1924 Ford Model T Touring Convertible 3 Door Beautiful Classic 40 Pics !! on 2040-cars

Auto blog

How Ford hid the 2015 Mustang from spy photographers

Now that we've finally seen the 2015 Ford Mustang, it's fun to go back and look at the spy shots we spent months pouring over, trying to dissect what was under all the camouflage. For the most part, Ford did a good job of concealing the car from spy photographers, and it released a video showing how much work went into doing so.
As crude as the Mustang's camo looked, all of the hard plastic, foam, vinyl and ratchet straps were actually created and put in place by a specific design team. The whole idea was to hide the car's identity, but it certainly ended up acting as a magnet for attention, too. According to Ford's press release, it took less than an hour for spy shots to appear online after the car was taken on public roads for the very first time - this is likely in reference to our first official spy shots of the Mustang from June, shown in the gallery below.
Scroll down for a press release and video, which shows footage of the 2015 Ford Mustang testing with minimal camouflage. This is probably the same track session where we got our first look at the Mustang's face back in August.

Ford F-100 'Snakebit' shown off by Gene Simmons and Shannon Tweed at SEMA

Ford, along with KISS bassist Gene Simmons and his wife, Shannon Tweed, used SEMA as a backdrop to pull the covers off Snakebit, a 1956 Ford F-100 pickup truck that's been updated with Shelby Mustang-derived styling bits and a 5.4-liter supercharged V8 engine. All 550 horsepower are funneled through a six-speed manual gearbox to the rear wheels.
Underneath the custom bodywork sits a chassis that's been stretched five inches and a bed widened and bedecked with billet machined pieces that are supposed to look like wood. The 20-inch rear and 18-inch front wheels ape those of past Shelby Mustang models. The interior is swathed in two-tone leather with a bench seat designed to look - try to act surprised - like a Shelby Mustang.
Like what you see? Bidding for the truck will take place in 2014 at an unspecified Barrett-Jackson event (we'd assume Scottsdale). Proceeds will be used to help build a children's hospital in Saskatoon, in the province of Saskatchewan, where Ms. Tweed grew up. See the high-res gallery above and the press release down below for more.

Ford builds Lightweight Concept with Fusion shell [w/video]

It's a fairly well known fact that removing weight from a car is essentially a panacea for many of the modern automobiles problems. Does it handle like crap? Remove weight. Underpowered? Don't add power; trim the fat. Need to improve fuel economy? It's diet time.
Actually executing a major weight reduction program, though, much like with human beings, is no easy task. Unlike you or I, where motivation is the issue, the prohibitive measure in trimming a car's waistline is money. Lightweight materials are expensive, with carbon fiber and carbon-fiber reinforced plastic still primarily in the domain of higher end vehicles. Even aluminum construction, pioneered on a mass-produced level by Audi and Jaguar, is only now starting to make its way into the mainstream, thanks to the upcoming Ford F-150.
With this concept, though, Ford is attempting to show that a mass-produced, lightweight vehicle isn't too far off. This is the Lightweight Concept, and while it may look like a Fusion, it weighs as much as a Fiesta. For reference, the lightest Fusion available to the public is the 3,323-pound, 2.5-liter model with a manual transmission. A manually equipped, 1.6-liter Fiesta, meanwhile, is just 2,537 pounds.