1951 Mercury Sport Sedan 100% Original Survivor No Rust! on 2040-cars

Auto blog

Ford recalling 126,000 Fusions and Milans over wheel separation concern

Ford has announced a recall of certain Ford Fusion and Mercury Milan vehicles after an investigation by the National Highway Traffic Safety Administration. A total of 128,616 2010 and 2011 models equipped with steel wheels may have been manufactured with wheel studs that could crack and split over time. If that happens, the vehicle may experience a wheel separation.
According to The Detroit News, the company is aware of a total of 30 wheel separation incidents, one of which occurred on the front of the vehicle. Even so, no injuries have been reported as a result of the defect.
The problem apparently stems from the fact that the mounting pads on the vehicles' steel wheels may have been faulty from the factory. In addition, the wheel mounting face on rear disc brakes may not have been installed properly. Ford will inspect the rear disc face and replace them as necessary. In addition, the company will replace all of the vehicle's wheel studs free of charge. Head to the NHTSA website for more information, and click past the jump to view the full recall notice.

NHTSA investigating 725k Ford, Mercury vehicles for stalling issue

Owners of Ford Escape, Mercury Mariner, Ford Fusion and Mercury Milan models, listen up. According to a report on Automotive News, the National Highway Traffic Safety Administration has opened an investigation into these four vehicles totaling an estimated 725,000 units. The investigation appears to center around a malfunctioning throttle body on non-hybrid models of the 2005-2012 Escape and 2011-2012 Fusion. With Mercury dying off after the 2011 model year, this probe will also apply to the 2005 through 2011 Mariner and the 2011 Milan. There has been some discussion around the Escape stalling issue for some time now, but this investigation appears to be larger in scope than before.
Though not a recall yet, NHTSA's Office of Defects Investigation (ODI) has received 123 complaints of stalling or surging vehicles, while Ford itself has logged 1,472 complaints. The investigation report, which is posted below, seems to indicate that a faulty circuit board for the throttle body could cause the vehicle to go into limp mode, which, according to NHTSA, could cause complaints of both stalling and surging.

Translogic drives wood-burning Mercury Beaver XR-7

You read the title right, we're talking about the Mercury Beaver XR-7. No, Mercury never officially built a car called the beaver. This is the brainchild of upstate New Yorker Chip Beam, who owns and operates Beaver Energy, LLC. It runs on gases created by wood pellets fermented in a 2,400-degree furnace and fed to a supercharged Ford 4.6-liter V8.
By all accounts, it gets down the road just fine, and has pretty close to full power. The best part is, you can grow the fuel yourself and avoid patronizing big oil, if that's your thing. The only drawback that we can see to the Mercury Beaver XR-7 is the PVC pipe jungle occupying the space that would be the trunk under normal circumstances.
Still, if you're willing to smell like a mountain man and look like a bad Back to the Future knockoff, this ride is right up your alley. Click past the jump to see Translogic's take on this modified Merc.