Silver Lexus Is300 In Good Condition With Sunroof And Tan Interior on 2040-cars

Auto blog

Consumer Reports: Toyota expected to announce fix for emergency trunk releases

According to Consumer Reports, Toyota is set to release a fix for trunk release pulls on certain Lexus vehicles that could snap off in an emergency. As you may recall, CR found the federally-mandated emergency releases could break if pulled toward the user. As it turned out, the trunk surround behaved like a fulcrum, putting more force against the center of the release than toward the trunk mechanism itself. While the organization found the problem to exist on 2013 Lexus ES and GS, Toyota was able to replicate the flaw on the IS as well.
Toyota will alert 700,000 owners of 2007-2013 Lexus ES models, 2006-2012 IS vehicles and 2013 GS cars and replace the old ABS plastic release with a sturdier polypropylene part free of charge once the components are available to dealers. The service campaign is expected to begin in January.

Lexus ES350 confirmed for Kentucky production starting in 2015

Following Thursday's report, Toyota has confirmed that production of the Lexus ES will move to its Georgetown, KY assembly plant starting in 2015. To accommodate the extra 50,000 units of capacity that the ES represents, Toyota will be investing $360 million in the plant and hiring 750 new workers.
In the previous report, sources stated that the state of Kentucky had offered Toyota as much as $146.5 million to move ES production to the Georgetown facility.
The press release, posted below, specifies that only the ES350 will be built in Kentucky, so it's likely that the ES300h hybrid will continue to be built in Japan - where all ES models have been built since the car was introduced in 1989. Toyota's Georgetown plant, which currently builds the Toyota Camry, will also be getting an expansion to its engine plant to produce more four-cylinder engines at a cost of $30 million and will create an additional 80 jobs.

Toyota develops new pre-collision system with steering assist

A number of automakers are working on developing fully autonomous cars, but it looks like the groundwork for such technologies will likely show up first as semi-autonomous systems for both safety and convenience. Following recent announcements from Nissan and Ford in this area, Toyota has now released information for some of its advanced semi-autonomous technologies that could be offered in production cars over the next few years.
On the safety front, Toyota's new pre-collision system with pedestrian-avoidance steering assist is aimed at protecting the folks who aren't in the car. This system combines visual and audible alerts with automatic brake assist and automatic steering. If warnings don't get the driver to slow down, the brake assist kicks in if a collision is very likely, but if that is still not able to avoid the impending collision (and if there is enough room to do so), the car can automatically steer itself around the pedestrian. This sounds most beneficial for last-second dangers such as a person accidently stepping out into the road in front of a car. Toyota hopes to have this technology available to customers by 2015.
The Japanese automaker is also testing a suite of technologies called Automated Highway Driving Assist (AHDA). The key part of this is a new adaptive cruise control system that uses vehicle-to-vehicle (V2V) communications rather than a radar-based system. This cooperative-adaptive cruise control allows vehicles to communicate their acceleration and deceleration data with other cars, which Toyota says this helps to improve fuel efficiency and traffic flow. Also a part of AHDA is the Lane Trace Control feature, which sounds like a next-gen lane keep assist. This system uses cameras, radar and a computer to keep the vehicle in a "smooth driving line" by being able to change steering angle, engine torque and braking force. Toyota says this technology could be in place by the "mid-2010s."