No Reserve 2008 Dodge Grand Caravan Loaded Sxt 7 Passenger on 2040-cars

Auto blog

Chrysler recalling 2009-2010 Ram 1500, Dodge Dakota pickups over axle pinion nut

Chrysler is issuing a recall for the 2009 and 2010 Ram 1500 and Dodge Dakota pickup trucks due to improper installation of the rear axle pinion nut. According to the National Highway Traffic Safety Administration, a total of 44,300 trucks are affected by the recall, and there have been 12 confirmed incidents including one crash.
The issue on both trucks is that the pinion nut is loosening on some trucks due to a lack of thread adhesive, and it is causing the rear axle to lock up resulting in loss of vehicle control. NHTSA's recall notice says that eight incidents occurred at speeds over 35 miles per hour and most also exhibited driveshaft failures as well since the loss of the pinion nut would cause the gear to separate from the driveshaft. In one complaint, the driveshaft separated from the rear axle and punctured the gas tank.
Chrysler will begin sending out recall notices to affected owners in November, but scroll down to see the official NHTSA notice.

Dodge Dart Mopar '13 special edition recalled over airbag woes

Dodge is only building 500 examples of the black-and-blue Mopar '13 Dart, but the majority of them are now being recalled. Part of the Mopar upgrade included replacing the stock seat skins in the Dart with black and blue Katzkin leather, but the seat-mounted side airbags were reinstalled improperly during the upfitting process, which could affect the performance of the front seat side airbags.
According to the official National Highway Traffic Safety Administration bulletin, a total of 374 Mopar '13 cars are being recalled due to side airbags that might not deploy in a side-impact collision. There have been no reports of the airbags not going off, but Chrysler will still need to reinstall the bags to ensure proper deployment. The recall notice is posted below, which gives information for Mopar '13 owners to contact Chrysler and NHTSA.

Chrysler to accelerate production of 2013 Ram and V6 engines

Chrysler is adding a third shift at its Warren Truck plant to meet demand for the new 2013 Ram pickup. And with tight supplies of its Pentastar V6, the company is also boosting output at its Mack Engine plant.
The expansions will add 1,250 jobs and are part of a $238 million investment by Chrysler in the Detroit area. Warren's third shift will begin work sometime in the spring, a Chrysler rep told Automotive News. Mack's increased Pentastar production a could include both 3.6 and 3.2-liter engines.
The company says it also plans to invest $40 million in its Trenton Engine plant to allow for production of a 3.2-liter V6 as well as the Tigershark inline-four for the upcoming Jeep Liberty replacement.