1974 Ford Bronco-hardtop-cosmetic Restoration-runs And Drives Great!!!! on 2040-cars

Auto blog

How Ford made its 2015 Ford Mustang safer for toupee wearers [w/video]

Ford is ready to tell the story of its 2015 Mustang Convertible, the can't-miss bits being the easier, quicker and quieter roof operation, a more robust roof build for a coupe-like cabin noise, more trunk space, better visibility and reduced in-cabin buffeting. The top release system has been completely redesigned with a single, center-mounted latch on the windshield frame instead of the dual latches of before. The driver can now release the roof without having to lean over into the passenger space, after which the top goes down fully automatically with the press of a button. Ford doesn't say how long it takes to stow, but it's apparently done in half as much time as before, so figure around 8 seconds.
The roof uses a five-bow structure, with the fabric outer and full inner headliner sandwiching ten millimeters of insulation. Detailing work on the top has eliminated "unsightly folds" in the corners when the roof is up and made it more compact when down; its Z-fold assembly is 6.7 inches lower than before at its highest point when put down. Ford says the new electric drive internals make less noise when in operation, and the fully-finished droptop look is achieved with snap-in caps that flank the rear seating and stow in the trunk when not in use (the outgoing Mustang's top was higher and the front when folded and always looked like it was catching air and creating drag).
The compact roof and newly independent rear suspension setup in back means liberated trunk space, 11.4 cubic feet ready to swallow golf bags and tourist swag. You can read a lot more about it in the press release below, check it out in the short video of running footage and learn about the aerodynamic improvements made to the entire Mustang lineup that decrease drag and increase fuel economy.

Motor Trend pits Camaro 1LE vs Mustang with Performance Pack, surprises ensue

With the 2015 Ford Mustang firmly on the scene, the inevitable comparisons with its arch rival, the 2015 Chevrolet Camaro are just starting to trickle out. Over the next several months, you're likely to be inundated by every outlet's muscle car comparison, whether it be the turbocharged Ford against the V6 Chevy, a V8-powered convertible comparo or what we have here, a competition between each vehicle's performance upgrade.
Motor Trend has pitted the Camaro SS 1LE against a Mustang with the GT Performance Pack for a comprehensive series of comparisons on the test stage, street and finally, at Willow Springs with ace Randy Pobst behind the wheel. As per usual, we aren't about to spoil this one for you.
So, hit the play button, have a look and then let us know what you think in Comments.

Ford reveals new rapid prototyping and low-volume production techniques [w/video]

It's called "F3T," and that stands for Ford Free-form Fabrication Technology. The process that The Blue Oval has developed means being able to sidestep the weeks-long process of tool-and-die making when engineers want to construct a new part, allowing them to fabricate a three-dimensional part from a two-dimensional sheet of metal in just hours.
While F3T is being developed it is limited to "low-volume prototyping or even low-volume niche vehicles," but the next step is to evaluate it for use in Ford's global manufacturing facilities. You can find out more about it in the video and the press release below.