2011 Honda Pilot Lx Damaged Rebuilder Fixer Low Miles Runs! Cooling Good L@@k!! on 2040-cars

Auto blog

Acura NSX bodywork to be sheathed in zirconium e-coat, fewer paint layers

Automakers make halo cars to drum up excitement and show off what they can do, but there's more to it than that. Advanced platforms allow a company's engineers to experiment with all sorts of technologies. And in the case of the upcoming new Acura NSX, that includes new paint processes.
Speaking with Autoline in this video interview, Honda's North American Senior VP Jon Minto talked about an innovative zirconium e-coat which it's applying to the new NSX. Unlike some experimental paints developed for Formula One, however, this coating is not designed to minimize drag or enhance cooling: it's designed to be more environmentally friendly.
It's one of a few measures which Honda is implementing on the NSX before expanding it to more accessible models, along with another process that uses fewer coats to reduce energy consumption by 40 percent. Watch the interview with Autoline host John McElroy right here.

McLaren working on P15 supercar to slot between 650S and P1

McLaren has been busy these past few years. It launched the MP4-12C in 2011, the 12C Spider in 2012, the P1 in 2013 and (most recently) the 650S in 2014. But it's not about to stop there. It's got an "entry-level" model in the works, set to take on the Porsche 911, and - according to information reported by Car and Driver and confirmed by McLaren in correspondence with Autoblog - a new flagship model, too.
The project is internally codenamed P15, and it calls for a new flagship that will cap the company's lineup once the P1 finishes its limited production run, but carry a price tag in the neighborhood of $500k to slot in between the P1 and the new 650S.
Just how, you wonder, can McLaren possibly develop another supercar each year? Simple: underneath, they're all essentially the same. (Only we're sure it's anything but simple.) That is to say they're all based on the same carbon monocoque structure and powered by the same 3.8-liter twin-turbo V8 mated to a seven-speed dual-clutch transmission driving the rear wheels. What differentiates them is what the engineers in Woking build around that monocoque and how they tune the engine: +/- 600 horsepower in the 12C (depending on the year it was built), 640 hp in the 650S, or 727 hp in the P1 (with another 177 from the electric assist). The 911 fighter would likely develop in the 500hp range, and the P15 will probably land in the upper 600 (or lower 700) range.

Tier 1 suppliers call GM the worst OEM to work with

Among automakers with a big US presence, General Motors is the worst to work for, according to a new survey from Tier 1 automotive suppliers, conducted by Planning Perspectives, Inc.
The Detroit-based manufacturer, which has been under fire following the ignition switch recall and its accompanying scandal, finished behind six other automakers with big US manufacturing operations. Suppliers had issues with trust and communications, as well as intellectual property protection. GM was also the least likely to allow suppliers to raise their prices in the face of unexpected increases in material cost, all of which contributed to 55 percent of suppliers saying their relationship with GM was "poor to very poor."
GM's cross-town competitors didn't fare much better. Chrysler finished in fifth place, ahead of GM and behind Dearborn-based Ford, which was passed for third place this year by Nissan. Toyota took the top marks, while Honda captured second place.