Vintage 1961 Dodge 300...1 Ton Truck With Hoist...runs...construction...restore on 2040-cars

Auto blog

Dodge Charger Hellcat hitting 60 in 2.9 seconds on drag radials?

The Dodge boys and their cousins from SRT have shoehorned the same 707-horsepower, 6.2-liter supercharged V8 into both the Dodge Challenger and Charger. The former being a two-door, it's lighter than the latter four-door sedan. So it would stand to reason that the Dodge Challenger SRT Hellcat would be the quicker of the two, right?
Only that's not necessarily proving to be the case. On stock rubber, yes, the coupe beats the sedan: Dodge quotes a 0-60 time of 3.7 seconds for the Charger SRT Hellcat and 3.5 for the Challenger. Same gap across the quarter-mile: 11 seconds flat for the Charger versus 10.8 seconds for the Challenger. But according to recent reports, the story changes when you put both on drag radials.
While visiting Chrysler HQ in Auburn Hills, MI, TorqueNews.com caught wind of performance figures for the Charger Hellcat on drag tires: 0-60 in a mind-blowing 2.9 seconds and a quarter-mile in just 10.7. The latter figure just barely pips the Hellcat-powered Challenger's NHRA-certified figure of 10.8, making the Charger not only the fastest sedan on the market, but also the fastest muscle car. What isn't immediately clear, however, is whether the drag radials in question have any tread on them and are street-legal, or if they're pure slicks confined to a closed strip.

Chrysler recalls 350k vehicles over ignition switches

Chrysler has announced a recall covering 349,442 vehicles due to ignition switches that can either become stuck or move without warning. All of the affected vehicles are from the 2008 model year, and were built before May 12, 2008.
The automaker has learned that ignition keys on some vehicles "may not fully return to the 'ON' position after rotation to the 'START' position during engine-startup," the company said in a statement. Additionally, "an ignition key may not fully return to the 'ON' position after rotation to the 'START' position and may inadvertently move through the 'ON' position to 'ACCESSORY' or 'OFF.'"
Chrysler says it is unaware of any related injuries, and notes that while reduced braking, engine or steering power is possible in such instances, the airbags are not affected. The later stands in contrast to General Motors' recent rash of high-profile recalls, and it's an important distinction that Chrysler (understandably) felt necessary to call out in bold print in its press release.

Chrysler recalling 2009-2010 Ram 1500, Dodge Dakota pickups over axle pinion nut

Chrysler is issuing a recall for the 2009 and 2010 Ram 1500 and Dodge Dakota pickup trucks due to improper installation of the rear axle pinion nut. According to the National Highway Traffic Safety Administration, a total of 44,300 trucks are affected by the recall, and there have been 12 confirmed incidents including one crash.
The issue on both trucks is that the pinion nut is loosening on some trucks due to a lack of thread adhesive, and it is causing the rear axle to lock up resulting in loss of vehicle control. NHTSA's recall notice says that eight incidents occurred at speeds over 35 miles per hour and most also exhibited driveshaft failures as well since the loss of the pinion nut would cause the gear to separate from the driveshaft. In one complaint, the driveshaft separated from the rear axle and punctured the gas tank.
Chrysler will begin sending out recall notices to affected owners in November, but scroll down to see the official NHTSA notice.