2008 Bmw 3.0si on 2040-cars

Auto blog

BMW 1 Series prototype packs direct water injection

Just a few months ago, BMW showcased an M4 that was modified to serve as the safety car for the MotoGP racing series. The flashing lights and emergency equipment, however, weren't the only modifications BMW made to the performance coupe. It also packed an innovative new water injection system. And now it's furthering the development of that system by running it in a 1 Series hatchback as well. Revealed at the BMW Group Innovation Days 2015 event, this five-door 1 Series packs a three-cylinder gasoline engine – like the one found in a Mini or i8 – but fitted with the direct water injection system. In this application, the system sprays a fine mist of water – yep, regular old H2O – right into the combustion chamber. While mixing water with gasoline normally wouldn't be recommended, in this case it evaporates immediately and helps cool the engine from the inside, allowing it to run at higher efficiency. That cooler running engine brings with it several benefits. It delivers improved fuel economy and lower emissions, to start. It also allows for an earlier ignition point, higher compression ratio, and higher boost pressure in turbocharged engines, delivering increased output. It even cuts down on engine knocking (where combustion occurs spontaneously), reduces wear and tear on the engine, and makes better use of lower octane levels. If that sounds like a win-win-win... win (we're losing count of all the wins here), it's because BMW just may be on to something. Of course it does require a water tank to be fitted on board, which means added weight, but instead of requiring the driver fill up the water tank, BMW has fitted this prototype with a system that replenishes the water level from the air conditioning system when the vehicle is switched off. So unless it's being driven in a particularly extreme climate, it doesn't even need topping up. Add one more "win" to the list, then. Extra power, improved real-world fuel economy: Direct water injection enhances efficiency. With direct water injection for turbocharged petrol engines, the BMW Group has again succeeded in enhancing the capabilities of conventional engine technology through an ongoing process of refinement and improvement. The precisely controlled injection of water into the engine cylinders produces a cooling effect that boosts power and torque, particularly when operating at or near full throttle, while at the same time reducing fuel consumption and emissions.

BMW looking to fix i3 acceleration problem uncovered by Consumer Reports

The BMW i3 has been hailed in some quarters as the future of electric mobility, what with its innovative carbon-fiber-reinforced plastic body and commitment to sustainable materials wherever possible. The modernist little hatch is even available with a 650cc two-cylinder gas engine with 34 horsepower to act as a range-extender for those who want it. However, that optional engine might have a drawback - at least for the moment.
Consumer Reports brought the problem to light when one of its drivers was behind the wheel of an i3 using the range-extender. When the driver attempted to pass another vehicle on a rolling, two-lane road, the BMW suddenly had no power to accelerate - a scary situation. CR started examining the car and found something pretty shocking: After driving at a constant speed for a while without any regenerative braking in range-extended mode, acceleration to 60 miles per hour plummeted from about 9 seconds normally to a staggering 27 to 40 seconds in their testing.
A BMW spokesperson told CR that it knows about the problem and has a fix coming next spring that also works on current models. The upgrade includes a state of charge indicator, a warning about loss of power and uses the car's navigation to boost the battery before driving on rolling terrain. It is not clear if the severe power deficiency will also eventually result in a recall.

Wagons make a bit of a comeback, with new models, sales on the rise

Consider this an official invitation to hop on the wagon bandwagon. There's still tons of room because, well, it's a wagon (and market share is still extremely small). But according to new data, the segment is growing. According to a report from Bloomberg, using data from Edmunds.com, roughly 211,600 Americans purchased wagons in 2018. That is technically down from the 237,600 sold in 2017, but wagon sales in the U.S. are up 29 percent from where they were five years ago. It's also the third year in a row that wagon sales broke the 200,000 mark. The sales trends have been somewhat representative of the availability of wagons. New models have debuted during the past 5 years and therefore offer more opportunity at more brands to buy wagons. In addition to more modest cars such as the Volkswagen Golf Sportwagen, several luxury and performance brands are offering wagons today, such as Mercedes-Benz, Audi, Porsche, Jaguar, Volvo and Buick. (Bloomberg's headlines make the point that "crossovers are for the Kardashians," and wagons are just, well, classier.) This uptick in brand-name availability, as well as extremely well-executed design on most of the wagons currently available, has helped increase the segment's desirability. That, and its ability to better accomplish the same tasks at hand while standing out from the crossover and SUV crowd. Still, the posted numbers represent a small fraction of the total vehicles sold. According to the data, wagons only held a 1.4 percent market share in 2017, the segment's best recent year. Wagons hold a steadfast place in America's past, and they're writing an interesting new story. With the downturn in traditional cars, they may continue to create an unexpected narrative. Related Video: News Source: Bloomberg, Edmunds Audi BMW Buick Volkswagen Volvo Wagon station wagon