Find or Sell Used Cars, Trucks, and SUVs in USA

2012 Ford Mustang Gt Convertible 2-door 5.0l on 2040-cars

US $31,000.00
Year:2012 Mileage:13015
Location:

Safety Harbor, Florida, United States

Safety Harbor, Florida, United States

This 2012 Grabber Blue Mustang GT Convertible is loaded with all factory options. Original window sticker of $46,245.00 new (included). Low miles, always garage kept.

Auto Services in Florida

Yow`s Automotive Machine ★★★★★

Auto Repair & Service, Automobile Machine Shop, Industrial Equipment & Supplies
Address: 6219 15th St E, Anna-Maria
Phone: (941) 758-6466

Xtreme Car Installation ★★★★★

Auto Repair & Service, Automobile Parts & Supplies, Automobile Accessories
Address: 3663 NW 79th St, Bay-Harbor-Islands
Phone: (305) 836-0118

Whitt Rentals ★★★★★

New Car Dealers, Car Rental
Address: 1807 N Nova Rd, Bunnell
Phone: (386) 252-0011

Vlads Autobahn LLC ★★★★★

Auto Repair & Service
Address: 5145 Commercial Dr, West-Melbourne
Phone: (321) 622-5665

Village Ford ★★★★★

Auto Repair & Service, New Car Dealers, Used Car Dealers
Address: 11660 SE US Highway 441, Ridge-Manor-Estates
Phone: (352) 233-2900

Ultimate Euro Repair ★★★★★

Auto Repair & Service
Address: 2011 SW 70th Ave, West-Hollywood
Phone: (954) 475-0225

Auto blog

NHTSA closes rollaway investigation into 1.56M Ford SUVs

Mon, 11 Mar 2013

It's taken four years of study, but the National Highway Traffic Safety Administration has finally closed the books on its investigation into rollaway accusations surrounding 1.56-million Ford SUV models.
The probe, which centered on the 2002-2005 Ford Explorer, 2002-2005 Mercury Mountaineer and 2003-2005 Lincoln Aviator, ends without the federal agency calling for a recall. According to The Detroit News, the investigation was closed due to a "low number of complaints" - NHTSA documented 180 such complaints that resulted in 14 crashes and six minor injuries, but the number of incidents have been slowing. The suspected defect rate for the trucks' automatic transmissions was found to be 4.4 per 100,000 units, and the brake-shift interlock mechanism failure rate was judged to be even lower at 3.4 per 100k.

Ford and Chrysler reducing summer plant shutdowns

Wed, 22 May 2013

Most domestic automaker assembly plants traditionally take a couple of weeks off during the summer. The shutdowns give each plant time for much needed repairs and maintenance, and in some cases, help better align production with demand. Not this year, though, as demand for many models is outstripping what Ford, Chrysler and General Motors plants can produce.
Ford has announced that it will shorten its annual summer shutdown for most North American plants from two weeks to one. The shorter shutdown will increase the carmaker's annual North American production by 40,000 units on top of the 200,000 extra units that it was already planning to produce this year versus last. Automotive News reports that Ford produced 2.8 million vehicles on this continent in 2012, and that output this year has already increased 13 percent through April.
Chrysler, meanwhile, is also operating at full tilt and plans to run some plants through the summer with no shutdown at all. Those not getting a break include Jefferson North where the Jeep Grand Cherokee and Dodge Durango are assembled, Toledo North that will assemble the new Cherokee, and Conner Avenue, home of SRT Viper production. Other assembly plants will be down for a single week, while all of Chrysler's engine and transmission plants except one in Indiana will continue operating with no shutdown this summer.

NHTSA closes Ford F-Series Super Duty steering probe without recall

Wed, 05 Feb 2014

The National Highway Traffic Safety Administration's investigation into 2008 Ford F-250 and F-350 Super Duty pickups, which was originally opened last year, has now ended without a recall. NHTSA was looking into steering failures on some 336,000 trucks.
The issue rested with the steering gear - NHTSA received five complaints of failures - which was redesigned in 2005. According to the report on the matter, investigators "found evidence of broken sector shaft gear teeth and piston damage consistent with incidents of single event overload."
NHTSA investigators, however, "found no evidence of fatigue or material property defects in any of the fractures. Analysis of complaint rates by vehicle build month showed no patterns indicating potential manufacturing quality issues and no difference before and after Ford introduced design changes to the input shaft and sector shaft seals in July 2007 to address potential leak concerns," according to the report, obtained by The Detroit News.