2011 Ram 3500 Laramie Mega Crew Cab Pickup 4-door 6.7l Megacab 4x4 on 2040-cars

Auto blog

Chrysler recalling 2009-2010 Ram 1500, Dodge Dakota pickups over axle pinion nut

Chrysler is issuing a recall for the 2009 and 2010 Ram 1500 and Dodge Dakota pickup trucks due to improper installation of the rear axle pinion nut. According to the National Highway Traffic Safety Administration, a total of 44,300 trucks are affected by the recall, and there have been 12 confirmed incidents including one crash.
The issue on both trucks is that the pinion nut is loosening on some trucks due to a lack of thread adhesive, and it is causing the rear axle to lock up resulting in loss of vehicle control. NHTSA's recall notice says that eight incidents occurred at speeds over 35 miles per hour and most also exhibited driveshaft failures as well since the loss of the pinion nut would cause the gear to separate from the driveshaft. In one complaint, the driveshaft separated from the rear axle and punctured the gas tank.
Chrysler will begin sending out recall notices to affected owners in November, but scroll down to see the official NHTSA notice.

Chrysler called out over lackluster Ram Runner by racer who helped develop it

Fans of off-roading and desert blasting might recall that Chrysler offers an aftermarket conversion that can turn a Ram 1500 into a road-legal desert racer, called the Ram Runner. The kit, sold through Mopar, includes some significant suspension upgrades, body tweaks and a brawnier cat-back exhaust for the truck's 5.7-liter V8.
Considering all of this, comparisons with the almighty Ford F-150 SVT Raptor are common. Among the off-road community, that makes these two a sort of Chevrolet Camaro and Ford Mustang for people that prefer driving on dirt. In the Race-Dezert forum, the discussion as to which truck was better was proceeding as normal - Ram fans said their piece and Ford fans said theirs. Then, a man named Kent Kroeker offered up his two cents.
See, Kroeker is a Baja racer, and the man that helped develop the Ram Runner. Despite his association with the truck, though, he had some less than kind words for Chrysler and the Ram Runner.

Chrysler to accelerate production of 2013 Ram and V6 engines

Chrysler is adding a third shift at its Warren Truck plant to meet demand for the new 2013 Ram pickup. And with tight supplies of its Pentastar V6, the company is also boosting output at its Mack Engine plant.
The expansions will add 1,250 jobs and are part of a $238 million investment by Chrysler in the Detroit area. Warren's third shift will begin work sometime in the spring, a Chrysler rep told Automotive News. Mack's increased Pentastar production a could include both 3.6 and 3.2-liter engines.
The company says it also plans to invest $40 million in its Trenton Engine plant to allow for production of a 3.2-liter V6 as well as the Tigershark inline-four for the upcoming Jeep Liberty replacement.