Ford F-350 Xlt on 2040-cars

Auto blog

Ring Brothers shows 1965-66 Mustang fastback carbon fiber body

We covered one of Ring Brothers' more extreme SEMA builds yesterday, the De Tomaso Pantera-based ADRNLN, but if that well-executed but over-the-top Italian-American exotic is too much for you, then perhaps this Ring Brothers 1965 Ford Mustang fastback with a carbon-fiber body suits your tastes better.
What the performance-parts manufacturer is showcasing with the Mustang is the carbon-fiber body itself, which is fashioned around the 1965-66 fastback. It can be bought from the company and bonded to the skin and unibody as a do-it-yourself project, or you can take your Mustang to Ring Brothers and have the body installed there. The fenders, doors and quarter panels are two-inches wider than stock, and Ring Brothers offers a custom widebody chassis to those who want the complete package.
The show car looks sharp in person lowered on HRE wheels, and we appreciate the bare front end so we can see the supercharged V8 and front coilover suspension, though the details on those performance upgrades are slim. Also note the custom independent rear suspension setup at the rear.

NHTSA closes rollaway investigation into 1.56M Ford SUVs

It's taken four years of study, but the National Highway Traffic Safety Administration has finally closed the books on its investigation into rollaway accusations surrounding 1.56-million Ford SUV models.
The probe, which centered on the 2002-2005 Ford Explorer, 2002-2005 Mercury Mountaineer and 2003-2005 Lincoln Aviator, ends without the federal agency calling for a recall. According to The Detroit News, the investigation was closed due to a "low number of complaints" - NHTSA documented 180 such complaints that resulted in 14 crashes and six minor injuries, but the number of incidents have been slowing. The suspected defect rate for the trucks' automatic transmissions was found to be 4.4 per 100,000 units, and the brake-shift interlock mechanism failure rate was judged to be even lower at 3.4 per 100k.

Ford builds Lightweight Concept with Fusion shell [w/video]

It's a fairly well known fact that removing weight from a car is essentially a panacea for many of the modern automobiles problems. Does it handle like crap? Remove weight. Underpowered? Don't add power; trim the fat. Need to improve fuel economy? It's diet time.
Actually executing a major weight reduction program, though, much like with human beings, is no easy task. Unlike you or I, where motivation is the issue, the prohibitive measure in trimming a car's waistline is money. Lightweight materials are expensive, with carbon fiber and carbon-fiber reinforced plastic still primarily in the domain of higher end vehicles. Even aluminum construction, pioneered on a mass-produced level by Audi and Jaguar, is only now starting to make its way into the mainstream, thanks to the upcoming Ford F-150.
With this concept, though, Ford is attempting to show that a mass-produced, lightweight vehicle isn't too far off. This is the Lightweight Concept, and while it may look like a Fusion, it weighs as much as a Fiesta. For reference, the lightest Fusion available to the public is the 3,323-pound, 2.5-liter model with a manual transmission. A manually equipped, 1.6-liter Fiesta, meanwhile, is just 2,537 pounds.