Dodge Ram 2500 Crew Cab Slt Cummins Diesel Tow Package 55k Miles on 2040-cars

Auto blog

Chrysler recalling 2009-2010 Ram 1500, Dodge Dakota pickups over axle pinion nut

Chrysler is issuing a recall for the 2009 and 2010 Ram 1500 and Dodge Dakota pickup trucks due to improper installation of the rear axle pinion nut. According to the National Highway Traffic Safety Administration, a total of 44,300 trucks are affected by the recall, and there have been 12 confirmed incidents including one crash.
The issue on both trucks is that the pinion nut is loosening on some trucks due to a lack of thread adhesive, and it is causing the rear axle to lock up resulting in loss of vehicle control. NHTSA's recall notice says that eight incidents occurred at speeds over 35 miles per hour and most also exhibited driveshaft failures as well since the loss of the pinion nut would cause the gear to separate from the driveshaft. In one complaint, the driveshaft separated from the rear axle and punctured the gas tank.
Chrysler will begin sending out recall notices to affected owners in November, but scroll down to see the official NHTSA notice.

Dodge idles Viper production again at Conner Avenue

You've got to hand it to Dodge for having the gumption to put the original Viper into production in the first place. It was, after all, much more of an emotional decision than a practical one, and a move which saw the first production V10 engine placed in a road car - long before the advent of the Lamborghini Gallardo, Audi R8, Porsche Carrera GT or Lexus LFA, not to mention the other Ford, BMW and Volkswagen Group models that used such engines.
It's now been 22 years since the first Viper entered production and the Viper still rolls on several generations later, but we're sad to say that courageous decision has not always been met with overwhelming sales success. In fact parent Chrysler was forced to idle the Conner Avenue plant where the Viper is made back in April due to slow sales. And while production resumed again as planned on June 23, it apparently didn't do the trick.
As a result, Chrysler corporate communications chief Shawn Morgan revealed to Autoblog that the assembly line has been shut down again for another two weeks. The line was up and running for nearly two full work weeks from June 23 until the holiday weekend that started on Thursday, July 3. But instead of coming back online today as planned, it's been idled again for the weeks of July 7 and 14. That means it will be July 21, at the earliest, before the serpentine supercars start slithering down the assembly line at Conner Avenue again. Once it does, however, production is set to resume at the same pace it was before the shutdown.

Dodge CEO and Gas Monkey Garage dissect the 10-second Challenger Hellcat

So far, whenever we've seen the 2015 Dodge Challenger SRT with its 707-horsepower, supercharged Hellcat V8, the muscle car has been smoking its tires. Dodge is finally proving that the SRT can do more than ruin perfectly good sets of rubber, though. In it's latest video, company CEO Tim Kuniskis hands the Hellcat off to the guys from Gas Monkey Garage to show how quickly the automaker's most powerful model can make it down the drag strip.
Of course, the only fitting contender to race against Dodge's latest top muscle car is its grandpa - a Hemi-powered 1971 Challenger, in this case. Before getting to the main event, the hosts also show off some of the SRT's unique features like the blanks in the grille that feed the intercoolers. We'll go ahead and spoil that the Hellcat makes its pass in the 10-second range, and the video admits the tires on the production version would take just a touch longer to cover the quarter-mile. However, you have to watch film to see just how quick it actually goes. Scroll down to see a classic example of American muscle drag racing against its modern legacy.