2008 Dodge Ram 2500 St Crew Cab Pickup 4-door 5.7l on 2040-cars

Auto blog

Dodge Durango could get eTorque mild hybrid system in 2020

The 2020 Dodge Durango appears slated to get a mild-hybrid powertrain option. That's the word from moparinsiders.com, which unearthed the news from documents relating to contract negotiation between the FCA and the UAW. Although the documents give no further details, it's a pretty safe bet that we're talking about Chrysler's eTorque mild-hybrid system, which was introduced on the Ram 1500 pickup and has since been extended to the Jeep Wrangler. Currently, the Wrangler offers the eTorque system on the 2.0-liter inline-four and the 3.6-liter Pentastar V6, both on the Sahara model only, while the Ram 1500 makes the mild-hybrid system standard with the 3.6-liter V6 and an option with the 5.7-liter Hemi V8. The V6 eTorque powertrain makes 305 horsepower and 269 pound-feet of torque (Ram) or 285 horsepower and 260 pound-feet (Wrangler). The Wrangler's four-cylinder eTorque is good for 270 horses and 295 lb-ft. The V8 version in the Ram is good for 395 horsepower and 410 lb-ft of torque. In all cases, the eTorque system does not increase peak output over the standard version of the gasoline engine. The mild-hybrid system does provide a minor fuel-economy boost. In the Wrangler, the 3.6-liter with eTorque has EPA city estimates that are 1 mpg better than without the system. On the Ram's V8, eTorque adds 2 mpg city and 1 mpg highway. (The 2.0-liter sees no improvement in its EPA ratings.) It's not known whether the Durango will add eTorque to its V6, or V8, or both. Either engine could do with a fuel-economy boost, as the V6 is EPA rated at 19/26 mpg city/highway (RWD) and 18/25 mpg (AWD), while the V8 version has estimates of 14/22 mpg. Related Video:

Junkyard Gem: 1987 Dodge Ram 50 with V8 swap

Chrysler did very well selling Mitsubishi Forte pickups with Plymouth and Dodge badging in the United States, even after Mitsubishi began moving the same trucks out of their own American dealerships in 1982. The 1987 Ram 50 2WD short bed weighed in at just over 2,500 pounds, so it was reasonably perky with its 2.0-liter G63B four-banger making 90 horsepower… but there's no replacement for displacement! At some point along the line, a Chrysler small-block V8 engine found its way into the engine compartment of this truck, now residing in a car graveyard in Sparks, Nevada. This was the cheapest new Dodge-branded pickup Americans could buy as a 1987 model, though it had to compete with its near-identical Mitsubishi Mighty Max twin for sales. The 1980s were great times for little pickups in the United States, but a desire for bigger cabs and more creature comforts doomed them by the dawn of the following decade. The most interesting thing about this engine swap is that it didn't involve a Chevrolet or Ford small-block V8. Both the Chevy small-block and Ford Windsor V8s are a few inches narrower than the Chrysler LA-series V8, which makes them easier to stuff into a small vehicle. It appears that engine length was the critical dimension in this case, since the Mopar seems to have had enough side-to-side clearance to avoid any slicing of Mitsubishi steel to make it fit. My guess is that whoever did the swap happened to have the engine handy and that's why it's here. Keeping it all Dodge might have been a factor in the decision as well, though the truck's Mitsubishi ancestry makes that unlikely. It was over 100°F out when I found this truck, so I wasn't motivated to check block casting numbers to determine exactly which LA engine we're dealing with here. The easiest LAs to get cheap for the last four or so decades have been the 318 (5.1-liter) and the 360 (5.8-liter), so one of those two is the most likely candidate here. Power levels for these engines got pretty dismal during the Malaise Era, but anyone with the wrenching skills to do this swap would have applied some basic power-enhancing wizardry before the engine went in. We can see there's an Edelbrock Performer intake manifold, and you might as well stab in a better camshaft if you're upgrading the intake. How much power? With a four-barrel carburetor on a dual-plane intake plus a meaner cam, 300 to 350 horsepower is easily achieved with one of these engines, even with stock exhaust manifolds.

Sunday Drive: The future looks bright, and the present ain't bad, either

A look at the week that just passed proves that Autoblog readers love looking into the future. Spy photos of the next Porsche 911 and a mysterious Dodge Demon prototype led the way last week as some of our most popular stories. A teaser from Subaru has our appetites whetted for the next WRX, and we're intrigued by the value proposition offered by the rear-wheel-drive Kia Stinger. Long-distance motorcycle tourers went gaga over leaked images of the next Honda Gold Wing. Such intense interest comes as no surprise considering that it's the standard by which all its competitors are judged, and it looks to be getting some serious new technology in its next iteration. And finally, we can't help tooting our own horn a bit. Autoblog just launched a brand-new Car Finder tool, which, after getting a few data points to work with, offers up a perfect list of vehicles for new-car buyers. As always, tune in to Autoblog next week for a front-row seat to all the happenings worth following in the automotive industry. 2019 Porsche 911 to get digital interior — only the tach will be analog Spy Shots: What the devil is Dodge up to with this narrow-body Challenger Demon? Subaru previews Viziv Performance Concept and 2 tuned STIs for Tokyo Leaked 2018 Honda Gold Wing shows off new suspension, hints at DCT 2018 Kia Stinger will start at $32,795 Dodge Honda Kia Porsche Subaru Coupe Hatchback Motorcycle Future Vehicles Luxury Performance Sedan recap sunday drive