Ford Expedition Limited Sport Utility 4-door on 2040-cars

Auto blog

Ford confirms 1.5-liter EcoBoost four-cylinder engine for 2014 Fusion

Earlier this week, reports were swirling 'round the internet about the 2014 Ford Fusion getting a new 1.5-liter three-cylinder EcoBoost engine. That was... half correct. Ford today confirmed that the 2014 Fusion is, in fact, getting a new 1.5-liter EcoBoost mill, but it has four cylinders, not three.
The new 1.5-liter engine will be the fifth EcoBoost powerplant from Ford Motor Company. Initially to be built at the automaker's Craiova, Romania plant, it will also be offered in the Fusion's twin, the Mondeo, in other markets. This engine will debut at the Shanghai Motor Show next month, and the 1.5-liter is of particular importance in the Chinese market - there is significant tax relief in the People's Republic for vehicles powered by engines with a capacity of 1.5 liters or less.
At a media briefing Thursday, Ford declined to divulge exact power or fuel economy numbers, though Joe Bakaj, vice president of powertrain engineering, told Autoblog that power output should be similar to that of the current 1.6-liter inline-four, and that overall efficiency will be "better than the 1.6." Our earlier report stated that the 1.5-liter four will produce 177 horsepower and 177 pound-feet of torque - losses of 1 hp and 7 lb-ft versus the 1.6-liter engine. Ford states that the 1.5-liter four will feature many of the same technologies used on the company's 1.0-liter EcoBoost inline-three, including an integrated exhaust manifold that recaptures much of the engine's heat.

Ford idling Michigan Assembly Plant to trim Focus, C-Max supply

Ford will be putting the brakes on production at its Michigan Assembly Plant in Wayne, MI, idling production during the weeks of October 28 and December 16. Ford is citing the first drop in US sales in 27 months, a 4.2-percent dip in September, as the impetus for trimming their supplies, according to Automotive News.
Ford's deft management of its supplies has been part of its success over the years, and seeing supplies of Focus and C-Max, the two vehicles built at MAP, rise from 58 and 108 days, respectively, to 71 and 122 days over the span of a month was apparently all that was need to justify the trimming. As AN points out, the rule of thumb for many automakers is to maintain a 60-day supply of vehicles.
"Ford has been focused on keeping their pricing in check. Their operating margin is in double digits. Nobody else is there and they're obviously very proud of that," Alan Baum, an auto analyst with Baum & Associates told AN. Keeping the supply chain operating smoothly and not increasing supplies too much is crucial to that healthy profit margin. After all, a large supply lowers prices ,which, in turn, cuts profit. So while this news might not be great for employees at MAP, who now have an extra two weeks of vacation time, it's far from a sign of problems in Dearborn. Quite the opposite, actually.

Ford recalls 434k vehicles for several unrelated issues

It seems that the hard winter in much of the country has been as rough on some Fords as it has on many people. The Blue Oval is recalling roughly 434,000 vehicles in two separate recalls, and one of them partially caused by the salt used to melt the snow on roads.
The first recall covers 385,750 2001-2004 Escape models in the Midwest, Northeast and Canada because a subframe could rust and eventually fail. This is partially due to the road salt used in those areas, and about 349,000 of the affected vehicles are in the US. To remedy the problem, dealers are installing a reinforcement cross brace on the frame to strengthen them. There has been one crash caused by the failure but no injuries. According to The Detroit News, this is not the first rust-related recall for Ford. It estimates the company has repaired over two million vehicles since 2010 for problems on vehicles related to the iron oxide, including the rear wheel wells of the Freestar minivan.
The second recall covers 48,950 2013-2014 Ford Fusion, Escape, C-MAX and Lincoln MKZ models because welds in their seatbacks don't meet National Highway Traffic Safety Administration standards. The fault affects the front seats, and the sub-standard welds joining the setback to the recliner could increase the chance on injury. There have been no reported injuries or accidents caused by the problem, but there are 42,972 affected vehicles in the US and 4,744 in Canada.