series cars, theyÂ’ll all have custom sessions with the Mulliner team to get their cars customized and built to their specific wants. Each Speed Six will then take 10 months from start to finish to complete, and Bentley thinks production will be completed by the end of 2025.