1997 Ford F450 Superduty Wrecker on 2040-cars

Auto blog

1947 Chevy rat rod pickup leaves rubber and smoke in its wake

Cool comes in multiple flavors. One one hand, we have the sophisticated attraction of svelte design and the efficient use of power. Of course, on the other hand there is the allure of being the bad boy and going against the grain. That is part of the appeal of rat rods. Ideally, they are built without rules to an owner's specific tastes, and this widened and heavily modified 1947 Chevrolet pickup rod is a perfect example of that spirit.
Coming down the highway with a bent grille, rusted body and pouring smoke, it looks like the pickup from hell. It backs up the looks with some very impressive mechanicals too. Owner Troy Gubser says that the truck packs a Ford Power Stroke diesel with to 42 pounds of boost that runs out of 8-inch exhaust stacks at the back. He claims it managed 505 horsepower and 885 pound-feet of torque on the dyno. To harness all that power, this hot rod has a ZF five-speed manual gearbox with a ceramic clutch and short-throw shifter. Plus, it has cool little features like a doorbell on the tailgate that operates an air horn.
You might not expect a truck like this to actually be useful, but it has a fifth wheel coupling to haul an RV around drag races and car shows. The air suspension also probably keeps the ride fairly comfy when Gubser wants it to be. Scroll down to check out this beastly rat rod pickup and watch it engage in some diesel drag racing. Warning, there is some NSFW language.

How Ford made its 2015 Ford Mustang safer for toupee wearers [w/video]

Ford is ready to tell the story of its 2015 Mustang Convertible, the can't-miss bits being the easier, quicker and quieter roof operation, a more robust roof build for a coupe-like cabin noise, more trunk space, better visibility and reduced in-cabin buffeting. The top release system has been completely redesigned with a single, center-mounted latch on the windshield frame instead of the dual latches of before. The driver can now release the roof without having to lean over into the passenger space, after which the top goes down fully automatically with the press of a button. Ford doesn't say how long it takes to stow, but it's apparently done in half as much time as before, so figure around 8 seconds.
The roof uses a five-bow structure, with the fabric outer and full inner headliner sandwiching ten millimeters of insulation. Detailing work on the top has eliminated "unsightly folds" in the corners when the roof is up and made it more compact when down; its Z-fold assembly is 6.7 inches lower than before at its highest point when put down. Ford says the new electric drive internals make less noise when in operation, and the fully-finished droptop look is achieved with snap-in caps that flank the rear seating and stow in the trunk when not in use (the outgoing Mustang's top was higher and the front when folded and always looked like it was catching air and creating drag).
The compact roof and newly independent rear suspension setup in back means liberated trunk space, 11.4 cubic feet ready to swallow golf bags and tourist swag. You can read a lot more about it in the press release below, check it out in the short video of running footage and learn about the aerodynamic improvements made to the entire Mustang lineup that decrease drag and increase fuel economy.

Ford cleans up painting process with cameras

Knowing how the bacon gets made rarely entices us and, in the same vein, the same usually goes for knowing about how new cars get painted. But in both instances, however, quality - or a lack thereof - is instantly obvious. In terms of the latter, Ford is showing off its new paint quality process with 3D Dirt Detection Technology to find imperfections in vehicle paint more easily and more quickly.
This process - being performed on the F-150 SVT Raptor above - uses 16 computer-controlled cameras to create a three-dimensional model (inset) of the vehicle to detect flaws in the paint including dirt particles, which can then be buffed out manually. Ford says this new technology cuts down on time spent looking for paint flaws and gives workers more time to correct those that are discovered.
Currently, Ford only uses its 3D Dirt Detection Technology system at three factories (the Dearborn, MI facility, along with those in Louisville, Kentucky and Valencia, Spain), but it will soon spread to five more plants in North America. Ford has released a video and press release for this innovative and unexpectedly interesting process, both of which are posted below.