1974 Ford Bronco Sport on 2040-cars

Auto blog

Ford F-150 EcoBoost in NHTSA probe for acceleration issue

According to Automotive News, the National Highway Traffic Safety Administration is launching a probe into 400,000 Ford F-150 models over possible acceleration problems. According to the article, NHTSA has received 95 reports "alleging incidents of reduced engine power during hard accelerations" on 2011 to 2013 F-150 models equipped with the company's 3.5-liter EcoBoost V6 engine.
Automotive News reports that Ford has issued three technical service bulletins "related to intermittent stumble/misfire on acceleration from highway cruise in humid or damp conditions," according to the government agency's documents. About one third of the 95 reports NHTSA has received cited humid or rainy conditions when these problems allegedly occurred.
These technical service bulletins have allowed dealers to address a "condition related to moisture accumulation in the charge air cooler during extended highway cruising at constant throttle in humid or damp conditions," AN reports, citing NHTSA documents. Furthermore, the TSB outlines details for "reprogramming the powertrain control module with the latest calibration and installing a new CAC and air deflector plate."

This is what a 3D-printed liquid metal Ford Torino looks like

Artist Ioan Florea has encapsulated a 1971 Ford Torino with 3-D-printed liquid metal transferred onto the car using technology that he developed, and the result is a stunningly shiny, seamless design.
"The surface has the highest coefficient of reflectivity never achieved before," Florea told us in an e-mail, using "nano-materials and nano-pigments that create an internal three-dimensional structure and dictate the polymer how to behave." Sure... We'll leave it to him to make any more 3-D-printed liquid metal-transferred art pieces.
Florea grew up in Romania, and the motivation behind picking the old Ford as his canvas came from his childhood memories of what an American car is - "big and wide and fascinating," he says - and the European name of the car itself, which it shares with an Italian city.

How Ford made its 2015 Ford Mustang safer for toupee wearers [w/video]

Ford is ready to tell the story of its 2015 Mustang Convertible, the can't-miss bits being the easier, quicker and quieter roof operation, a more robust roof build for a coupe-like cabin noise, more trunk space, better visibility and reduced in-cabin buffeting. The top release system has been completely redesigned with a single, center-mounted latch on the windshield frame instead of the dual latches of before. The driver can now release the roof without having to lean over into the passenger space, after which the top goes down fully automatically with the press of a button. Ford doesn't say how long it takes to stow, but it's apparently done in half as much time as before, so figure around 8 seconds.
The roof uses a five-bow structure, with the fabric outer and full inner headliner sandwiching ten millimeters of insulation. Detailing work on the top has eliminated "unsightly folds" in the corners when the roof is up and made it more compact when down; its Z-fold assembly is 6.7 inches lower than before at its highest point when put down. Ford says the new electric drive internals make less noise when in operation, and the fully-finished droptop look is achieved with snap-in caps that flank the rear seating and stow in the trunk when not in use (the outgoing Mustang's top was higher and the front when folded and always looked like it was catching air and creating drag).
The compact roof and newly independent rear suspension setup in back means liberated trunk space, 11.4 cubic feet ready to swallow golf bags and tourist swag. You can read a lot more about it in the press release below, check it out in the short video of running footage and learn about the aerodynamic improvements made to the entire Mustang lineup that decrease drag and increase fuel economy.