2013 Dodge Ram 1500 4wd 4x4 Hemi Express New Pickup Truck on 2040-cars

Auto blog

2015 Dodge Challenger looks fresh, still plenty retro [w/video]

It was the Ford Mustang that kicked off the retro-styled muscle car renaissance back in 2005, but it was the Dodge Challenger that served as the movement's poster child, with its unabashedly retro looks. Over the years, though, as the Mustang and the Chevrolet Camaro were freshened and upgraded, the look of the big Dodge has remained largely consistent since its 2008 debut. For 2015, the Challenger has received a big freshening, boasting strongly revised front and rear ends and (finally, finally, finally) a redesigned interior.
Let's talk about that new cabin first. It's basically been plucked directly from the redesigned Charger, and boasts the same seven-inch IP display. The center stack's miserable, last-gen display has been replaced by an expansive, 8.4-inch UConnect system. Material quality should see a solid boost with the new cabin, as well.
The exterior, meanwhile, sees a revised front fascia with LED halo lights, as well as new grille inserts. A functional shaker hood scoop is a must-have extra on the V8 models, while the back of the car is highlighted by a new set of LED taillights that don't use the "Racetrack" design of Dodge's other models.

Chrysler recalling 2009-2010 Ram 1500, Dodge Dakota pickups over axle pinion nut

Chrysler is issuing a recall for the 2009 and 2010 Ram 1500 and Dodge Dakota pickup trucks due to improper installation of the rear axle pinion nut. According to the National Highway Traffic Safety Administration, a total of 44,300 trucks are affected by the recall, and there have been 12 confirmed incidents including one crash.
The issue on both trucks is that the pinion nut is loosening on some trucks due to a lack of thread adhesive, and it is causing the rear axle to lock up resulting in loss of vehicle control. NHTSA's recall notice says that eight incidents occurred at speeds over 35 miles per hour and most also exhibited driveshaft failures as well since the loss of the pinion nut would cause the gear to separate from the driveshaft. In one complaint, the driveshaft separated from the rear axle and punctured the gas tank.
Chrysler will begin sending out recall notices to affected owners in November, but scroll down to see the official NHTSA notice.

NHTSA investigating power modules on Chrysler Group SUVs and minivans

The Center for Auto Safety is officially petitioning the National Highway Traffic Safety Administration to begin scrutinizing alleged problems with the totally integrated power module (TIPM) on about 24 Chrysler Group SUVs and minivans. The advocacy group claims that the part's failure can cause affected vehicles to stall or not start at all. NHTSA is still looking into the accusations and deciding whether a full investigation is actually warranted.
The CAS petition claims at least 70 TIPM failures, but according to NHTSA, six of the complaints are for models that don't have the modules. In 34 of the reported cases, the vehicles refused to start, and in 17 of them the engine stalled. There were also two allegations of smoke and one of a fire. However, none of these affected airbag deployment or resulted in a crash.
This petition isn't the first TIPM-related problem for Chrysler Group. A recent report in the New York Times alleged that it found 240 complaints potentially related to the issue on NHTSA's website alone. In September, the automaker also recalled 230,760 examples worldwide (188,723 in the US) of the 2011 Jeep Grand Cherokee and Dodge Durango replace the fuel pump relay circuit inside of the TIPM-7 with one external to the unit. The original part could allegedly cause the models to stall without warning. Even earlier, the company also recalled about 80,000 examples of the Jeep Wrangler and Dodge Nitro in 2007 to have the module reprogrammed.