1972 Chevrolet Chevelle Malibu 2 Dr Hardtop Project on 2040-cars
Dickens, Iowa, United States
Vehicle Title:Clear
Make: Chevrolet
Drive Type: rwd
Model: Chevelle
Mileage: 99,999
Trim: malibu
72 Chevelle project. Some rust as shown in pics. No engine or trans,10 bolt rear. Was 350 auto. Comes with a pair of buckets and AC parts. Clean title, shipping availible. Check out extra pics at this link; https://skydrive.live.com/redir?resid=FB380EB8B92DED01!1065&authkey=!AHIHIMCz_fblLUc
Chevrolet Chevelle for Sale
Auto Services in Iowa
Truck Equipment Inc ★★★★★
Tint Masters ★★★★★
Thorpe`s Body Shop ★★★★★
Shaffer`s Auto Body Co. Inc ★★★★★
Scotty`s Body Shop ★★★★★
Sargent`s Garage ★★★★★
Auto blog
Chevrolet planning low-cost Corvette under Stingray?
Wed, 27 Feb 2013If you're burnt out on musings about the Chevrolet Corvette, you'll want to go ahead and skip this post. Motor Trend reports General Motors is hard at work on a low-cost version of the seventh-generation sports car for 2015. Rumored to be called the Corvette Coupe, the car will forgo the Stingray and skip the 450-horsepower 6.2-liter V8 engine in favor of a 5.3-liter V8 with under 400 ponies. If you're keeping track, that's a shade of the same engine found behind the headlights of the 2014 Chevrolet Silverado and GMC Sierra.
The report also suggests the Coupe will receive a number of aesthetic tweaks to separate it from the Stingray, including different front and rear fascias as well as new front fenders and a rear diffuser. Motor Trend says the point of all this is to cut the car's price tag, which means we may see a Corvette on showroom floors for less than $50,000 if this car comes to fruition.
C7 Corvette turbo with 1,000 horsepower promised from Hennessey
Mon, 25 Feb 2013If you can't wait for the next-generation Chevrolet Corvette ZR1, Hennessey says they will have you covered. The Texas-based company has announced it will offer a spate of upgrades for the 2014 Corvette ranging from a range of bolt-on options all the way up to a 1,000-horsepower, twin-turbo system. Buyers can start with a cold air intake, cat-back exhaust or stainless steel long-tube headers, but Hennessey says it will also offer up three stages of forced induction mayhem should those bits and baubles not provide enough thrust.
Those choices start with a supercharger system good for up to 700 hp, though Hennessey will gladly ditch the blower in favor of two turbos. Doing so will spin the crank to the tune of 800 horsepower all the way up to a certifiably ludicrous 1,000 ponies. There's no word on how much these tricks will cost you - or when they will be available, as we're guessing they haven't gotten their hands on the car yet - but you can head over to the Hennessey site to drop them a line if you're curious.
More Corvette Stingray Factoids: Vanishing panel gaps and 26-mpg LT1
Thu, 28 Feb 2013During January's Detroit Auto Show, we managed a longer than expected wandering tag-team interview with C7 Corvette chief engineering exec Tadge Juechter (pictured above), and LT1 engine boss Jordan Lee (pictured below). They are, quite honestly, two of the very nicest bigshot lads to ever walk the engineering corridors of an American manufacturer. Both are enthralled by what they're doing for a day job. So are we.
We've followed the pre-sale anticipation for the Chevrolet C7 Corvette Stingray like an Oreck vacuum yanking every speck of dirt from a well-trampled carpet. Everything is reportable and contains a grain of further knowledge about this dramatically important and cheered-for car, as it continues to be pressured into representing all that is superior about the American dream. The Corvette wears one heavy cloak.
So, most of what was talked about has been expertly reported already right here on Autoblog. But, looking through our notes again, both Jeuchter and Lee added facts to the buzzing mix.