1984 Bmw 633csi 5-speed Manual on 2040-cars

Auto blog

Thanks to smaller engines, vehicle dependability falls for first time in 16 years

As automakers have made engines smaller and smaller to improve fuel economy, problems in those vehicles have gotten bigger and bigger. That's the synopsis of a J.D. Power vehicle-dependability study, which found that dependability dropped for the first time in 16 years, largely because the proliferation of four-cylinder engines is causing the vehicles to be less reliable. Specifically, the number of problems per 100 vehicles (or what J.D. Power calls PP100) during the past 12 months for 2011 model-year vehicles rose six percent from the year-earlier figures for 2010 model-year cars. Singling out four-cylinder vehicles revealed about a 10-percent increase in problems during the past year. This issues largely related to engine hesitation, rough transmission shifting and lack of power, signaling the inability of vehicle makers to iron out some of the problems in their smaller engines as they strove for better fuel economy. Six- and five-cylinder engines proved far more reliable. Among car brands, BMW's Mini sub-brand came out as least reliable, with 185 problems per 100 vehicles during the past year. Toyota's Lexus badge was easily the most reliable, with just 68 problems per 100 vehicles. Coming in second place was Mercedes-Benz. The overall average was 133. Check out J.D. Power's press release below. J.D. Power Reports: Increased Engine and Transmission Problems Contribute to Decline in Vehicle Dependability for The First Time in More Than 15 Years General Motors Company Receives Eight Segment Awards, While Toyota Motor Corporation Garners Seven and Honda Motor Company Earns Six WESTLAKE VILLAGE, Calif.: o Owners of 3-year-old vehicles (2011 model year) report more problems than did owners of 3-year-old vehicles last year, according to the J.D. Power 2014 U.S. Vehicle Dependability StudySM (VDS) released today. The study, now in its 25th year, examines problems experienced during the past 12 months by original owners of 2011 model-year vehicles. Overall dependability is determined by the number of problems experienced per 100 vehicles (PP100), with a lower score reflecting higher quality. The study finds that overall vehicle dependability averages 133 PP100, a 6 percent increase in problems from 126 PP100 in 2013. This marks the first time since the 1998 study that the average number of problems has increased. "Until this year, we have seen a continual improvement in vehicle dependability," said David Sargent, vice president of global automotive at J.D.

Upgraded BMW 230i and M240i get more power, new badges

A few months ago, we got our hands on a report that claimed that BMW would ditch the 28i and 35i monikers for both the 2 and 3 Series. BMW already dropped the 335i designation in favor of the 340i badge, but the 328i is still hanging around. In the 2017 2 Series, the old badges are out. Meet the new 2017 230i and M240i, in both coupe and convertible flavors. If you're already confused about all the badge changes, here's the important part: the 2.0-liter inline-four and the 3.0-liter inline-six, both turbocharged, get more power than the engines in their 2016 counterparts. The 230i will get 248 horsepower and 258 lb-ft of torque, and be smoother than before. Those are increases of eight hp and three lb-ft of torque over the 2016 model. The M240i replaces the M235i. There's more power here, too: 335 hp and 369 lb-ft of torque, available from 1,520 rpm to 4,500 rpm. Those are increases of 15 hp and 39 lb-ft of torque, by the way. All-wheel-drive models are eight-speed automatic-only; a six-speed manual is a no-cost option on the 230i, and available on the M240i. These models will launch later this summer, and pricing will be available closer to that time. We reached out to a BMW spokesperson for a better understanding of what hardware and software changes are responsible for the increased output, but this information isn't yet available. Related Video: BMW Convertible Coupe Luxury Performance 2 series bmw m240i bmw 230i

VW could look outside its own ranks for next CEO

Companies have two options when coming up with succession plans – hire within, or go outside its ranks. Either choice comes with advantages and disadvantages, to be sure. Hiring within means generally getting someone familiar with the company and its culture and traditions, while going outside is ideal if you're looking to shake things up and bring in fresh ideas. It's unclear which avenue the Volkswagen Group will go down when it comes time to replace its head man, Herr Professor Doctor Doctor Herr Martin Winterkorn, but he isn't ruling out a trip outside of Wolfsburg. Winterkorn has already given the reins of the VW brand to former BMW board member Herbert Diess, while Andreas Renschler, a former Daimler board member, is heading up VW's truck group. Now, Winterkorn has made some statements to a German weekly that indicate the most important thing about his successor isn't necessarily his (or her, though no women appear to be on the short-list) previous employer, Motoring.com.au is reporting, so much as his qualities as a leader and an engineering background. "A Volkswagen boss has to have a big affinity to our products. He needs to be close to customers and he needs to have a relationship with dealers," Winterkorn told Stern. "Like always, it depends on the personality and it also helps if the candidate is an engineer." Motoring throws out a couple of potential candidates from within, including Porsche boss Mathias Muller, Audi Chairman Rupert Stadler and engineering guru Ulrich Hackenberg, in addition to both Diess and Renschler. And while each candidate has a lot of potential, the only thing that's guaranteed right now is what Winterkorn has already said: "The decision about who will succeed me is not an easy one for the supervisory board."