2011 Ford F-250 Lariat 4x4 Kelderman 8"-10" Air Suspension Lift on 2040-cars

Auto blog

How Ford made its 2015 Ford Mustang safer for toupee wearers [w/video]

Ford is ready to tell the story of its 2015 Mustang Convertible, the can't-miss bits being the easier, quicker and quieter roof operation, a more robust roof build for a coupe-like cabin noise, more trunk space, better visibility and reduced in-cabin buffeting. The top release system has been completely redesigned with a single, center-mounted latch on the windshield frame instead of the dual latches of before. The driver can now release the roof without having to lean over into the passenger space, after which the top goes down fully automatically with the press of a button. Ford doesn't say how long it takes to stow, but it's apparently done in half as much time as before, so figure around 8 seconds.
The roof uses a five-bow structure, with the fabric outer and full inner headliner sandwiching ten millimeters of insulation. Detailing work on the top has eliminated "unsightly folds" in the corners when the roof is up and made it more compact when down; its Z-fold assembly is 6.7 inches lower than before at its highest point when put down. Ford says the new electric drive internals make less noise when in operation, and the fully-finished droptop look is achieved with snap-in caps that flank the rear seating and stow in the trunk when not in use (the outgoing Mustang's top was higher and the front when folded and always looked like it was catching air and creating drag).
The compact roof and newly independent rear suspension setup in back means liberated trunk space, 11.4 cubic feet ready to swallow golf bags and tourist swag. You can read a lot more about it in the press release below, check it out in the short video of running footage and learn about the aerodynamic improvements made to the entire Mustang lineup that decrease drag and increase fuel economy.

Ford's J Mays feels vindicated by Fusion reception

It's hard to think back now, but the same man overseeing the design of the 2013 Ford Fusion also presided over a rather lackluster period in Ford design, highlighted by vehicles like the Five Hundred and Freestyle. With the redesigned Fusion receiving high praise, J Mays tells Automotive News that he feels vindicated from criticisms suggesting he's not a daring enough designer.
When Mays took over as lead of design in 1997, he admits to having quite an ego ("My head would barely fit through the door some days. I've long since gotten over myself") and the workload to match. With the Blue Oval's portfolio full of premium brands like Aston Martin, Jaguar, Land Rover and Volvo at that point, along with the bread-and-butter Ford, Lincoln and Mercury models, Mays certainly had quite the challenge.
It was in the mid-2000s that Mays took over just the premium brands, and took on the new title of Chief Creative Officer. At the time, Mays endured some criticism for looking backwards to retro styling, rather than setting a new standard for American car design - criticism that Mays says he is free from with the all-new Fusion.

Ford talking unibody Ranger replacement

Now here's some welcome news. Car and Driver reports Ford is seriously mulling a replacement for the recently deceased Ranger, but the successor to the compact pickup's throne may not look anything like what we've seen from the nameplate in the past.
While speaking at the 2013 Chicago Auto Show, Doug Scott, marketing manager for Ford Trucks, said there's still a market for a smaller pickup, but that buyers expect to see a larger differentiation between the smaller utility vehicles and their full size counterparts in price, capability and fuel economy.
According to Scott, that means a vehicle with a payload capacity of around 1,000 pounds paired with a towing capacity of 3,000 pounds and "a dramatic reduction in fuel consumption." But the biggest piece of that recipe is the price tag, and Scott says to keep the MSRP far enough away from the already cheap F-150, the answer could come in the form of a unibody design. Scott says target customers in this market don't care whether the truck has a traditional frame or not, so long as it's tough enough to do the job and has the capability they need.