2012 Dodge Ram 2500 4x4 Laramie Mega Diesel Nav 16k Mi Texas Direct Auto on 2040-cars

Auto blog

NHTSA investigating 110,000 Ram 2500s and 3500s, one death alleged

The National Highway Traffic Safety Administration has launched an investigation focusing on 110,000 Dodge Ram 2500 and 3500 pickups from model years 2004 to 2006. One death has already been reported, according to NHTSA, due to a potential fault with the clutch interlocks on manual-transmission versions of the heavy duty pickup.
According to the report, these trucks can be started without depressing the clutch. There have been three reports so far, and as we mentioned above, one very sad incident seems to have resulted in the death of a child.
"One complaint involved an incident that occurred when a child was able to enter the vehicle and start the ignition without depressing the clutch. The vehicle then moved forward striking another child resulting in a fatality," NHTSA said in the investigation bulletin, which you can view below.

Chrysler recalling 2009-2010 Ram 1500, Dodge Dakota pickups over axle pinion nut

Chrysler is issuing a recall for the 2009 and 2010 Ram 1500 and Dodge Dakota pickup trucks due to improper installation of the rear axle pinion nut. According to the National Highway Traffic Safety Administration, a total of 44,300 trucks are affected by the recall, and there have been 12 confirmed incidents including one crash.
The issue on both trucks is that the pinion nut is loosening on some trucks due to a lack of thread adhesive, and it is causing the rear axle to lock up resulting in loss of vehicle control. NHTSA's recall notice says that eight incidents occurred at speeds over 35 miles per hour and most also exhibited driveshaft failures as well since the loss of the pinion nut would cause the gear to separate from the driveshaft. In one complaint, the driveshaft separated from the rear axle and punctured the gas tank.
Chrysler will begin sending out recall notices to affected owners in November, but scroll down to see the official NHTSA notice.

Mopar maneuvers into SEMA with a multitude of modified models

As the aftermarket and performance arm of Fiat Chrysler Automobiles, Mopar has a duty to extract everything from the company's models that it can, and there's no better place to show all of its work off than the annual SEMA Show.
Dodge really gets in on the act this year with several customs to show off different parts of the brand's performance heritage. Perhaps the most interesting among them is the track-prepped Viper ACR Concept (pictured above). It wears a custom body kit to produce even more downforce, thanks in no small part to a monstrous wing at the back. To shed weight, most of the interior is stripped out, as well. Next up, the Challenger T/A Concept takes inspiration from '70s Trans-Am racing in a livery of Sublime Green and matte black paint. The center scoop in the hood keeps the 6.4-liter V8 fed with cool air, and the special's 20-by-9.5-inch matte black wheels keep it planted in the corners.
Also getting the once-over from Mopar is the Charger R/T. It wears the division's body kit, and under the hood, a cold-air intake keeps the 5.7-liter V8 breathing. The suspension is retooled to hold the road better with a coil-over kit, upgraded sway bars and strut tower braces for the front and rear. The company is also showing off a snazzy blue Charger with a mean look. The final Dodge getting work from Mopar is the Dart R/T Concept with bright, O-So-Orange paint and a matte black hood with a scoop hooked directly to the air intake. The performance-oriented design is finished off with a coil-over suspension and big brake kit, as well.