4dr Supercab 3.0l Cd Rear Wheel Drive Temporary Spare Tire Power Steering Abs on 2040-cars

Auto blog

Ford Mustang GT350 drops some camo

Now that we've poured over the 2015 Ford Mustang in its standard form, it's time to look ahead. We already knew (and heard - literally) that Ford was working on a higher-performance version of its 'Stang to replace the Shelby GT500, and earlier reports have stated that it will simply be called the GT350.
We don't have a ton of detail to go on, but this latest set of spy photos clearly shows a hood-mounted air scoop, which suggests a forced-induction powerplant is under the hood. However, this disagrees with earlier reports that the GT350 will be all motor, using a naturally aspirated engine to send massive horsepower to the rear wheels. Our spies also point out the functional vent aft of the front wheels to allow for better airflow, and the massive quad exhaust pipes can be seen, clear as day.
Expect to see the Mustang GT350 in April, when it debuts at the New York Auto Show in conjunction with the Pony's 50th anniversary. In the meantime, have a look at our gallery above to see the latest shots of the hot Mustang out testing.

2015 Ford F-150 shaves 700 pounds, adds 2.7-liter EcoBoost [w/video]

The Ford F-150 is one of the best selling vehicles on the planet. Considering that, one can imagine that when it comes time for a redesign, there are hardly any half measures. For its lucky thirteenth generation, Ford has gone all-in on the single most important vehicle in its portfolio, redesigning it from the ground up.
The big news is the F-150's new, lightweight, Atlas-inspired body. Ninety-three percent of that new body is made from a sort of aluminum alloy not unlike what the US military uses in its M2 Bradley fighting vehicles and Humvees, and it accounts for up to 70 percent of the F-150's 700-pound weight reduction. As a side benefit, the aluminum body should prove more resistant to dents and dings. Built Ford tough, indeed.
If you're wondering where the other 30 percent of that 700-pound weight loss went, 8.5 percent (60 pounds) came from the increased use of high-strength steel (up from 23 percent to 77 percent) in its ladder-box frame. Ford claims this steel is comparable to some of the heavy duty pickups used by its competitors, with a PSI rating of 70,000.

Ford opens the doors on its Swedish rally skunkworks

It's always amazing to see how different kinds of racecars are made. Formula One racers are often constructed in modern architectural marvels that hint at some of the cutting-edge technology going into the racing. Conversely, rallying is all about sliding around on a varied course as fast as possible, but it often leaves a vehicle caked in mud. So it makes some sense Olsbergs MSE, or simply (OMSE) rally car shop in Nynashamn, Sweden, shows technological sophistication in a more down-to-earth setting. It builds Ford Fiesta ST racers for Global Rallycross there, and this new video gives viewers a tour through the work.
Former rally driver Andreas Eriksson runs OMSE. These days instead of racing, he and the company's 46 employees are building Ford racers from scratch. A ton of work goes into constructing each one, and according to Eriksson, it takes 400 hours to complete each body. At times, things are so busy that some of the technicians live in the shop in apartments that are on premises. There's even a restaurant to keep them fed. Sadly the dyno room is empty during this visit, though.
By the time OMSE is done, a rallycross car might resemble a Fiesta ST on the outside, but as you see in the video, it's a completely different beast underneath. Check out the work it takes to build one of them, and scroll down to read more about it in the official release.