2011 Ram 3500 4wd Reg Cab 143 on 2040-cars

Auto blog

Chrysler recalling 2009-2010 Ram 1500, Dodge Dakota pickups over axle pinion nut

Chrysler is issuing a recall for the 2009 and 2010 Ram 1500 and Dodge Dakota pickup trucks due to improper installation of the rear axle pinion nut. According to the National Highway Traffic Safety Administration, a total of 44,300 trucks are affected by the recall, and there have been 12 confirmed incidents including one crash.
The issue on both trucks is that the pinion nut is loosening on some trucks due to a lack of thread adhesive, and it is causing the rear axle to lock up resulting in loss of vehicle control. NHTSA's recall notice says that eight incidents occurred at speeds over 35 miles per hour and most also exhibited driveshaft failures as well since the loss of the pinion nut would cause the gear to separate from the driveshaft. In one complaint, the driveshaft separated from the rear axle and punctured the gas tank.
Chrysler will begin sending out recall notices to affected owners in November, but scroll down to see the official NHTSA notice.

Chrysler investing $20M in Toledo plant to support 9-speed auto production

In 2011, Chrysler announced a $72-million investment in its Toledo Machining Plant to modernize production of the eight- and nine-speed torque-converters for automatic transmissions made there. That upgrade work won't be finished until Q3 of this year, but Chrysler has already announced a further $19.6-million investment to increase production capacity for the nine-speeders.
The extra units will be necessary because the nine-speed transmission they'll be mated to is going into three popular models: it will debut on the 2014 Jeep Cherokee, then go into the Chrysler 200 and Dodge Dart. The company predicted that this year alone it would sell 200,000 units equipped with the nine-speed tranny, and it is spending some $374 million in addition to the investment in Toledo to upgrade production capacity for it.
The work attached to this new investment won't begin until Q3 of 2014, and it will be finished by the end of that year. There's a press release below with all the details.

2013 Dodge Challenger R/T hits the Redline

Dodge has added a bit of spice to its Hemi-powered Challenger for 2013, offering up this new Redline package that makes its official debut at the Chicago Auto Show. The R/T Redline builds on the Rallye Redline kit that was created for the V6 Challenger, and we like how these subtle changes add to the muscle coupe's already classic styling.
In addition to the black chrome 20-inch wheels with red accents, the R/T Redline adds subtle graphics along the beltline. Inside, cars equipped with the six-speed manual transmission get a performance tuned exhaust that allows the engine to send a full 375 horsepower and 410 pound-feet of torque to the rear wheels. (Redline Challengers with the five-speed automatic produce 372 hp and 400 lb-ft.)
The Redline package retails for $1,995 and can be had on both Challenger R/T and R/T Plus models. Scroll down for the full press blast.